TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DRA821: SPL BOOT without A72 SPL on J7200 on 10.1 SDK

    Gokul Praveen
    Gokul Praveen
    Part Number: DRA821 Tool/software: How to enable Falcon Boot Mode on J7200? Boot Flow: R5 SPL -> ATF -> OPTEE -> U-BOOT -> Kernel Regards Gokul
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198362 Discussions
  • Not Answered

    DM816x: Hardware Floating Point on the DSP? 0 Locked

    313 views
    3 replies
    Latest over 13 years ago
    by _Ralph_
  • Not Answered

    C6727 Boot Loader via I2C port 0 Locked

    368 views
    1 reply
    Latest over 13 years ago
    by Rahul Prabhu
  • Not Answered

    xdc dm6437 0 Locked

    182 views
    0 replies
    Started over 13 years ago
    by Junqing Zhao
  • Not Answered

    c6748 uart FIFO level 0 Locked

    574 views
    0 replies
    Started over 13 years ago
    by si cheng
  • Not Answered

    dm8168 spi help 0 Locked

    908 views
    5 replies
    Latest over 13 years ago
    by Jason Radtke
  • Not Answered

    MPEG-4/H.264 Basic profile Video Encoding / decoding libraries for DM642 Processr 0 Locked

    263 views
    0 replies
    Started over 13 years ago
    by Adeel Malik
  • Not Answered

    H264Encoder questions 0 Locked

    175 views
    0 replies
    Started over 13 years ago
    by yuanjun ren
  • Suggested Answer

    C5515 Standalone Bootloading 0 Locked

    333 views
    3 replies
    Latest over 13 years ago
    by Steve Tsang
  • Not Answered

    AM335x USB standard compliance 0 Locked

    441 views
    2 replies
    Latest over 13 years ago
    by -DK-
  • Not Answered

    C66x and uCLinux MCSDK 0 Locked

    1087 views
    5 replies
    Latest over 13 years ago
    by Rex Chang
  • Not Answered

    C542 CALLing to Different Section 0 Locked

    479 views
    7 replies
    Latest over 13 years ago
    by Archaeologist
  • Not Answered

    OMAPL138 / AIC3254 0 Locked

    189 views
    0 replies
    Started over 13 years ago
    by ldufrechou
  • Not Answered

    Acoustic Echo Canceller Help 0 Locked

    6114 views
    38 replies
    Latest over 13 years ago
    by RandyP
  • Not Answered

    Does OMX Capture component support interlaced input? 0 Locked

    765 views
    5 replies
    Latest over 13 years ago
    by echo yang
  • Not Answered

    Problem to get the messageQ samples to coexist with the EZSDK dm816x_hdvpss.xem3 slave. 0 Locked

    221 views
    0 replies
    Started over 13 years ago
    by Per-Ola Gustafsson
  • Answered

    .cmd File for OMAP L138 0 Locked

    1794 views
    5 replies
    Latest over 13 years ago
    by Sasha Slijepcevic
  • Not Answered

    how Y U V data is arranged in format OMX_TI_COLOR_FormatYUV420PackedSemiPlanar? 0 Locked

    293 views
    1 reply
    Latest over 13 years ago
    by _Ralph_
  • Not Answered

    Booting Linux with initramfs if the size of the compressed image > 16M 0 Locked

    550 views
    0 replies
    Started over 13 years ago
    by Rakesh B.K
  • Not Answered

    xdc cfg DM6437 0 Locked

    172 views
    0 replies
    Started over 13 years ago
    by Junqing Zhao
  • Not Answered

    Try to boot the uboot kernel ramdisk in the leopard board dm355 from sd card 0 Locked

    178 views
    0 replies
    Started over 13 years ago
    by venkata subramanian
<>