TDA4VM: How to determine the csi port

daohong qin

Expert 1120 points

Part Number: TDA4VM

HI TI

The mipi waveform can be measured When I open the app,but No image display.that's why?

How to set the csi port?

over 1 year ago

0 Brijesh Jadav over 1 year ago

TI__Guru**** 430245 points

Hi qin,

Did not get this question, do you mean how to set CSIRX instance? then please check instId parameter in the CSIRX create parameters.

Regards,

Brijesh

0 daohong qin over 1 year ago in reply to Brijesh Jadav

Expert 1120 points

yes.I only found some code about CSIRX instance and I have modified BOARD_CSI_INST_0,It still hasn't solved the problem.Is there any other place I can set it?Do you have any good suggestions?Is the attachment the instId parameter in the CSIRX create parametersyou said?

+1 Brijesh Jadav over 1 year ago in reply to daohong qin

TI__Guru**** 430245 points

Not this one. This just helps us to get ub960 instance, not the CSIRX instance. In order to select different CSIRX instance, please select instId in the capture node create parameters, as in given in below structure.

Regards,

Brijesh

Processors

Processors forum

TDA4VM: How to determine the csi port