TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AM64X/ AM62X : How to Reset the SOC when WDT timer expires in AM64X and AM62X?

    Swargam Anil
    Swargam Anil
    Part Number: AM6442 Introduction: The primary application of a watchdog timer is as a system monitor to detect and reset an "out of control" SOC. When program execution goes wrong or software or devices are not functioning properly, the watchdog…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VH/AM62A: How to create the CAC mesh LUT for DCC tuning tool input?

    Gang Hua
    Gang Hua
    CAC in VPAC3-VISS or VPAC3L-VISS is very similar to LDC in VPAC. To prepare the CAC LUT for DCC tuning tool input, we may use similar matlab/octave script as LDC. You may refer to the LDC FAQ in the link below for more details. e2e.ti.com/.../faq-tda4vm…
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] DRA821: canTxstatus is busy even after Cancellation of Finished messages is set for respective Tx Buffer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4VM Hello, Customer has enabled AUTO retransmission of messages, and Using the CAN channel on TDA4x device to continuously send messages, and then remove other nodes on the CAN bus. Later it entered into Error passive state , and the…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] PROCESSOR-SDK-J784S4: How Do I Build Yocto Images and Packages for J7 Devices?

    Jared McArthur
    Jared McArthur
    Part Number: PROCESSOR-SDK-J784S4 Other Parts Discussed in Thread: DRA821 , DRA829 , TDA4VM , AM68 , AM69 , SK-AM68 , SK-AM69 How do I build the default yocto images and install new packages for J7 devices?
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM625-Q1 / AM625SIP : LFOSC usage in the processor

    Koichiro Tashiro
    Koichiro Tashiro
    Part Number: AM625 Other Parts Discussed in Thread: AM62D-Q1 , AM62P-Q1 , , AM62A7-Q1 , AM623 Hi, I have a question from my customer for LFOSC (external 32.668kHz). According to datasheet section 7.11.4.1 Input Clocks / Oscillators, it seems the clock…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM625-Q1 / AM625SIP / AM62L / AM62A7 / AM62A3 / AM62A1-Q1 / AM62D-Q1 / AM62P / AM62P-Q1 Custom board hardware design – EXTINTn pin pullup connection

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Hi TI Experts, I have the below queries regarding the use of EXTINTn pin. Termination recommendations when used. Termination recommendations when not used. Let me know your thoughts.
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM62A7 / AM62A7-Q1 / AM62A3 / AM62A3-Q1 / AM62A1-Q1 / AM62D-Q1 Custom board hardware design - FAQs related to Processor collaterals, functioning, peripherals, interface and Starter kit

    Lavanya M R
    Lavanya M R
    Other Parts Discussed in Thread: AM62D-Q1 , SK-AM62A-LP , AM62P , TMUX1308-Q1 , TPS65224-Q1 Hi Board designers, Refer FAQs listed below related to custom board design for AM62Ax and AM62D-Q1 processor families that could be used along with other available…
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM625, AM623, AM620-Q1, AM625-Q1, AM625SIP Custom board hardware design - FAQs related to Processor collaterals, functioning, peripherals, interface and Starter kit

    Lavanya M R
    Lavanya M R
    Other Parts Discussed in Thread: AM62D-Q1 , SK-AM62 , SK-AM62B-P1 , SK-AM62-LP , SK-AM62-SIP , SK-AM62B , AM62P , TMUX1308-Q1 , TPS65219 Hi Board designers, Refer FAQs listed below related to custom board design for AM62x processor family that could…
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM620-Q1 / AM625-Q1 Custom board hardware design – Collaterals to Get started

    Lavanya M R
    Lavanya M R
    Part Number: AM625-Q1 Other Parts Discussed in Thread: AM620-Q1 , AM625 , AM623 , , AM625SIP , AM62D-Q1 , TPS65219 , SK-AM62-LP , SK-AM62B-P1 , SYSCONFIG Hi TI Experts, Can you provide a List of collaterals that can be referred when starting a custom…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VL: How to resolve NETDEV WATCHDOG: transmit queue timed out issue in Linux (A72) in case of SBL optimized boot flow?

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VL How to resolve NETDEV WATCHDOG: transmit queue timed out issue in Linux (A72) in case of SBL optimized boot flow?
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198160 Discussions
  • Answered

    Configure PHY using NDK interfaces 0 Locked

    541 views
    2 replies
    Latest over 13 years ago
    by Jeremy Sarao
  • Not Answered

    DM8168 Linux kernel memory utilization 0 Locked

    223 views
    2 replies
    Latest over 13 years ago
    by Scott Park
  • Answered

    regarding Smartreflex 0 Locked

    143 views
    1 reply
    Latest over 13 years ago
    by one and zero
  • Not Answered

    symbol referencing error 0 Locked

    119 views
    0 replies
    Started over 13 years ago
    by sachin kalkur
  • Suggested Answer

    BSP_WINCE_ARM_A8_02_30_00 for Beagleboard xM, Hang on kernel initial phase with Persistent Hive Registry Storage enabled 0 Locked

    1796 views
    7 replies
    Latest over 13 years ago
    by weidong zhou
  • Not Answered

    [MIDAS 2.0]: MIDAS build failure 0 Locked

    519 views
    5 replies
    Latest over 13 years ago
    by Honey Sukesan
  • Answered

    Core0 is not in Suspended state upon launch 0 Locked

    2848 views
    20 replies
    Latest over 13 years ago
    by David Friedland
  • Discussion

    EDMA3LLD 02.11.04.01 release is now available Locked

    114 views
    1 reply
    Latest over 13 years ago
    by Thomas S
  • Not Answered

    am3517 pwm 0 Locked

    228 views
    0 replies
    Started over 13 years ago
    by HONGSEN LI
  • Answered

    GPGPU on OMAP3530 without framebuffer 0 Locked

    1525 views
    8 replies
    Latest over 13 years ago
    by Prathap Srinivas
  • Not Answered

    Older version of Sitara Linux SDK 0 Locked

    431 views
    1 reply
    Latest over 13 years ago
    by Anil
  • Answered

    Why my OMAP4430SDP-tablet with L27.IS.1 boot up in safe mode 0 Locked

    287 views
    2 replies
    Latest over 13 years ago
    by Leo Du
  • Not Answered

    How to include external library during build DVSDK_4_02_00_06 ? 0 Locked

    191 views
    0 replies
    Started over 13 years ago
    by oded almog
  • Not Answered

    separating the splash image from the U-Boot(AM3517) 0 Locked

    396 views
    1 reply
    Latest over 13 years ago
    by clkunde
  • Not Answered

    AM3703 camera sample program 0 Locked

    297 views
    1 reply
    Latest over 13 years ago
    by Vaibhav Hiremath
  • Not Answered

    TMDXEVM8148 LCD image offset 0 Locked

    623 views
    4 replies
    Latest over 13 years ago
    by Jeppe Ledet-Pedersen
  • Answered

    Does DM8168 support debug trace points 0 Locked

    212 views
    1 reply
    Latest over 13 years ago
    by HardikShah
  • Answered

    RGB video capture and YUV encoding of DM814x? 0 Locked

    1360 views
    5 replies
    Latest over 13 years ago
    by HardikShah
  • Not Answered

    Timming and format for mvSADout 0 Locked

    289 views
    3 replies
    Latest over 13 years ago
    by Veeranna Hanchinal
  • Answered

    USB error USBD_STATUS_BUFFER_UNDERRUN (0xc000000d) 0 Locked

    819 views
    3 replies
    Latest over 13 years ago
    by Long Ngoc
<>