Texas Instruments (TI) Power management support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search power management IC content or ask technical support questions on everything from linear and DC/DC switching regulators to battery management and LED drivers. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions

  • [FAQ] TPS650830: Can TPS65083x be powered by 5V supply?

    Part Number: TPS650830 Can TPS65083x be powered by 5V supply?

  • [FAQ] TPS650830: How to set Resistor Divider for VDCSNS Comparator?

    Part Number: TPS650830 How to set resistor divider for VDCSNS comparator?

  • [FAQ] TPS65916: Which I2C bus should I use?

    Part Number: TPS65916 Should I use I2C1 or I2C2?

  • [FAQ] TPS65916: What voltage can the open-drain GPIOs be pulled up to?

    Part Number: TPS65916 What voltage should I use to pullup the GPIOs?

  • [FAQ] TPS65916: How should VCCA and VIO supplies be sequenced?

    Part Number: TPS65916 What are the requirements for the sequencing of the input supplies for this device?

  • [FAQ] TPS65916: Should I use PWRON or POWERHOLD to turn on the device?

    Part Number: TPS65916 How should I enable the device?

  • [FAQ] TPS65916: Can I run the PMIC without OTP or modify the OTP?

    Part Number: TPS65916 Can I change the initial OTP settings?

  • [FAQ] TPS65916: What is OTP?

    Part Number: TPS65916 What is OTP? Where can I find OTP settings?

  • [FAQ] TPS659037: Do I need to use a crystal?

    Part Number: TPS659037 Is a crystal required with this PMIC?

  • [FAQ] TPS659037: Which I2C bus should be used?

    Part Number: TPS659037 Should I use I2C1 or I2C2?

View FAQ threads