TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DRA821: SPL BOOT without A72 SPL on J7200 on 10.1 SDK

    Gokul Praveen
    Gokul Praveen
    Part Number: DRA821 Tool/software: How to enable Falcon Boot Mode on J7200? Boot Flow: R5 SPL -> ATF -> OPTEE -> U-BOOT -> Kernel Regards Gokul
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 197749 Discussions
  • Answered

    Problem Outputting Video to Component on Leopardboard DM365 0 Locked

    688 views
    4 replies
    Latest over 13 years ago
    by Chuck@Cimarron Systems
  • Not Answered

    question about vip port1 0 Locked

    170 views
    0 replies
    Started over 13 years ago
    by puyol jiang
  • Not Answered

    omap 3530 mcbsp clock 0 Locked

    216 views
    0 replies
    Started over 13 years ago
    by Eswar
  • Answered

    MIPI-DSI Graphics Data Seems Missing 0 Locked

    493 views
    1 reply
    Latest over 13 years ago
    by Chris Read
  • Not Answered

    Real-time audio issues on OMAP L138 (C6748 DSP) 0 Locked

    168 views
    0 replies
    Started over 13 years ago
    by Francesco Faccenda
  • Not Answered

    WinCE License File for OMAP35x bsp 0 Locked

    176 views
    0 replies
    Started over 13 years ago
    by Paul Joseph
  • Answered

    Android 4.0 support for the 2 decoders instances on the omap4 0 Locked

    418 views
    2 replies
    Latest over 13 years ago
    by Lajos Molnar
  • Not Answered

    Sleep mode for TMS320VC5505 eZdsp usbkit. 0 Locked

    197 views
    0 replies
    Started over 13 years ago
    by Ali Imtiaz
  • Answered

    Interfacing C6414/C6416 to AT91SAM9G54 ARM 0 Locked

    1553 views
    9 replies
    Latest over 13 years ago
    by Sam Kuzbary
  • Not Answered

    Reducing cycles for memcmp 0 Locked

    530 views
    1 reply
    Latest over 13 years ago
    by Alberto Chessa
  • Answered

    TEVM4460 Blaze Tablet screen capture from framebuffer issue 0 Locked

    870 views
    5 replies
    Latest over 13 years ago
    by Magdalena Iovescu
  • Not Answered

    Output 25Mhz RMII1_REFCLK 0 Locked

    1987 views
    8 replies
    Latest over 13 years ago
    by Anil
  • Not Answered

    TMDSIPCAM8127J3 software 0 Locked

    333 views
    1 reply
    Latest over 13 years ago
    by Raghu Kudva
  • Not Answered

    About DM8127 IPNC RTC connection 0 Locked

    397 views
    1 reply
    Latest over 13 years ago
    by Appro Support Team
  • Not Answered

    DM814x Processor capability 0 Locked

    277 views
    3 replies
    Latest over 13 years ago
    by K Md Feroz Irfan
  • Not Answered

    dm368 facedetector 0 Locked

    214 views
    1 reply
    Latest over 13 years ago
    by Raghu Kudva
  • Not Answered

    H264enc with interlaced content 0 Locked

    223 views
    0 replies
    Started over 13 years ago
    by zhang cheng
  • Not Answered

    DM8165 Power calculation 0 Locked

    340 views
    1 reply
    Latest over 13 years ago
    by K Md Feroz Irfan
  • Not Answered

    How to get the Appro DM368 IPNC V3.0 version sdk? 0 Locked

    712 views
    1 reply
    Latest over 13 years ago
    by Raghu Kudva
  • Answered

    why can not control gpio 88 0 Locked

    312 views
    1 reply
    Latest over 13 years ago
    by Anil
<>