TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DRA821: SPL BOOT without A72 SPL on J7200 on 10.1 SDK

    Gokul Praveen
    Gokul Praveen
    Part Number: DRA821 Tool/software: How to enable Falcon Boot Mode on J7200? Boot Flow: R5 SPL -> ATF -> OPTEE -> U-BOOT -> Kernel Regards Gokul
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198292 Discussions
  • Not Answered

    AM3359 How to change LCD resolution (800x480 to 480x272) 0 Locked

    543 views
    1 reply
    Latest over 12 years ago
    by liu liu1
  • Not Answered

    Dose DM368 support 720P display on clock of 75555555 0 Locked

    197 views
    0 replies
    Started over 12 years ago
    by yangchar
  • Answered

    a question about H264_DEC_002 and 4k x 2k video decoding 0 Locked

    796 views
    14 replies
    Latest over 12 years ago
    by Xiaotao Hou
  • Answered

    interrupt routine is not called after enabling interrupt of McSPI 0 Locked

    990 views
    6 replies
    Latest over 12 years ago
    by Orjan Friberg
  • Answered

    uartEcho compiled with CodeSourcery 4.6.1 0 Locked

    1143 views
    8 replies
    Latest over 12 years ago
    by Orjan Friberg
  • Answered

    Regarding gst ducati plugins 0 Locked

    711 views
    3 replies
    Latest over 12 years ago
    by Carol Suman Pinto
  • Answered

    dm385-AR0331 wdr sensor. 0 Locked

    956 views
    7 replies
    Latest over 12 years ago
    by Xiao Feng Huang
  • Suggested Answer

    OMAP L138 MMC 2 register access issue 0 Locked

    2757 views
    23 replies
    Latest over 12 years ago
    by xiaohuan lee
  • Not Answered

    Decode + display problems 0 Locked

    85 views
    1 reply
    Latest over 12 years ago
    by Sivagamy Govindasamy
  • Answered

    EDMA3 test copy data not successful. 0 Locked

    387 views
    3 replies
    Latest over 12 years ago
    by sunfarmer
  • Answered

    How use a dual MMC configuration on the AM335x-EVM 0 Locked

    1209 views
    8 replies
    Latest over 12 years ago
    by xiaohuan lee
  • Answered

    What's defferent between input frame-rate and target frame-rate? 0 Locked

    1753 views
    14 replies
    Latest over 12 years ago
    by Badri Narayanan
  • Not Answered

    DM365–DVR, not able to play recorded video... 0 Locked

    210 views
    2 replies
    Latest over 12 years ago
    by PP_123
  • Not Answered

    AM335x ethernet multicast receive. 0 Locked

    1020 views
    2 replies
    Latest over 12 years ago
    by chaitanya godavarthi
  • Answered

    C6678 I2C EEPROM Boot Issue 0 Locked

    953 views
    7 replies
    Latest over 12 years ago
    by Daisuke Maeda
  • Answered

    1st stage U-boot issue 0 Locked

    555 views
    5 replies
    Latest over 12 years ago
    by krishna prasad
  • Not Answered

    How to configure kernel for testing OTG protocols on OMAP4430 PandaBoard? 0 Locked

    1151 views
    1 reply
    Latest over 12 years ago
    by I-Hsiu Liu
  • Not Answered

    Realtek 8192CU on AM1808 using 3.3.0 kernel 0 Locked

    423 views
    1 reply
    Latest over 12 years ago
    by Shankari G
  • Answered

    How to output the analog video signals for the C665x 0 Locked

    348 views
    4 replies
    Latest over 12 years ago
    by Daisuke Maeda
  • Answered

    Dm365 + SPI + PWM Issue 0 Locked

    620 views
    6 replies
    Latest over 12 years ago
    by jk laoking
<>