Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Part Number: AM3357
Tool/software:
Hi team,
I am planning to input an analog signal to AM3357's AIN by dividing the voltage. Was the constant of the voltage divider resistor OK with the constant shown in the figure? I am wondering if I should add…
Part Number: AM62A7 Other Parts Discussed in Thread: SYSCONFIG
Tool/software:
Questions addressed in this post:
What is OSPI Phy Tuning?
When is the Phy Tuning Algorithm used?
Where is the Phy enabled and disabled throughout the MCU PLUS SDK…
Part Number: AM6442 Other Parts Discussed in Thread: SK-AM64B
Tool/software:
Hello,
I am designing a board with Ethernet and USB3 using the AM6442. I have referred to the device sheet and TRM, but I could not find the required specifications for…
Part Number: AM6442
Tool/software:
Dear Sitara HW champs,
In the Table “6-19. MCU_OSC0 Crystal Circuit Requirements” in the AM64x datasheet, it is specified the following :
. When not using the RGMII and/or RMII interfaces, then +/-100 ppm Xtal…
Part Number: PROCESSOR-SDK-AM64X Tool/software: I am trying to load the SDK example code to AM62x/AM64x board, but I am facing an issue while loading the program into it as shown in the below screenshot.
Can you please help to resolve the above error…
Part Number: AM625 Other Parts Discussed in Thread: TMDS64EVM , SK-AM64B , SK-AM62B-P1 , SK-AM62-LP , SK-AM62B , SK-AM62-SIP , , SK-AM62A-LP , AM62P , SK-AM62P-LP
Tool/software:
HI TI experts,
We are currently designing a custom board leveraging…
Part Number: TDA4VM-Q1 Other Parts Discussed in Thread: TDA4VM
Tool/software:
Hi Expert,
My customer Motovis report an issue about ethernet link down issue, customer have catch the MDIO using the Logic analysis, they find there is some difference…
Part Number: AM625
Tool/software:
Hi Ti Experts,
I am designing a custom board for the AM6254 SoC and trying to connect an SPI peripheral to the AM6254 SPI interface.
I intend to use MCU_SPI1 Channel but I am not sure which one is MISO and MOSI…
Part Number: TDA4AP-Q1
Tool/software:
Hi TI Experts,
Customer is working on TDA4AP SDK10.0. They are using SPL boot.
They want to change the De-emphasis to be -3.5dB for PCIe0 for 5.0GT/s to minimize reflection. Please see the below description…
