Texas Instruments (TI) Power management support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search power management IC content or ask technical support questions on everything from linear and DC/DC switching regulators to battery management and LED drivers. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions

  • [FAQ] TPS923651: List of FAQs for TPS923651 / TPS923650

    Part Number: TPS923651 Other Parts Discussed in Thread: TPS923650 Tool/software: This thread provides a list of frequently asked questions for TPS923651 / TPS923650 LED driver. You can click below link to check the detailed answer for each question…

  • [FAQ] TPS922051: List of FAQs for TPS922051 / TPS922050

    Part Number: TPS922051 Other Parts Discussed in Thread: TPS922050 Tool/software: This thread provides a list of frequently asked questions for TPS922051 / TPS922050 LED driver. You can click below link to check the detailed answer for each question.

  • [FAQ] TPS25947: How to achieve 3 channel Priority PMUX using TPS25947

    Part Number: TPS25947 Tool/software: Extending the datasheet section 9.5 Priority Power MUXing for three input voltage rails.

  • [FAQ] UCC21750-Q1: Gate Drivers Actual Peak Current

    Part Number: UCC21750-Q1 Other Parts Discussed in Thread: UCC21750 , Tool/software: Gate Driver Actual Peak Current: UCC21750/UCC21750-Q1 is a constant voltage driver, so the driver will supply current until the gate is charged to the VDD-VEE potential…

  • [FAQ] UCC21750-Q1: Isolated Gate Drivers Bias Current Requirement for Primary side

    Part Number: UCC21750-Q1 Tool/software: What are the parameters to be considered for Low voltage (Primary side) Bias supply current requirement? Primary Bias Supply Power Requirement: In datasheet , Vcc and Vdd current plots for different conditions…

  • [FAQ] UCC21750-Q1: Isolated Gate Drivers Bias Current Requirement

    Part Number: UCC21750-Q1 Tool/software: What are the parameters to be considered for VDD/VCC2 bias current requirement? How to define it for N parallel switches? Isolated gate drivers are used to switch IGBT, Si and SiC power switches…

  • [FAQ] TPS3701: How to monitor negative supply rails with a voltage supervisor

    Part Number: TPS3701 Other Parts Discussed in Thread: TPS3700 Tool/software: Can you please provide some guidance and examples on negative supply rail monitoring solutions?

  • [FAQ] TI-PD-ANALYZER: FAQ

    Part Number: TI-PD-ANALYZER Tool/software: WHAT IS THE TI PD ANALYZER? The TI-PD-ANALYZER is a low-cost Power Delivery Analyzer and can be used to monitor and log USB type-C power delivery (PD) data by monitoring the configuration channels (CC1…

  • [FAQ] BQ41Z50: ECC Authentication Tool

    Part Number: BQ41Z50 Tool/software: To use the ECC Authentication tool for BQ41z50, refer to the provided PDF guide. It offers a high-level overview of the ECC algorithm and step-by-step instructions for using the ECC GUI. PDF Guide and Executable…

  • [FAQ] TPS1HB08-Q1: ISNSFH at low VBB

    Part Number: TPS1HB08-Q1 Tool/software: Hello All, When operating at low VBB the RSNS value needs to be scaled to match this operating voltage. For an application reference, to get the correct ISNSFH values mentioned in the data sheet the following…

View FAQ threads