TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Power management

Power management

Power management forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Power management support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search power management IC content or ask technical support questions on everything from linear and DC/DC switching regulators to battery management and LED drivers. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] LP8758-E0: Max duty and dropout voltage characteristic

    K. Sasaki14
    K. Sasaki14
    Part Number: LP8758-E0 Other Parts Discussed in Thread: LP8758 I got the answer that LP8758-E0 Max duty is 100% from the following URL E2E post. However there is "dropout voltage" (min 0.7V) on datasheet electrical characteristics. What does this…
    • Answered
    • over 7 years ago
    • Power management
    • Power management forum
  • [FAQ] TPS65070: power on fail

    Kamal Najmi
    Kamal Najmi
    Part Number: TPS65070 I'm using the TPS65070 as Power-Manager of an IIoT-System. As power-supply I use LiPo or/and AC. After booting the TSP EN_DCDC1 is high and in the CON_CTRL1-Register there is the default setting “01111111” This means after pulling…
    • over 7 years ago
    • Power management
    • Power management forum
  • [FAQ] UCD3138: UCD3138 getting started

    Sanatan Rajagopalan
    Sanatan Rajagopalan
    Part Number: UCD3138 Hello Everyone, I will list the links and learning material to get started on the UCD3138 firmware development : Initial documents to read: 1) Datasheet : http://www.ti.com/product/UCD3138/datasheet Section 5 , 6 and 9 would…
    • over 8 years ago
    • Power management
    • Power management forum
  • [FAQ] UCD90160A vs UCD90160 and UCD9090A vs UCD9090

    yihe
    yihe
    Other Parts Discussed in Thread: UCD90160A , UCD9090A Please refer http://www.ti.com/lit/an/slva908/slva908.pdf to understand the improvemetns to UCD9090A and UCD90160A . Regards Yihe
    • over 8 years ago
    • Power management
    • Power management forum
  • [FAQ] TPS65094: Is TPS65094 suitable for any version of APOLLO LAKE

    chentsu chung
    chentsu chung
    Part Number: TPS65094 Hi Sir, Is TPS65094 suitable for any version of APOLLO LAKE like N3350, N3350 B1 stepping, N4200...etc? Or TPS65094 is for any Apollo Lake platform? Thank you.
    • Answered
    • over 8 years ago
    • Power management
    • Power management forum
  • [FAQ] Please Read the UCD90XXX Family Frequently Q&A before posting any questions.

    yihe
    yihe
    Please read the UCD90XXX Family Frequenctly Asked Questions and Answers from below http://www.ti.com/lit/pdf/slua815 before posting your questions. You may find your answers there. Thanks Yihe
    • Answered
    • over 8 years ago
    • Power management
    • Power management forum
  • [FAQ] LMG3410-HB-EVM: Modifications to "Using the LMG3410-HB-EVM Half-Bridge and LMG34XX-BB-EVM Breakout Board EVM"

    Serkan Dusmez
    Serkan Dusmez
    Part Number: LMG3410-HB-EVM We have made some improvements to the LMG3410-HB-EVM, resulting in a revision D of the EVM. The official EVM Users Guide is currently being modified, so this document acts as an errata until the formal documentation is complete…
    • over 8 years ago
    • Power management
    • Power management forum
  • [FAQ] Linux Drivers for PMICs

    Chase Maupin
    Chase Maupin
    Other Parts Discussed in Thread: TPS65910 , TPS65912 , TPS65913 , TPS65917-Q1 , TPS65916 , TPS659039-Q1 , TPS659037 , TPS65217 , TPS80032 , TPS65090 , TPS65218 , TPS68470 , LP8720 , LP8725 , LP8733 , LP87565-Q1 , TPS65185 Many times people are looking…
    • over 10 years ago
    • Power management
    • Power management forum
  • [FAQ] Ripple lm3478 no load.

    Ewgeny Kolomyicev
    Ewgeny Kolomyicev
    Other Parts Discussed in Thread: LM3478 Hi! I made a converter 21- 30V - > 48V 1A. The chip LM3478 . There was a problem . No load ripple 1,5V 4Hz . Under load 50mA or more do not. The scheme was developed in WEBENCH. All denominations except the…
    • Answered
    • over 12 years ago
    • Power management
    • Power management forum
<

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Answered

    BQ20Z655-R1: Calibration and Addresses 0 Locked

    253 views
    1 reply
    Latest over 6 years ago
    by Kang Kang
  • Suggested Answer

    BQ28Z610: BQ28z610 0 Locked

    370 views
    1 reply
    Latest over 6 years ago
    by Kang Kang
  • Suggested Answer

    BQ25890: When increase input supply current, Vbat is much over Vbattery_actually 0 Locked

    365 views
    8 replies
    Latest over 6 years ago
    by Ning T
  • Suggested Answer

    BQ77PL900: problem facing in over voltage condition and in discharging condition in auto mode 0 Locked

    396 views
    3 replies
    Latest over 6 years ago
    by WM5295
  • Answered

    Fusion Digital Power Designer: No USB adapter found 0 Locked

    878 views
    2 replies
    Latest over 6 years ago
    by Qian Chen
  • Suggested Answer

    TPS53625: Layout question- feedback and bias pins 0 Locked

    364 views
    3 replies
    Latest over 6 years ago
    by Qian Chen
  • Suggested Answer

    BQ2946: BQ294624 - Temperature limit behaviour 0 Locked

    289 views
    3 replies
    Latest over 6 years ago
    by WM5295
  • Suggested Answer

    BQ25892: Slow Charging using TypeC charger 0 Locked

    407 views
    5 replies
    Latest over 6 years ago
    by Ning T
  • Suggested Answer

    BQ24100: Part fails to charge after 3 months in the field 0 Locked

    679 views
    14 replies
    Latest over 6 years ago
    by Jeff F
  • Suggested Answer

    CSD95490Q5MC: Series R/L model 0 Locked

    515 views
    3 replies
    Latest over 6 years ago
    by Lucian Hriscu
  • Suggested Answer

    BQ78350-R1: Authentication for bqstudio 0 Locked

    379 views
    5 replies
    Latest over 6 years ago
    by WM5295
  • Suggested Answer

    TPS53681: 8-bit Registers 0 Locked

    266 views
    3 replies
    Latest over 6 years ago
    by Carmen Parisi
  • Suggested Answer

    LM5017: Reference design "SNVR323" for 3x isolated supplies disagrees with LM5017 datasheet? 0 Locked

    362 views
    1 reply
    Latest over 6 years ago
    by Orlando Murray
  • Suggested Answer

    TPS7B63-Q1: TPS7B63-Q1,TPS3702AX33QDDCRQ1 0 Locked

    280 views
    1 reply
    Latest over 6 years ago
    by Ryan Eslinger
  • Answered

    LM5141QRGEVM: Output voltage fluctuates at low frequency 0 Locked

    458 views
    3 replies
    Latest over 6 years ago
    by Orlando Murray
  • Answered

    LMZ10501: Mass/Weight 0 Locked

    266 views
    1 reply
    Latest over 6 years ago
    by Jimmy Hua
  • Suggested Answer

    UCC28634: How to use the double power function of UCC28634? 0 Locked

    903 views
    8 replies
    Latest over 6 years ago
    by Hong Huang
  • Answered

    TPS63060: request to measure PHASE MARGIN of TPS63060DSCT 0 Locked

    493 views
    3 replies
    Latest over 6 years ago
    by Milos
  • Suggested Answer

    TPS23754: Wrong PoE classification TPS23754 with 802.3at GLOBTEK GT-96300-3656-T3-AP PoE injector 0 Locked

    2013 views
    1 reply
    Latest over 6 years ago
    by Thomas Amlee
  • Suggested Answer

    BQ20Z45-R1: SOCC Perm Failure after Discharge Current 0 Locked

    408 views
    5 replies
    Latest over 6 years ago
    by Kang Kang
<>