TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Power management

Power management

Power management forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Power management support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search power management IC content or ask technical support questions on everything from linear and DC/DC switching regulators to battery management and LED drivers. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] BQ24610, BQ24616, BQ24617, BQ24618, & BQ24630: Layout guidelines and example

    Michael Emanuel35
    Michael Emanuel35
    Part Number: BQ24610 Other Parts Discussed in Thread: BQ24617 , BQ24616 , , BQ24618 , BQ24630 Please see the below document for the layout guidelines and example for the BQ24610, BQ24616, BQ24617, BQ24618, and BQ24630. Layout Guidelines and Example…
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] TPS3840: PFET based disconnect on overvoltage

    Ajay Padgaonkar
    Ajay Padgaonkar
    Part Number: TPS3840 In case of an overvoltage situation, how can the downstream power tree be disconnected to protect it from such overvoltage? Can reset ICs not only sense the overvoltage but also drive a PFET switch to turn it off?
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] TPS62903: Reasons for Vout variations away from the expected value?

    Joseph Conrad
    Joseph Conrad
    Part Number: TPS62903 Other Parts Discussed in Thread: TPS62901 , TPS629210-Q1 What are some of the causes of output voltage variations in the TPS62901/2/3 buck converters?
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] TPS62130A: How to use the Power Good (PG) pin?

    Joseph Conrad
    Joseph Conrad
    Part Number: TPS62130A Other Parts Discussed in Thread: TPS62130 , What is the PG pin used for and what are the differences between the TPS62130 and TPS62130A?
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] BQ25171-Q1: Configuration Pins and Design Questions

    Bill Johns
    Bill Johns
    Part Number: BQ25171-Q1 The device can be configured to charge Li-Ion, NiMH and LiFePO using external pins. Can the configuration be changed during operation? Any other things I should note?
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] BQ25890: Why does ICHG reduce when reaching the maximum duty cycle for the BQ25890, BQ25890H, BQ25892, BQ25895, BQ25895M, BQ25896, BQ25898, BQ25898D, BQ24190, BQ24192, BQ24195, BQ24195L, BQ24196, BQ24295, BQ24296, BQ24296M, BQ24259?

    Wyatt Keller
    Wyatt Keller
    Part Number: BQ25890 The charger is basically a step-down DC-DC (buck) converter. It requires the input voltage to be higher than the output voltage with some headroom for normal operations. The maximum duty cycle specification is one of the factors…
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] BQ25890: Why does ICHG reduce during input voltage DPM (Dynamic Power Management) or the input current DPM for the chargers BQ25890, BQ25890H, BQ25892, BQ25895, BQ25895M, BQ25896, BQ25898, BQ25898D, BQ24190, BQ24192, BQ24195, BQ24195L, BQ24196,...

    Wyatt Keller
    Wyatt Keller
    Part Number: BQ25890 When the input source is over-loaded, it is either from the current exceeding the IINDPM (Input Current Limit) or from the voltage dropping below VINDPM (Input Voltage Limit). For the current to cause the input source to be…
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] BQ25618: [FAQ] Why does ICHG reduce when reaching the maximum duty cycle for the BQ25618, BQ25618E, BQ25619, BQ25611D, BQ25616, BQ25600, BQ25600D, BQ25601, BQ25601D, BQ25606?

    Wyatt Keller
    Wyatt Keller
    Part Number: BQ25618 The charger is basically a step-down DC-DC (buck) converter. It requires the input voltage to be higher than the output voltage with some headroom for normal operations. The maximum duty cycle specification is one of the factors…
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] BQ25618: Why does ICHG reduce during the input current DPM (Dynamic Power Management) or the input voltage DPM for the chargers BQ25618, BQ25618E, BQ25619, BQ25611D, BQ25616, BQ25600, BQ25600D, BQ25601, BQ25601D, BQ25606?

    Wyatt Keller
    Wyatt Keller
    Part Number: BQ25618 When the input source is over-loaded, it is either from the current reaching the IINDPM (Input Current Limit) or from the voltage dropping to the VINDPM (Input Voltage Limit). For the current to cause the input source to be…
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
  • [FAQ] TPS53353: [FAQ] VFB at Light Load Current vs Heavier Load Current

    Alec Biesterfeld
    Alec Biesterfeld
    Part Number: TPS53353 If using skip mode, a higher VOUT is expected at a light load when compared to a heavier load when the device is operating in CCM. This is not an artifact of the reference voltage (or feedback voltage) changing as a function of load…
    • Answered
    • over 4 years ago
    • Power management
    • Power management forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Not Answered

    TPS76701QPWPR 0 Locked

    233 views
    1 reply
    Latest over 10 years ago
    by David Hopkins
  • Answered

    TPS70302PWP / ψJT 0 Locked

    317 views
    1 reply
    Latest over 10 years ago
    by David Hopkins
  • Not Answered

    TPS40210EVM 0 Locked

    366 views
    2 replies
    Latest over 10 years ago
    by Bahadur Sagoo
  • Answered

    PMP7499 Circuit Design 0 Locked

    592 views
    1 reply
    Latest over 10 years ago
    by Eric Wright
  • Not Answered

    TPS92661 / EN , SYNC pin 0 Locked

    240 views
    0 replies
    Started over 10 years ago
    by Ryuji
  • Not Answered

    LM3429 PWM Dimming Problem 0 Locked

    584 views
    5 replies
    Latest over 10 years ago
    by Lucifer
  • Not Answered

    TPS65023 setting condition 0 Locked

    650 views
    4 replies
    Latest over 10 years ago
    by tateo yamashiro
  • Not Answered

    Equivalent Isolated DCDC for Linear Tech LT8302 0 Locked

    557 views
    0 replies
    Started over 10 years ago
    by Kum Hoo Lee
  • Not Answered

    TPS55340 0 Locked

    404 views
    2 replies
    Latest over 10 years ago
    by Anthony F
  • Not Answered

    TWL6032 0 Locked

    335 views
    1 reply
    Latest over 10 years ago
    by AlainC
  • Answered

    bq27441-g1 0 Locked

    1741 views
    7 replies
    Latest over 10 years ago
    by Kang Kang
  • Not Answered

    LM5088 excessive Vout ripple from SW node sub-harmonic oscillations at Vin=24V/5A for a 20V switcher 0 Locked

    516 views
    1 reply
    Latest over 10 years ago
    by EricLee
  • Not Answered

    200 amp mosfet 3.7v to 4.2v 0 Locked

    2095 views
    3 replies
    Latest over 10 years ago
    by Brett Barr1
  • Not Answered

    Interesting feature of LDOs? 0 Locked

    279 views
    1 reply
    Latest over 10 years ago
    by David Hopkins
  • Not Answered

    Weird battery boot up effect from wireless charging from a drained battery 0 Locked

    820 views
    3 replies
    Latest over 10 years ago
    by Sean H
  • Not Answered

    UCC28630 and UCC39002 0 Locked

    139 views
    0 replies
    Started over 10 years ago
    by Sergio Fernandez Santos
  • Not Answered

    BQ51221EVM-520 for Transmitter product test report 0 Locked

    440 views
    1 reply
    Latest over 10 years ago
    by Dick Stacey
  • Answered

    LM1085IT-5.0/NOPB IOUT 0 Locked

    258 views
    1 reply
    Latest over 10 years ago
    by Donald Jones
  • Not Answered

    LM25011-Q1 Regulator failing and not regulating 0 Locked

    1765 views
    4 replies
    Latest over 10 years ago
    by Chuck Sampson
  • Answered

    LM5008A for split rail power supply 0 Locked

    687 views
    2 replies
    Latest over 10 years ago
    by Denis Kotlar
<>