Greetings, everyone!
I'm using MSP430FR6989 and when trying to put a breakpoint in my code I get the error message:
"EEM module not accessible while running in Ultra Low Power Debug Mode - Deactivate Ultra
Low Power Debug mode to enable this feature"
I was able to fix this by following this thread:
e2e.ti.com/.../464151
and by unchecking
"Project properties -> Debug -> MSP43x Options -> Low power mode settings -> Enable Ultra Low Power debug / LPMx.5 debug"
BUT I DONT UNDERSTAND - WHY?
First of all I don't use low power modes in my code. I have turned off all optimizations.
Second - let's assume that I enter this low power mode (LPMx.5) somehow due to some
unknown optimizations. Then why do I have to UNCHECK the "Enable Ultra Low Power debug /
LPMx.5 debug" ? What does it do?
Regards,
L. B.