TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DRA821: SPL BOOT without A72 SPL on J7200 on 10.1 SDK

    Gokul Praveen
    Gokul Praveen
    Part Number: DRA821 Tool/software: How to enable Falcon Boot Mode on J7200? Boot Flow: R5 SPL -> ATF -> OPTEE -> U-BOOT -> Kernel Regards Gokul
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 197749 Discussions
  • Discussion

    Ping flood attack hangs NDK stack Locked

    1778 views
    13 replies
    Latest over 12 years ago
    by Vinesh Balan
  • Not Answered

    USB OTG driver for OMAP-L138 LCDK 0 Locked

    942 views
    1 reply
    Latest over 12 years ago
    by Shankari G
  • Not Answered

    dm8168 display quality. 0 Locked

    284 views
    4 replies
    Latest over 12 years ago
    by Senthilnathan Maadasamy
  • Not Answered

    Beagleboard xm LAN 9221 performance in WinCE BSP 0 Locked

    459 views
    3 replies
    Latest over 12 years ago
    by Renjith Thomas
  • Answered

    AM3730 vdds_mmc1 and vdds_x connected to the general vdds power rail 0 Locked

    220 views
    2 replies
    Latest over 12 years ago
    by Diego Alegre
  • Not Answered

    How to configure resizer in ISP pipeline? 0 Locked

    347 views
    3 replies
    Latest over 12 years ago
    by Renjith Thomas
  • Answered

    Questions when tuning 8168's DDRIII phy. 0 Locked

    3947 views
    17 replies
    Latest over 12 years ago
    by Biser Gatchev-XID
  • Not Answered

    RDK NSF 0 Locked

    227 views
    4 replies
    Latest over 12 years ago
    by Li Michelle
  • Answered

    how to use AM335X HW timer 0 Locked

    624 views
    1 reply
    Latest over 12 years ago
    by peaves
  • Not Answered

    omap3-evm boot problems 0 Locked

    279 views
    2 replies
    Latest over 12 years ago
    by Renjith Thomas
  • Answered

    DM3730 EVM booting issue, stops at before filesystem mounting 0 Locked

    1442 views
    2 replies
    Latest over 12 years ago
    by Renjith Thomas
  • Not Answered

    Bluetooth module 0 Locked

    177 views
    0 replies
    Started over 12 years ago
    by ramanjulu koneni
  • Answered

    problem with mounting mmcblk on dm365 evm 0 Locked

    3581 views
    12 replies
    Latest over 12 years ago
    by Deepu Raj
  • Answered

    RDK2.8 NSF 0 Locked

    1434 views
    29 replies
    Latest over 12 years ago
    by Badri Narayanan
  • Not Answered

    I am not able to compile u-boot and MLO for the Beagleboard-xM 0 Locked

    393 views
    2 replies
    Latest over 12 years ago
    by Herman Brunner
  • Not Answered

    (DM8127 IPNC 3.2)about the REISZER OVERFLOW OCCURED:RESTARTING ... Error. 0 Locked

    3322 views
    18 replies
    Latest over 12 years ago
    by Rajat Sagar
  • Answered

    Virtual channels over CSI2 0 Locked

    693 views
    1 reply
    Latest over 12 years ago
    by Georgi Georgiev XID
  • Not Answered

    Clock to gpmc in OMAP3530 0 Locked

    295 views
    5 replies
    Latest over 12 years ago
    by Renjith Thomas
  • Not Answered

    Measuring clock cycles on C6678 EVM 0 Locked

    358 views
    2 replies
    Latest over 12 years ago
    by Louis Chouinard
  • Not Answered

    SCCB support 0 Locked

    2262 views
    8 replies
    Latest over 12 years ago
    by Renjith Thomas
<>