TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DRA821: SPL BOOT without A72 SPL on J7200 on 10.1 SDK

    Gokul Praveen
    Gokul Praveen
    Part Number: DRA821 Tool/software: How to enable Falcon Boot Mode on J7200? Boot Flow: R5 SPL -> ATF -> OPTEE -> U-BOOT -> Kernel Regards Gokul
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 197749 Discussions
  • Not Answered

    Problems to add SCL to CCSv.5.2.1 (TMS320VC5509A) 0 Locked

    181 views
    0 replies
    Started over 13 years ago
    by Eugen Frick
  • Answered

    Problem With u-boot.bin 0 Locked

    284 views
    1 reply
    Latest over 13 years ago
    by Vladimir-XID
  • Not Answered

    Can DM368 deal with the MPEG-2 encoding with 1080i@30fps ? 0 Locked

    148 views
    0 replies
    Started over 13 years ago
    by Chen Dianyu
  • Not Answered

    what is the write buffer configuration for the LCD frame buffer? 0 Locked

    222 views
    0 replies
    Started over 13 years ago
    by Yaoming Qin
  • Not Answered

    8-bit BT.656 embedded sync capture on VIP1 PORTB 0 Locked

    333 views
    1 reply
    Latest over 13 years ago
    by Sivaramkrishna Neeruganti
  • Answered

    Build profile information in .cfg file 0 Locked

    1014 views
    2 replies
    Latest over 13 years ago
    by Sebastian D.
  • Answered

    OMAP 4460 - McBSP2 connection to receive audio data from HDMI receiver 0 Locked

    799 views
    9 replies
    Latest over 13 years ago
    by Mayank Mangla
  • Answered

    8 Bit RGB capture/display support in DM816x 0 Locked

    968 views
    12 replies
    Latest over 13 years ago
    by HardikShah
  • Discussion

    StarterWare 02.00.00.06 release Locked

    641 views
    7 replies
    Latest over 13 years ago
    by Mohsen Taheri
  • Not Answered

    BIOS calls that requires a Timer Does not work 0 Locked

    216 views
    0 replies
    Started over 13 years ago
    by elmaleh aaron
  • Not Answered

    JTAG ICEPICK registers configuration 0 Locked

    304 views
    1 reply
    Latest over 13 years ago
    by Brad Griffis
  • Not Answered

    Does DM3730 support 720p60 of real time H.264 video encode or decode? 0 Locked

    311 views
    1 reply
    Latest over 13 years ago
    by Brad Griffis
  • Not Answered

    Does AM1808 Support LCD overlay? 0 Locked

    208 views
    1 reply
    Latest over 13 years ago
    by Brad Griffis
  • Not Answered

    I2C0 on OMAPL138 0 Locked

    272 views
    2 replies
    Latest over 13 years ago
    by Brad Griffis
  • Not Answered

    Driver for JTAG 0 Locked

    153 views
    1 reply
    Latest over 13 years ago
    by Brad Griffis
  • Not Answered

    What is the efficient asm implementation of comparion, bit storage 0 Locked

    125 views
    1 reply
    Latest over 13 years ago
    by RandyP
  • Not Answered

    DM365 H264dec codec problem: first call of Vdec2_process will cause segmentation fault if you call Vdec2_delete and Vdec2_create again 0 Locked

    2001 views
    12 replies
    Latest over 13 years ago
    by KetanPatel
  • Answered

    Can starterware's USB stack support the USB host HUB? 0 Locked

    534 views
    4 replies
    Latest over 13 years ago
    by Yaoming Qin
  • Answered

    Using XDAIS on C6713 0 Locked

    271 views
    1 reply
    Latest over 13 years ago
    by Brad Griffis
  • Not Answered

    Informations about input Camera DM3730 0 Locked

    245 views
    2 replies
    Latest over 13 years ago
    by clkunde
<>