AM4376: QSPI output rise and fall times

shigehiro tsuda

Part Number: AM4376

Hi,

Please tell me the rise and fall time of the QSPI output signal of AM4376.
QSPI Flash input rise and fall time is 1.5 ns (max), is it possible to connect?

Best Regards,
Shigehiro Tsuda

over 8 years ago

0 Biser Gatchev-XID over 8 years ago

TI__Guru**** 393215 points

The factory team have been notified. They will respond here.

0 shigehiro tsuda over 8 years ago in reply to Biser Gatchev-XID

Mastermind 9490 points

Hi Biser,

Thank you for your support.
Is there any update information from your factory team?

Best Regards,
Shigehiro Tsuda

0 Biser Gatchev-XID over 8 years ago in reply to shigehiro tsuda

TI__Guru**** 393215 points

Sorry about the delay. I have escalated the request.

0 Lawrence Ronk over 8 years ago in reply to Biser Gatchev-XID

TI__Intellectual 2810 points

We are following-up on this. We are checking the data.

0 -DK- over 8 years ago

TI__Mastermind 27890 points

Tsuda-san,

I have forwarded this request directly to our Design team. I'll let you know what they say.

0 -DK- over 7 years ago in reply to -DK-

TI__Mastermind 27890 points

Tsuda-san,

These values are not provided in our documentation as they are application specific. The customer should simulate the interface on their board to determine the value in their specific use-case. The IBIS model is located here:

Processors

Processors forum

AM4376: QSPI output rise and fall times

http://www.ti.com/lit/zip/sprm636