TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AM64X/ AM62X : How to Reset the SOC when WDT timer expires in AM64X and AM62X?

    Swargam Anil
    Swargam Anil
    Part Number: AM6442 Introduction: The primary application of a watchdog timer is as a system monitor to detect and reset an "out of control" SOC. When program execution goes wrong or software or devices are not functioning properly, the watchdog…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VH/AM62A: How to create the CAC mesh LUT for DCC tuning tool input?

    Gang Hua
    Gang Hua
    CAC in VPAC3-VISS or VPAC3L-VISS is very similar to LDC in VPAC. To prepare the CAC LUT for DCC tuning tool input, we may use similar matlab/octave script as LDC. You may refer to the LDC FAQ in the link below for more details. e2e.ti.com/.../faq-tda4vm…
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] DRA821: canTxstatus is busy even after Cancellation of Finished messages is set for respective Tx Buffer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4VM Hello, Customer has enabled AUTO retransmission of messages, and Using the CAN channel on TDA4x device to continuously send messages, and then remove other nodes on the CAN bus. Later it entered into Error passive state , and the…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] PROCESSOR-SDK-J784S4: How Do I Build Yocto Images and Packages for J7 Devices?

    Jared McArthur
    Jared McArthur
    Part Number: PROCESSOR-SDK-J784S4 Other Parts Discussed in Thread: DRA821 , DRA829 , TDA4VM , AM68 , AM69 , SK-AM68 , SK-AM69 How do I build the default yocto images and install new packages for J7 devices?
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM625-Q1 / AM625SIP : LFOSC usage in the processor

    Koichiro Tashiro
    Koichiro Tashiro
    Part Number: AM625 Other Parts Discussed in Thread: AM62D-Q1 , AM62P-Q1 , , AM62A7-Q1 , AM623 Hi, I have a question from my customer for LFOSC (external 32.668kHz). According to datasheet section 7.11.4.1 Input Clocks / Oscillators, it seems the clock…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM625-Q1 / AM625SIP / AM62L / AM62A7 / AM62A3 / AM62A1-Q1 / AM62D-Q1 / AM62P / AM62P-Q1 Custom board hardware design – EXTINTn pin pullup connection

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Hi TI Experts, I have the below queries regarding the use of EXTINTn pin. Termination recommendations when used. Termination recommendations when not used. Let me know your thoughts.
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM62A7 / AM62A7-Q1 / AM62A3 / AM62A3-Q1 / AM62A1-Q1 / AM62D-Q1 Custom board hardware design - FAQs related to Processor collaterals, functioning, peripherals, interface and Starter kit

    Lavanya M R
    Lavanya M R
    Other Parts Discussed in Thread: AM62D-Q1 , SK-AM62A-LP , AM62P , TMUX1308-Q1 , TPS65224-Q1 Hi Board designers, Refer FAQs listed below related to custom board design for AM62Ax and AM62D-Q1 processor families that could be used along with other available…
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM625, AM623, AM620-Q1, AM625-Q1, AM625SIP Custom board hardware design - FAQs related to Processor collaterals, functioning, peripherals, interface and Starter kit

    Lavanya M R
    Lavanya M R
    Other Parts Discussed in Thread: AM62D-Q1 , SK-AM62 , SK-AM62B-P1 , SK-AM62-LP , SK-AM62-SIP , SK-AM62B , AM62P , TMUX1308-Q1 , TPS65219 Hi Board designers, Refer FAQs listed below related to custom board design for AM62x processor family that could…
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM620-Q1 / AM625-Q1 Custom board hardware design – Collaterals to Get started

    Lavanya M R
    Lavanya M R
    Part Number: AM625-Q1 Other Parts Discussed in Thread: AM620-Q1 , AM625 , AM623 , , AM625SIP , AM62D-Q1 , TPS65219 , SK-AM62-LP , SK-AM62B-P1 , SYSCONFIG Hi TI Experts, Can you provide a List of collaterals that can be referred when starting a custom…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VL: How to resolve NETDEV WATCHDOG: transmit queue timed out issue in Linux (A72) in case of SBL optimized boot flow?

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VL How to resolve NETDEV WATCHDOG: transmit queue timed out issue in Linux (A72) in case of SBL optimized boot flow?
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198179 Discussions
  • Answered

    what does DNUM mean? 0 Locked

    1641 views
    1 reply
    Latest over 13 years ago
    by SRiva
  • Not Answered

    6678 packet accelerator with RX linked descriptors 0 Locked

    296 views
    0 replies
    Started over 13 years ago
    by SRiva
  • Not Answered

    How to configed the OV7620 for DM355? 0 Locked

    326 views
    2 replies
    Latest over 13 years ago
    by gary yang1
  • Not Answered

    new codec h264fhdvenc_01_10_02_06 failed to work normally on DM6467T 0 Locked

    142 views
    1 reply
    Latest over 13 years ago
    by JIAXIN XU
  • Not Answered

    mmc2 0 Locked

    413 views
    2 replies
    Latest over 13 years ago
    by Alexandre Puhl
  • Not Answered

    GPMC_WAIT questions (4) 0 Locked

    249 views
    1 reply
    Latest over 13 years ago
    by Chaitanya Vaddadi
  • Not Answered

    Unable to launch the TI debugger session(since Target connect option is disabled) 0 Locked

    187 views
    0 replies
    Started over 13 years ago
    by hemanth sivakumar
  • Answered

    OMAP 4430: Code Composer - Cannot read "Pressure Bit" Distrbution through trace 0 Locked

    407 views
    3 replies
    Latest over 13 years ago
    by Gina Glaser
  • Answered

    uart 1 problem 0 Locked

    1806 views
    13 replies
    Latest over 13 years ago
    by Gary Wu
  • Answered

    AM35x RGMII interface IO voltage 0 Locked

    1050 views
    1 reply
    Latest over 13 years ago
    by peaves
  • Answered

    DM8168 EZSDK booting output 0 Locked

    220 views
    1 reply
    Latest over 13 years ago
    by yuqing cai
  • Not Answered

    DM365 codec FAQs 0 Locked

    141 views
    1 reply
    Latest over 13 years ago
    by Mayank Agarwal
  • Not Answered

    Android GPS JNI implementation is missing 0 Locked

    362 views
    1 reply
    Latest over 13 years ago
    by Vishveshwar Bhat
  • Not Answered

    A whole pile of questions about OMX components 0 Locked

    561 views
    1 reply
    Latest over 13 years ago
    by Vimal Jain
  • Not Answered

    Fail to call Memory_contigAlloc() function and lead to segmentation fault 0 Locked

    196 views
    0 replies
    Started over 13 years ago
    by Rayn ying
  • Not Answered

    why does the ferrite beads be abnegated in hawkboard OMAP-L138EVM 0 Locked

    1392 views
    2 replies
    Latest over 13 years ago
    by xunliang ma
  • Answered

    Is there any difference in the support of 1080I60 in EZSDK5.03.1.15? 0 Locked

    224 views
    2 replies
    Latest over 13 years ago
    by echo yang
  • Not Answered

    PCIe access by multiCore 0 Locked

    548 views
    1 reply
    Latest over 13 years ago
    by Karthik Ramana Sankar
  • Not Answered

    PCIe API's for DM8168 EVM 0 Locked

    174 views
    1 reply
    Latest over 13 years ago
    by _Ralph_
  • Not Answered

    Drivers for DP83848I Dm8148 SDK 0 Locked

    540 views
    1 reply
    Latest over 13 years ago
    by Benoit Parrot
<>