TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Power management

Power management

Power management forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Power management support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search power management IC content or ask technical support questions on everything from linear and DC/DC switching regulators to battery management and LED drivers. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] BQ24610, BQ24616, BQ24617, BQ24618, & BQ24630: Layout guidelines and example

    Michael Emanuel35
    Michael Emanuel35
    Part Number: BQ24610 Other Parts Discussed in Thread: BQ24617 , BQ24616 , , BQ24618 , BQ24630 Please see the below document for the layout guidelines and example for the BQ24610, BQ24616, BQ24617, BQ24618, and BQ24630. Layout Guidelines and Example…
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] TPS3840: PFET based disconnect on overvoltage

    Ajay Padgaonkar
    Ajay Padgaonkar
    Part Number: TPS3840 In case of an overvoltage situation, how can the downstream power tree be disconnected to protect it from such overvoltage? Can reset ICs not only sense the overvoltage but also drive a PFET switch to turn it off?
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] TPS62903: Reasons for Vout variations away from the expected value?

    Joseph Conrad
    Joseph Conrad
    Part Number: TPS62903 Other Parts Discussed in Thread: TPS62901 , TPS629210-Q1 What are some of the causes of output voltage variations in the TPS62901/2/3 buck converters?
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] TPS62130A: How to use the Power Good (PG) pin?

    Joseph Conrad
    Joseph Conrad
    Part Number: TPS62130A Other Parts Discussed in Thread: TPS62130 , What is the PG pin used for and what are the differences between the TPS62130 and TPS62130A?
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] BQ25171-Q1: Configuration Pins and Design Questions

    Bill Johns
    Bill Johns
    Part Number: BQ25171-Q1 The device can be configured to charge Li-Ion, NiMH and LiFePO using external pins. Can the configuration be changed during operation? Any other things I should note?
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] BQ25890: Why does ICHG reduce when reaching the maximum duty cycle for the BQ25890, BQ25890H, BQ25892, BQ25895, BQ25895M, BQ25896, BQ25898, BQ25898D, BQ24190, BQ24192, BQ24195, BQ24195L, BQ24196, BQ24295, BQ24296, BQ24296M, BQ24259?

    Wyatt Keller
    Wyatt Keller
    Part Number: BQ25890 The charger is basically a step-down DC-DC (buck) converter. It requires the input voltage to be higher than the output voltage with some headroom for normal operations. The maximum duty cycle specification is one of the factors…
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] BQ25890: Why does ICHG reduce during input voltage DPM (Dynamic Power Management) or the input current DPM for the chargers BQ25890, BQ25890H, BQ25892, BQ25895, BQ25895M, BQ25896, BQ25898, BQ25898D, BQ24190, BQ24192, BQ24195, BQ24195L, BQ24196,...

    Wyatt Keller
    Wyatt Keller
    Part Number: BQ25890 When the input source is over-loaded, it is either from the current exceeding the IINDPM (Input Current Limit) or from the voltage dropping below VINDPM (Input Voltage Limit). For the current to cause the input source to be…
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] BQ25618: [FAQ] Why does ICHG reduce when reaching the maximum duty cycle for the BQ25618, BQ25618E, BQ25619, BQ25611D, BQ25616, BQ25600, BQ25600D, BQ25601, BQ25601D, BQ25606?

    Wyatt Keller
    Wyatt Keller
    Part Number: BQ25618 The charger is basically a step-down DC-DC (buck) converter. It requires the input voltage to be higher than the output voltage with some headroom for normal operations. The maximum duty cycle specification is one of the factors…
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] BQ25618: Why does ICHG reduce during the input current DPM (Dynamic Power Management) or the input voltage DPM for the chargers BQ25618, BQ25618E, BQ25619, BQ25611D, BQ25616, BQ25600, BQ25600D, BQ25601, BQ25601D, BQ25606?

    Wyatt Keller
    Wyatt Keller
    Part Number: BQ25618 When the input source is over-loaded, it is either from the current reaching the IINDPM (Input Current Limit) or from the voltage dropping to the VINDPM (Input Voltage Limit). For the current to cause the input source to be…
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] TPS53353: [FAQ] VFB at Light Load Current vs Heavier Load Current

    Alec Biesterfeld
    Alec Biesterfeld
    Part Number: TPS53353 If using skip mode, a higher VOUT is expected at a light load when compared to a heavier load when the device is operating in CCM. This is not an artifact of the reference voltage (or feedback voltage) changing as a function of load…
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Answered

    LP2951 input capacitor 0 Locked

    518 views
    1 reply
    Latest over 9 years ago
    by Michael J Schultis
  • Suggested Answer

    EV2300 USB driver does not work 0 Locked

    542 views
    2 replies
    Latest over 9 years ago
    by mike zhang
  • Not Answered

    BQ25050 behavior of OUT pin when no battery is connected 0 Locked

    318 views
    2 replies
    Latest over 9 years ago
    by Jing Zou
  • Not Answered

    floating reference for tps2492 0 Locked

    611 views
    2 replies
    Latest over 9 years ago
    by Alex Triano
  • Answered

    TPS25942/IEC60950-1-am2.0 0 Locked

    1405 views
    5 replies
    Latest over 9 years ago
    by Venkata Nandam
  • Not Answered

    BQ24103A 0 Locked

    519 views
    8 replies
    Latest over 9 years ago
    by Jing Zou
  • Answered

    TPS62170-Q1 Switching Node Waveform for Light Load 0 Locked

    2789 views
    11 replies
    Latest over 9 years ago
    by Luis Cordova
  • Answered

    TPS2553 current limit question 0 Locked

    1086 views
    5 replies
    Latest over 9 years ago
    by Eric Wright
  • Suggested Answer

    TPS23861 questions 0 Locked

    619 views
    1 reply
    Latest over 9 years ago
    by Penny Xu
  • Answered

    TPS56121's EN/SS pin increase voltage 0 Locked

    333 views
    2 replies
    Latest over 9 years ago
    by JohnTucker
  • Not Answered

    CAPACITOR CHARGER upto 200V 0 Locked

    604 views
    3 replies
    Latest over 9 years ago
    by Billy Long
  • Answered

    BQ24617 Overvoltage protection 0 Locked

    402 views
    2 replies
    Latest over 9 years ago
    by Lefteris Kostoulas
  • Suggested Answer

    TPS65217 schematic checklist related query for N/A text for Not Used Features for AM335X processor 0 Locked

    736 views
    3 replies
    Latest over 9 years ago
    by Richard Solarski
  • Answered

    TPS62740 size pullup resistor (10Mohm) at EN pin 0 Locked

    502 views
    1 reply
    Latest over 9 years ago
    by Chris Glaser
  • Not Answered

    bq24158 Timer fault question 0 Locked

    189 views
    1 reply
    Latest over 9 years ago
    by Jeff F
  • Answered

    DCR010505 Fails to Start Sometimes 0 Locked

    1173 views
    3 replies
    Latest over 9 years ago
    by Tom Guerin
  • Not Answered

    Active balancing in BQ76930? 0 Locked

    284 views
    0 replies
    Started over 9 years ago
    by Maria Luisa Sanchez Maizer
  • Not Answered

    bq76930 current consumption 0 Locked

    578 views
    2 replies
    Latest over 9 years ago
    by Maria Luisa Sanchez Maizer
  • Suggested Answer

    LM3463 EN and DIMn pin questions 0 Locked

    830 views
    3 replies
    Latest over 9 years ago
    by Kazuya Nakai59
  • Not Answered

    Low height requirement device selection 0 Locked

    354 views
    3 replies
    Latest over 9 years ago
    by JohnTucker
<>