TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AM64X/ AM62X : How to Reset the SOC when WDT timer expires in AM64X and AM62X?

    Swargam Anil
    Swargam Anil
    Part Number: AM6442 Introduction: The primary application of a watchdog timer is as a system monitor to detect and reset an "out of control" SOC. When program execution goes wrong or software or devices are not functioning properly, the watchdog…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VH/AM62A: How to create the CAC mesh LUT for DCC tuning tool input?

    Gang Hua
    Gang Hua
    CAC in VPAC3-VISS or VPAC3L-VISS is very similar to LDC in VPAC. To prepare the CAC LUT for DCC tuning tool input, we may use similar matlab/octave script as LDC. You may refer to the LDC FAQ in the link below for more details. e2e.ti.com/.../faq-tda4vm…
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] DRA821: canTxstatus is busy even after Cancellation of Finished messages is set for respective Tx Buffer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4VM Hello, Customer has enabled AUTO retransmission of messages, and Using the CAN channel on TDA4x device to continuously send messages, and then remove other nodes on the CAN bus. Later it entered into Error passive state , and the…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] PROCESSOR-SDK-J784S4: How Do I Build Yocto Images and Packages for J7 Devices?

    Jared McArthur
    Jared McArthur
    Part Number: PROCESSOR-SDK-J784S4 Other Parts Discussed in Thread: DRA821 , DRA829 , TDA4VM , AM68 , AM69 , SK-AM68 , SK-AM69 How do I build the default yocto images and install new packages for J7 devices?
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM625-Q1 / AM625SIP : LFOSC usage in the processor

    Koichiro Tashiro
    Koichiro Tashiro
    Part Number: AM625 Other Parts Discussed in Thread: AM62D-Q1 , AM62P-Q1 , , AM62A7-Q1 , AM623 Hi, I have a question from my customer for LFOSC (external 32.668kHz). According to datasheet section 7.11.4.1 Input Clocks / Oscillators, it seems the clock…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM625-Q1 / AM625SIP / AM62L / AM62A7 / AM62A3 / AM62A1-Q1 / AM62D-Q1 / AM62P / AM62P-Q1 Custom board hardware design – EXTINTn pin pullup connection

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Hi TI Experts, I have the below queries regarding the use of EXTINTn pin. Termination recommendations when used. Termination recommendations when not used. Let me know your thoughts.
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM62A7 / AM62A7-Q1 / AM62A3 / AM62A3-Q1 / AM62A1-Q1 / AM62D-Q1 Custom board hardware design - FAQs related to Processor collaterals, functioning, peripherals, interface and Starter kit

    Lavanya M R
    Lavanya M R
    Other Parts Discussed in Thread: AM62D-Q1 , SK-AM62A-LP , AM62P , TMUX1308-Q1 , TPS65224-Q1 Hi Board designers, Refer FAQs listed below related to custom board design for AM62Ax and AM62D-Q1 processor families that could be used along with other available…
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM625, AM623, AM620-Q1, AM625-Q1, AM625SIP Custom board hardware design - FAQs related to Processor collaterals, functioning, peripherals, interface and Starter kit

    Lavanya M R
    Lavanya M R
    Other Parts Discussed in Thread: AM62D-Q1 , SK-AM62 , SK-AM62B-P1 , SK-AM62-LP , SK-AM62-SIP , SK-AM62B , AM62P , TMUX1308-Q1 , TPS65219 Hi Board designers, Refer FAQs listed below related to custom board design for AM62x processor family that could…
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM620-Q1 / AM625-Q1 Custom board hardware design – Collaterals to Get started

    Lavanya M R
    Lavanya M R
    Part Number: AM625-Q1 Other Parts Discussed in Thread: AM620-Q1 , AM625 , AM623 , , AM625SIP , AM62D-Q1 , TPS65219 , SK-AM62-LP , SK-AM62B-P1 , SYSCONFIG Hi TI Experts, Can you provide a List of collaterals that can be referred when starting a custom…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VL: How to resolve NETDEV WATCHDOG: transmit queue timed out issue in Linux (A72) in case of SBL optimized boot flow?

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VL How to resolve NETDEV WATCHDOG: transmit queue timed out issue in Linux (A72) in case of SBL optimized boot flow?
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198213 Discussions
  • Not Answered

    TMDXEVM6678 - PCIe Linux Drivers? 0 Locked

    335 views
    1 reply
    Latest over 13 years ago
    by Rex Chang
  • Answered

    Corruption in interdependent QDMA linked transfers 0 Locked

    496 views
    4 replies
    Latest over 13 years ago
    by RandyP
  • Not Answered

    Checking onvif in V3 software 0 Locked

    412 views
    4 replies
    Latest over 13 years ago
    by Raghu Kudva
  • Answered

    StarterWare 0 Locked

    1366 views
    16 replies
    Latest over 13 years ago
    by Keldy
  • Not Answered

    DM368 IPNC GBasic Error? 0 Locked

    341 views
    1 reply
    Latest over 13 years ago
    by Raghu Kudva
  • Not Answered

    AM3352 PCB layout guide lines 0 Locked

    384 views
    0 replies
    Started over 13 years ago
    by Pradeep Bhutada
  • Not Answered

    AM3352 RE (Radiated Emission) and RI (Radiated Emunity) result for OPP50 0 Locked

    293 views
    0 replies
    Started over 13 years ago
    by Pradeep Bhutada
  • Not Answered

    TCA 8418 0 Locked

    323 views
    0 replies
    Started over 13 years ago
    by AVINASH NEETHI
  • Answered

    Concerto - C28x timer priority 0 Locked

    332 views
    5 replies
    Latest over 13 years ago
    by HRi
  • Not Answered

    C66X PCIe boot example 0 Locked

    384 views
    3 replies
    Latest over 13 years ago
    by ArunMani
  • Not Answered

    SPI OMAP-L138 0 Locked

    249 views
    1 reply
    Latest over 13 years ago
    by Rahul Prabhu
  • Answered

    C6678 Nand and Nor Flash 0 Locked

    501 views
    1 reply
    Latest over 13 years ago
    by ArunMani
  • Answered

    Is C6accel really fast? 0 Locked

    355 views
    2 replies
    Latest over 13 years ago
    by Rahul Prabhu
  • Not Answered

    ROM Ethernet Boot and big-endian 0 Locked

    493 views
    3 replies
    Latest over 13 years ago
    by ArunMani
  • Answered

    Heap Create, Delete, Open, Close 0 Locked

    432 views
    2 replies
    Latest over 13 years ago
    by RCReddy
  • Not Answered

    How to modify mcsdk_video demo for running it on another 4XC6678 platform? 0 Locked

    502 views
    8 replies
    Latest over 13 years ago
    by Vivek Chengalvala
  • Not Answered

    How to debug mcsdk_video demo sv01 on our evm6678l ? 0 Locked

    437 views
    4 replies
    Latest over 13 years ago
    by Vivek Chengalvala
  • Not Answered

    why can we ignore PKTIO IF Config for PA in mcsdk-video demo? 0 Locked

    368 views
    3 replies
    Latest over 13 years ago
    by Vivek Chengalvala
  • Not Answered

    write boot-image to NOR on custom board 0 Locked

    405 views
    4 replies
    Latest over 13 years ago
    by Steve Tsang
  • Not Answered

    DM365 JPEG decoder problem 0 Locked

    994 views
    9 replies
    Latest over 13 years ago
    by Rohan Babtiwale
<>