TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AM654x, AM652x : Data sheet Documentation (about timing) of the power sequencing

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM6548 Tool/software: Hi TI experts, On page 142 of the datasheet "AM654x, AM652x Sitara Processors Silicon Revision 2.1 datasheet (Rev. C)", Figure 6-4. Power-Up Sequencing using On Chip Power-on-reset (POR) has labels such as "Note…
    • Answered
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] AM6422: How to configure the PCIe align with the simulation results.?

    wang shu
    wang shu
    Part Number: AM6422 Tool/software: Hi, I am setting the PCIe configuration. We simulated the PCIe using the IBIS model of AM6422. Below picture is the configuration we could get best simulation results. We don't know how to set it in AM6422 software…
    • Answered
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM625-Q1 / AM625SIP: eMMC0_DAT0 not enabled pull up by ROM

    Tony Tang
    Tony Tang
    Part Number: AM625 Tool/software: #1. On my customer board using eMMC0 boot, did not pull up eMMC0_DAT0, occasionally can't boot up by Power On, but can boot up by warm reset or power cycle. #2. Add pull up on eMMC_DAT0, can boot up always so far…
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM62L / AM62A / AM62P / AM62D-Q1 / AM64x / AM243x Design Recommendations / Custom board hardware design - Data sheet Pin Attributes and Pin connectivity related queries

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM625 Tool/software: Hi TI Experts, I have the below query regarding the data sheet Pin attributes Pin attributes I have a number of IOs that are not used, is there a connection recommendation Is there a recommendation for the…
    • Answered
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM62L / AM62A / AM62P / AM62D-Q1 / AM64x / AM243x Design Recommendations / Custom board hardware design - Current Data sheet revision, updates, revision backup and usage notes

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM625 Other Parts Discussed in Thread: AM62D-Q1 , AM62P , AM62L Tool/software: Hi TI Experts, I have the below query Currently available data sheet revision How do i verify i am using the latest revision Is there a way i can receive…
    • Answered
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] SK-AM69: How to run GStreamer pipeline with RTSP source

    Fabiana Jaimes
    Fabiana Jaimes
    Part Number: SK-AM69 Tool/software: How to stream H.264 encoded streams from a RTSP compliant IP camera or via RTSP server running on remote PC using GStreamer?
    • Answered
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] AM5728: Build and Test Guide for AM57xx Driver Examples using CCS

    Karthikeyan S
    Karthikeyan S
    Part Number: AM5728 Tool/software: Hi, How can I build and test an AM57xx driver example Using CCS?
    • Answered
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] AM623: Can eMMC0 support DDR50 mode

    Tony Tang
    Tony Tang
    Part Number: AM623 Tool/software: Can MMC0 port support eMMC DDR50? In the datasheet, list only 3 modes for eMMC application. DDR50 in SD Card application but not for eMMC. Although list all features in TRM, but we was told follow datasheet…
    • Answered
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] How to flash u-boot to GPMC-NAND with USB-DFU on AM62x

    Hong Guan64
    Hong Guan64
    Part Number: AM625 Other Parts Discussed in Thread: SK-AM62-LP Tool/software: AM62x boot ROM supports booting from parallel GPMC NAND. From "5.4.9.1 GPMC NAND Bootloader Operation" in AM62x TRM "GPMC NAND boot only supports boot from ONFI 1.0 compatible…
    • Answered
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] SK-AM64B: What is the purpose of --operation=flash-phy-tuning-data ?

    Vaibhav Kumar
    Vaibhav Kumar
    Part Number: SK-AM64B Tool/software: Greetings All, In MCU PLUS SDK offering, across Sitara SoCs, one must have come across different configuration files. These configuration files are located inside the directory: MCU_PLUS_SDK_INSTALL_PATH\tools…
    • Answered
    • 8 months ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198371 Discussions
  • Not Answered

    I changed DM8168 daughter card surport SII9135 to TVP7002, i use VCRDK's vc_rdk's mcfw_demo to test the board. And the camera can capture datas, but the LCD always display a half of the camera captured datas 0 Locked

    338 views
    0 replies
    Started over 13 years ago
    by longfei Wu
  • Suggested Answer

    LPM ON/OFF fails 0 Locked

    808 views
    4 replies
    Latest over 13 years ago
    by Chris Ring
  • Not Answered

    DM3725 WEC7 BSP Questions 0 Locked

    325 views
    4 replies
    Latest over 13 years ago
    by DavidVescovi
  • Answered

    Where can I find the OMAP4460 IBIS 0 Locked

    276 views
    1 reply
    Latest over 13 years ago
    by Shaheen Saroor
  • Answered

    C6678 x IdleTask 0 Locked

    1950 views
    12 replies
    Latest over 13 years ago
    by weber de souza calixto
  • Answered

    RTA support 0 Locked

    383 views
    3 replies
    Latest over 13 years ago
    by judahvang
  • Discussion

    Stream_create() fails Locked

    271 views
    3 replies
    Latest over 13 years ago
    by judahvang
  • Not Answered

    How to play seperated video/audio es data with gstreamer using hardware decoding in DM814x? 0 Locked

    300 views
    1 reply
    Latest over 13 years ago
    by Roman Sedyshev
  • Not Answered

    EZSDK 5_04_00_11: system hangs up while running codec engine examples 0 Locked

    311 views
    1 reply
    Latest over 13 years ago
    by YaMike
  • Not Answered

    DM368 vbfe initialization 0 Locked

    338 views
    0 replies
    Started over 13 years ago
    by Natarajan Viswanathan
  • Not Answered

    fa 0 Locked

    130 views
    0 replies
    Started over 13 years ago
    by Natarajan Viswanathan
  • Not Answered

    Question about gstreamer v4l2sink in DM814x 0 Locked

    224 views
    0 replies
    Started over 13 years ago
    by kim minsoon
  • Not Answered

    [DM8168]How to indicate the HDVICP ID when create VDEC component 0 Locked

    234 views
    0 replies
    Started over 13 years ago
    by Eric Mao
  • Not Answered

    ezsdk_5_03_01_15 MultiChannel decoder, VIDDEC3_Create can't return 0 Locked

    230 views
    0 replies
    Started over 13 years ago
    by Eric Mao
  • Answered

    Power-saving routines in L138 starterware? 0 Locked

    338 views
    2 replies
    Latest over 13 years ago
    by Paul Singh
  • Not Answered

    CODEC_DEBUG_ENABLE: inBuf elements were not set correctly 0 Locked

    267 views
    3 replies
    Latest over 13 years ago
    by Tenggui Fu
  • Not Answered

    Controlling Brightness, Contrast and other display properties on 816x 0 Locked

    211 views
    0 replies
    Started over 13 years ago
    by Amol Natekar
  • Answered

    Missing document SPRUEC7 0 Locked

    254 views
    4 replies
    Latest over 13 years ago
    by turboscrew
  • Not Answered

    Error while loading Sylink.ko on Ti816x evm 0 Locked

    296 views
    0 replies
    Started over 13 years ago
    by rakesh sasanapuri
  • Not Answered

    Cable to connect two Zoom EVM6748 kits 0 Locked

    235 views
    2 replies
    Latest over 13 years ago
    by ReinierC
<>