TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DRA821: SPL BOOT without A72 SPL on J7200 on 10.1 SDK

    Gokul Praveen
    Gokul Praveen
    Part Number: DRA821 Tool/software: How to enable Falcon Boot Mode on J7200? Boot Flow: R5 SPL -> ATF -> OPTEE -> U-BOOT -> Kernel Regards Gokul
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 197711 Discussions
  • Not Answered

    how to remove the HDMI loopback display component from capture_encode? 0 Locked

    267 views
    0 replies
    Started over 13 years ago
    by B V Srikanth Reddy
  • Not Answered

    DDR3 Placement for Keystone DSP C667x 0 Locked

    753 views
    9 replies
    Latest over 13 years ago
    by NK49690
  • Not Answered

    TMS320C6455 McBSP audio transfer 0 Locked

    246 views
    1 reply
    Latest over 13 years ago
    by RandyP
  • Not Answered

    What is the correct steps to setup video display port in DM6467? 0 Locked

    203 views
    0 replies
    Started over 13 years ago
    by jim xu
  • Discussion

    Can I send you the project? Locked

    128 views
    1 reply
    Latest over 13 years ago
    by David Friedland
  • Not Answered

    how to view output of sine wave program in graph? 0 Locked

    567 views
    5 replies
    Latest over 13 years ago
    by RandyP
  • Answered

    Configuring the properties of (default/generated) SYS/BIOS LoggerBuf Instances 0 Locked

    1069 views
    1 reply
    Latest over 13 years ago
    by Steven Connell
  • Answered

    AM335x SPL (MLO) 0 Locked

    5467 views
    4 replies
    Latest over 13 years ago
    by Gururaja Hebbar
  • Not Answered

    creation of new server that contains both the encoders 0 Locked

    137 views
    0 replies
    Started over 13 years ago
    by Abhijit Dalvi
  • Answered

    Have problem use Android4.0 on PandaBoard 0 Locked

    583 views
    4 replies
    Latest over 13 years ago
    by Israel Cepeda
  • Not Answered

    DM8148, what to do with DEVOSC_WAKE pin? 0 Locked

    470 views
    4 replies
    Latest over 13 years ago
    by Adam Gray
  • Answered

    how to configure gpio HWI by 643x 0 Locked

    347 views
    5 replies
    Latest over 13 years ago
    by Brad Griffis
  • Not Answered

    VCP2 sharing in multicore processor TI's 6487 0 Locked

    308 views
    0 replies
    Started over 13 years ago
    by Manish Aggarwal
  • Not Answered

    firmware code protection on a C5515 DSP using external SPI EEPROM ? 0 Locked

    2768 views
    11 replies
    Latest over 13 years ago
    by Martin S.
  • Answered

    Is it possible to call processAsync from an algorithm that is considered local? 0 Locked

    279 views
    2 replies
    Latest over 13 years ago
    by Luis Fernando Arce Mora
  • Not Answered

    Why C6EZ tool is removed from DM8168 EZSDK 5.03 ? 0 Locked

    402 views
    5 replies
    Latest over 13 years ago
    by std
  • Not Answered

    Fast External Booting Jump Address on AM335x 0 Locked

    222 views
    0 replies
    Started over 13 years ago
    by Motoyasu Hattori
  • Answered

    wlan is not working on Blaze 0 Locked

    390 views
    1 reply
    Latest over 13 years ago
    by Alex Trinh
  • Discussion

    ICS building error with Panda 4430 Locked

    464 views
    3 replies
    Latest over 13 years ago
    by shubham patni
  • Answered

    PRU and GPIO 0 Locked

    957 views
    4 replies
    Latest over 13 years ago
    by Fernando Gomes
<>