Texas Instruments (TI) Power management support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search power management IC content or ask technical support questions on everything from linear and DC/DC switching regulators to battery management and LED drivers. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions

  • [FAQ] TPS65916: Can I run the PMIC without OTP or modify the OTP?

    Part Number: TPS65916 Can I change the initial OTP settings?

  • [FAQ] TPS65916: What is OTP?

    Part Number: TPS65916 What is OTP? Where can I find OTP settings?

  • [FAQ] TPS659037: Do I need to use a crystal?

    Part Number: TPS659037 Is a crystal required with this PMIC?

  • [FAQ] TPS659037: Which I2C bus should be used?

    Part Number: TPS659037 Should I use I2C1 or I2C2?

  • [FAQ] TPS659037: How should VCC1 and VIO inputs be sequenced?

    Part Number: TPS659037 How should these input supplies be turned on?

  • [FAQ] TPS659037: Should I use PWERHOLD or PWRON to turn on the PMIC?

    Part Number: TPS659037 How should I turn on the TPS659037?

  • [FAQ] TPS659037: How can I tell which OTP I am using?

    Part Number: TPS659037 How do I know which OTP settings are programmed in the device I am using?

  • [FAQ] TPS659037: Can I run the PMIC without OTP or modify the OTP?

    Part Number: TPS659037 Can I reprogram the OTP settings to match my design requirements?

  • [FAQ] TPS659037: What is OTP?

    Part Number: TPS659037 What is OTP? Where can I find the OTP settings for a part number?

  • [FAQ] TPS650830: Is a series resistor needed on the VBATTBKUP?

    Part Number: TPS650830 Is a series resistor needed on the VBATTBKUP?

View FAQ threads