Texas Instruments (TI) Power management support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search power management IC content or ask technical support questions on everything from linear and DC/DC switching regulators to battery management and LED drivers. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Part Number: TPS650330-Q1
The design documents (datasheets and TRM) are on TI MySecure folder. Customers can request access from the link below:
www.ti.com/.../swlicexportcontrol.tsp
Once approved, design documents can be accessed from the link…
Part Number: BQ4050 FAQs
How to enter UNSEAL or FULL ACCESS modes after sealing the gauge?
How long does the voltage on the PACK pin need to be applied to wake-up the gauge?
What are the differences between hardware and firmware protections? …
Other Parts Discussed in Thread: UCC27517A , UCC21551 , UCC27714 When looking for a power supply for an AC/DC system, high efficiency, high power factor (PF) and low power line harmonics are all of major concern. This article will take a look at power…
The gauge takes an OCV measurements periodically when in relaxation and then uses this measurement to recalculate the remaining capacity and full charge capacity. If there is a change in conditions, like temperature, or every 5 hours in relaxation mode…
Other Parts Discussed in Thread: BQSTUDIO One of the most common problems when trying to complete the learning cycle is having the Update Status (Learned Status) not transition from 0x05 to 0x06. This transition indicates that the gauge has updated the…
Other Parts Discussed in Thread: BQ27Z561 , BQ27Z561-R2 , BQ27Z561-R1 BQ27Z561 FAQ Home Page
This is the home page for common questions in relation to the BQ27Z561, BQ27Z561-R1, and BQ27Z561-R2.
FAQs
Related FAQ home pages:
Impedance Track FAQ…
Other Parts Discussed in Thread: BQSTUDIO One of the most common problems when trying to complete the learning cycle is having the Update Status (Learned Status) not transition from 0x04 to 0x05. For this to happen, there must be at least a 90% change…
Other Parts Discussed in Thread: TPS7B86-Q1 , TPS745 One commonly misunderstood topic regarding low dropout regulators (LDOs) is thermal dissipation. LDOs drop the input voltage using a FET in order to achieve the desired output rail. This power dissipates…
Part Number: BQ24800 Other Parts Discussed in Thread: BQ24780S Customers are often interested in knowing the max duty cycle of the buck converter so they can estimate the max output voltage of the charger at different input voltages. The max duty cycle…
Other Parts Discussed in Thread: TPSF12C1 , TPSF12C3 Part Numbers: TPSF12C1/3/-Q1
TPSF12C1/-Q1 and TPSF12C3/-Q1 FAQ home page
This is the home page for common questions and collateral resources related to the TI's new family of power-supply filter…
