TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DRA821: SPL BOOT without A72 SPL on J7200 on 10.1 SDK

    Gokul Praveen
    Gokul Praveen
    Part Number: DRA821 Tool/software: How to enable Falcon Boot Mode on J7200? Boot Flow: R5 SPL -> ATF -> OPTEE -> U-BOOT -> Kernel Regards Gokul
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 197740 Discussions
  • Not Answered

    how to interface dsp processor dm6437 with monitor 0 Locked

    176 views
    0 replies
    Started over 12 years ago
    by ganesh nikam
  • Not Answered

    DSP_fft16x16- Crash when I call that function twice 0 Locked

    335 views
    2 replies
    Latest over 12 years ago
    by Marcelo Gutierrez
  • Answered

    change the codec..... 0 Locked

    370 views
    3 replies
    Latest over 12 years ago
    by Israel Cepeda
  • Answered

    Audio Noise on Blaze 0 Locked

    997 views
    12 replies
    Latest over 12 years ago
    by Israel Cepeda
  • Suggested Answer

    OMAP-L138 NAND driver 0 Locked

    222 views
    2 replies
    Latest over 12 years ago
    by Balaji Nagarajan
  • Answered

    Linking Error openMP 0 Locked

    1194 views
    3 replies
    Latest over 12 years ago
    by Yogesh Siraswar
  • Answered

    C674x instruction set - online 0 Locked

    316 views
    1 reply
    Latest over 12 years ago
    by Mariana
  • Answered

    Support for Audio Re-sampling 0 Locked

    203 views
    1 reply
    Latest over 12 years ago
    by Israel Cepeda
  • Not Answered

    DM3730: Expanding RAM to 512MB from 256MB in Linux 0 Locked

    339 views
    1 reply
    Latest over 12 years ago
    by Cvetolin Shulev-XID
  • Not Answered

    DSP speed optimisation regarding 0 Locked

    104 views
    0 replies
    Started over 12 years ago
    by mayuresh shendurnikar
  • Answered

    PRU-ICSS for EtherCAT application 0 Locked

    645 views
    3 replies
    Latest over 12 years ago
    by Frank Walzer
  • Not Answered

    OMAPL138 DSP-LINK/SYSLINK to place buffers in DSP L1/L2 memory 0 Locked

    370 views
    3 replies
    Latest over 12 years ago
    by Arnie Reynoso
  • Not Answered

    How to change the EDMA priority of SPI? 0 Locked

    341 views
    5 replies
    Latest over 12 years ago
    by YJ Liu
  • Not Answered

    Replace LCD A board of EVM AM3358 0 Locked

    393 views
    6 replies
    Latest over 12 years ago
    by Biser Gatchev-XID
  • Answered

    Dual mode for SD/MMC/SDIO 1 on OMAP4430 0 Locked

    433 views
    4 replies
    Latest over 12 years ago
    by Gina Glaser
  • Not Answered

    Can't receive POSIX timer signal while linking DSPLink 0 Locked

    285 views
    3 replies
    Latest over 12 years ago
    by Ramsey
  • Answered

    about silicon error 2.1.27 SATA lock up 0 Locked

    200 views
    1 reply
    Latest over 12 years ago
    by Biser Gatchev-XID
  • Not Answered

    how to use gpio as input and output of am1808 on linux 0 Locked

    118 views
    0 replies
    Started over 12 years ago
    by harnek singh
  • Answered

    system hang sometimes with SGX recovery trigger 0 Locked

    783 views
    2 replies
    Latest over 12 years ago
    by Matthew Kiser
  • Answered

    Can't build Codec Engine Examples in EZSDK 5.05.01.04: "Error: Server info file ..... does not exist" 0 Locked

    575 views
    2 replies
    Latest over 12 years ago
    by Chris Ring
<>