Texas Instruments (TI) Motor drivers support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search motor drivers IC content or ask technical support questions on everything from brushless DC (BLDC) and brushed DC (BDC) motor drivers to stepper motor and other drivers for precise motor control. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Part Number: DRV2700 When using the DRV2700 in it’s flyback configuration there are multiples things to consider when trying to approximate what your output will be. Here is the flyback configuration circuit found in the DRV2700 Datasheet:
First…
Part Number: DRV2625 Other Parts Discussed in Thread: DRV2624 , DRV-ACC16-EVM Achieving the right recording set-up is crucial in understanding the haptic effects produced by our haptic driver chip
Here are a few things to keep in mind when putting together…
Part Number: DRV2700 DRV2700 Frequency Response
Being able to understand how the relationship between bandwidth, load capacitance, gain, and current limit is critical for getting the output you would expect when using the DRV2700
Looking at these…
With regards to longevity of TI motor drivers, please see the below resources for more information:
TI Quality site: http://www.ti.com/support-quality/quality-policies-procedures/product-change-notification.html (please refer to the section titled …
Other Parts Discussed in Thread: DRV8846 , DRV8880 What happens when you connect a stepper motor to the driver and power up the system? Ideally, the stepper motor should begin turning, but what if the motor does not move? How do you find the problem?…
Other Parts Discussed in Thread: DRV10970 , DRV10964 , DRV10974 , DRV10975 , DRV10983 , DRV10983-Q1 , DRV10987 E2E FAQ - Quick selection Guide for DRV10x devices
TI’s DRV10x family of motor drivers includes gate drivers, integrated MOSFET, and integrated…
Part Number: DRV2624 Other Parts Discussed in Thread: DRV2604 , , DRV2603 What is Real Time Playback (RTP) Mode?
- RTP is based on the processor communicating the haptic waveform wanting to be played through I 2 C communication. Digital amplitude values…
Part Number: DRV2624 Hi!
One of the most common questions when using haptics drivers is related to the different modes and configurations that our devices support. In general, all our haptics drivers solutions support open and closed loop modes. Depending…
Part Number: DRV2624
Hi,
When selecting our haptics drivers products, it is important to compare which features are supported by the devices and which of them are required for the end application. Here there are some useful questions that may help…
Part Number: DRV2624 Other Parts Discussed in Thread: DRV2625 What is the purpose of auto-calibration?
- The auto-calibration routine is available for the purpose to drive the attached actuator into steady state based on the input parameters for rated…