Texas Instruments (TI) Power management support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search power management IC content or ask technical support questions on everything from linear and DC/DC switching regulators to battery management and LED drivers. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Make sure to use the latest version of the TI Fusion Designer GUI ( Fusion Digital Power Designer ) . TI also provides an "Alert Me" feature to notify the registered users when a new GUI version is available to download.
For more FAQ please check…
Other Parts Discussed in Thread: UCD90120A , UCD9090 , UCD90160A , UCD90160 , UCD90240 , UCD90320U , UCD90120 , UCD9090A , UCD90124 , UCD90124A , UCD90320 The faulted rail is configurable to either shutdown immediate or soft off. This is set at the fault…
Other Parts Discussed in Thread: UCD90120A , UCD9090 , UCD90160A , UCD90160 , UCD90240 , UCD90320U , UCD90120 , UCD9090A , UCD90124 , UCD90124A , UCD90320 There is a CONTROL signal turnoff configuration: Soft Off (with Sequencing) or Immediately Off.…
Other Parts Discussed in Thread: UCD90120A , UCD9090 , UCD90160A , UCD90160 , UCD90240 , UCD90320U , UCD90120 , UCD9090A , UCD90124 , UCD90124A , UCD90320 Yes, but it is not recommended to do so. A rail EN pin has many features that logic GPO pins do…
Other Parts Discussed in Thread: UCD90120A , UCD9090 , UCD90160A , UCD90160 , UCD90240 , UCD90320U , UCD90120 , UCD9090A , UCD90124 , UCD90124A , UCD90320 If the sequence hangs, check at which step the sequence is stuck, then find the cause. For example…
Other Parts Discussed in Thread: UCD90120A , UCD9090 , UCD90160A , UCD90160 , UCD90240 , UCD90320U , UCD90120 , UCD9090A , UCD90124 , UCD90124A , UCD90320 The "time between re-sequences" only starts to count when all rails are below their POWER_GOOD_OFF…
Other Parts Discussed in Thread: UCD90120A , UCD9090 , UCD90160A , UCD90160 , UCD90240 , UCD90320U , UCD90120 , UCD9090A , UCD90124 , UCD90124A , UCD90320 The re-sequencing count is reset when all re-sequencing rails stay above the POWER_GOOD threshold…
Other Parts Discussed in Thread: UCD90120A , UCD9090 , UCD90160A , UCD90160 , UCD90240 , UCD90320U , UCD90120 , UCD9090A , UCD90124 , UCD90124A , UCD90320 The retry count is reset whenever the rail stays above the POWER_GOOD threshold for a TON_MAX_FAULT_LIMIT…
Other Parts Discussed in Thread: UCD90120A , UCD9090 , UCD90160A , UCD90160 , UCD90240 , UCD90320U , UCD90120 , UCD9090A , UCD90124 , UCD90124A , UCD90320 For rails that are off due to fault response and ON_OFF_CONFIG set to AUTO, the only way to power…
