Part Number: TDA4VM

Tool/software:

How do I use GPIO interrupts in PDK and how are they routed in J7 devices?

Part Number: J722SXH01EVM

Tool/software:

I have the following error when trying to connect XDS110 debugger and launch target configuration in CCS:

How do I fix this?

Part Number: AM625

Tool/software:

Hi TI Experts, 

Do you have suggestions to optimize the BOOTMODE configuration on custom board compared to  implementation on the SK or the EVM schematics.

Can i remove the buffers. If yes, do you have some implementation guidance

Part Number: AM625

Tool/software:

Hi TI Experts,

I have the below queries regarding the CSI-2 interface

1. Supported data rate 
2. Does the CSI-2 interface provide provision for internal termination 
3. Links to useful threads 

Let me know your thoughts.

Part Number: AM6442

Tool/software:

We have a desire to use the SERDES as a raw interface without a protocol on top. The idea would be to just run 8b/10b and limit our packet size to 10 -40 bits. Is this possible or do we need to run PCIE or USB using the PCS?

Part Number: TDA4AH-Q1

Tool/software:

I have ONNX graph with below mentioned layer structure.

Which tools can i use to change the unsupported layer (HardSwish) to Supported ones ? 

Part Number: SK-TDA4VM

Tool/software:

Hi, TI Team
I run an opencv example program(drawing and media play) in Wayland(western).
But drawing(graphics) is little bit slow and media play occurs a stuttering frames.
- drawing.cpp: graphics example
drawing.cpp
- test_play.cpp: simple media play
test_play.cpp

I attached a video screen(performacne_issue.mp4) for checking the performance of media play - TDA4VM(left side) vs PC(right side),
you can see a stuttering frames(left side video) in TDA4VM.

Is there anything I can do to improve performance?

FYI, I am using ti-processor-sdk-linux-edgeai-j721e-evm-09_01_00_06-Linux-x86-Install.bin

Regards,
JB

Part Number: AM623

Tool/software:

Hi team,

A customer wants to have 4GB LPDDR4 (single channel topology). They could not find 4GB 16-bit single-channel LPDDR4, there is only 2GB option. Can they use a 32-bit device and only connect one channel? Please let me know if you have any suggested devices.

Thanks,

Kim Yue

Part Number: AM62P

Tool/software:

How can you measure the wakeup latency for Low Power Modes on AM62x/A/P? Low Power Mode's wakeup latency is the amount of time required from triggering a wakeup event to resuming normal operation. This FAQ shows to measure this time. This applies to AM62x, AM62A, AM62P.

Part Number: AM625

Tool/software:

Hi TI Experts,

Is there any application note with information about how to connect IOs or Peripherals - Used or Unused 

Details on the connections to be done when used.

When not used, should these IOs or Peripherals be left unconnected or connected to an pull-up or pull-down resistor.