CCS/MSP430F6435: How to debugg and program this micro-controller from code composer studio.

Dhanraj

Part Number: MSP430F6435

Tool/software: Code Composer Studio

Hello,

I m using MSP430F6435 in my project.I want to program and debug it using code composer studio via JTAG ,With the help of MSP-EXP430FR4133 Launch Pad.

someone tell me the hardware connection from target device to the evaluation board

and debugging procedure in ccs.

Regards

over 7 years ago

0 Dennis Eichmann over 7 years ago

Guru 74080 points

Hi Dhanraj!

Simply disconnect the RST and TEST jumpers between the emulation side and the processor side on the LaunchPad and use some wires from RST and TEST from the header on the emulation side to your processor. Then also connect GND and if your target has no own power, also connect the 3.3V supply pin. If your target has it's own power, make sure it is around 3.3V as well - otherwise your logic levels might not match and excessive current can flow through RST and TEST which might damage the internal protection diodes.

Dennis

0 Dhanraj over 7 years ago in reply to Dennis Eichmann

Guru 14805 points

I have done correct connection but still getting the error-
"MSP430: Error connecting to the target: Unknown device"

Regards
DC

0 Dennis Eichmann over 7 years ago in reply to Dhanraj

Guru 74080 points

Could you upload a photo whre one can see your complete setup?

0 Dhanraj over 7 years ago in reply to Dennis Eichmann

Guru 14805 points

thanks , issue resolved . there was hardware issue on target board.

**Attention** This is a public forum

MSP low-power microcontrollers

MSP low-power microcontroller forum

CCS/MSP430F6435: How to debugg and program this micro-controller from code composer studio.