TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AM625: MMC0 PCB Connectivity Requirements

    reto hermann
    reto hermann
    Part Number: AM625 Tool/software: Hi we have issues with an eMMC connected to MMC0 of a AM6254 processor on a custom board. In the datasheet of the AM625 processors we found layout requirements for the MMC0 interface. Does this "min" specification…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] PROCESSOR-SDK-AM64X: How to enable RTOS based PCIE-PTM

    Ashwani Goel
    Ashwani Goel
    Part Number: PROCESSOR-SDK-AM64X Other Parts Discussed in Thread: TMDS243EVM Tool/software: Hi TI Expert, How can we use AM64x/ AM243x - MCU+SDK to enable PCIE based Precision Time Measurement (PTM) ? Regards
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] How do I build the native IgH EtherCAT stack for TI microprocessors?

    Jared McArthur
    Jared McArthur
    Part Number: AM62 Tool/software: The IgH EtherCAT stack is an open source EtherCAT stack. It comes with a generic driver that uses generic Linux ethernet API calls, but is not optimized for specific platforms, and therefore comes with latency. …
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM: How to run ETHFW without connecting GESI card to J721EXCPXEVM for TDA4VM/J721E?

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM Other Parts Discussed in Thread: J721EXCPXEVM , Tool/software: How to run ETHFW without connecting GESI card to J721EXCPXEVM for TDA4VM/J721E? When using TI SDK ETHFW was failed to load.
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM620-Q1: Connect SRAM to GPMC

    FM
    FM
    Part Number: AM620-Q1 Tool/software: Hi TI Team, I would like to avoid LPDDR4 memory because of cost. Is it possible to connect a standard 16-bit SRAM to the GPMC? Can you recommend any p/n? What is the maximum addressing size? Voltage…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM6421: How many reflow is acceptable at new package ANI?

    Tsurumoto
    Tsurumoto
    Part Number: AM6421 Tool/software: Hi To decide if customer use AM6421 for their new product or not, they need the information about how many reflow is acceptable at new package ANI. What's the limit number of reflow of AM6421BSEFHIANIR?
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TLV62585: Input voltage vs Output voltage - AM64x AM62x Discrete power architecture

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: TLV62585 Tool/software: Hi Experts, I am reviewing a customer schematic. Customer is using TLV62585DRLR the input is 4.2V and could be switched to 3V. The output is 3.3V. Do you have any concern with the TLV62585DRLR providing…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] How to flash and boot Linux from NAND with AM335x Linux SDK 9.1

    Hong Guan64
    Hong Guan64
    Part Number: AM3358 Tool/software: AM335x GPMC-NAND boot issue was observed with AM335x Linux SDK 9.1 [1]. The FAQ lists the u-boot and kernel patches to support flashing and booting u-boot/kernel/root_fs with AM335x Linux SDK 9.1 from GPMC-NAND on…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] : Reset Module on AM64X / AM243/AM62X SOC's

    Swargam Anil
    Swargam Anil
    Part Number: AM6442 Tool/software: In AM64X/AM243/AM62X there are many Resets. So, what is the difference between each type of Reset? What is the boot flow for each Reset ? What are the Registers/Peripherals affected for each Reset ? How different…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] J784S4XEVM: How to create EXT4 rootfs on UFS and boot to Linux using UFS

    Keerthy J
    Keerthy J
    Part Number: J784S4XEVM Tool/software: UFS is present on the J784S4EVM. How can one use it instead of eMMC to host rootfs and use that to boot to Linux command prompt.
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198583 Discussions
  • Not Answered

    2D Graphics (SWOSD) for the DM8127 IPNC RDK 0 Locked

    1028 views
    3 replies
    Latest over 13 years ago
    by Allen Black
  • Answered

    How to rebuild libraries that come with the MCSDK like the pdk etc for CCSv5.1 0 Locked

    360 views
    2 replies
    Latest over 13 years ago
    by Aamir Husain
  • Not Answered

    How can I fix this error? 0 Locked

    567 views
    5 replies
    Latest over 13 years ago
    by Archaeologist
  • Not Answered

    Using sections from linker cmd 0 Locked

    258 views
    1 reply
    Latest over 13 years ago
    by Uday
  • Suggested Answer

    USB interface with DM3730 from LAN9514 0 Locked

    543 views
    1 reply
    Latest over 13 years ago
    by BrandonAzbell
  • Answered

    Trouble connecting with the DSP of TI DM8148 0 Locked

    681 views
    6 replies
    Latest over 13 years ago
    by Abhishek Singh Sisodia
  • Answered

    why can not use two vfcc component? 0 Locked

    422 views
    4 replies
    Latest over 13 years ago
    by george jiang
  • Not Answered

    Unable to affect GPIO lines via Linux 0 Locked

    158 views
    0 replies
    Started over 13 years ago
    by Mark Jackson99390
  • Not Answered

    Problem In Porting G711.1 On EVM DM6437 0 Locked

    279 views
    1 reply
    Latest over 13 years ago
    by RandyP
  • Answered

    It puzzled me that build a multi-core development environment about C6x 0 Locked

    648 views
    1 reply
    Latest over 13 years ago
    by Rex Chang
  • Answered

    overlay validity 0 Locked

    190 views
    1 reply
    Latest over 13 years ago
    by Matthew Kiser
  • Answered

    C5505 - SPI chip select glitch 0 Locked

    388 views
    2 replies
    Latest over 13 years ago
    by Todd Anderson78572
  • Not Answered

    Grab screen of OMAP3530 0 Locked

    164 views
    0 replies
    Started over 13 years ago
    by chao yin
  • Not Answered

    DM816x: PCIe io space mapping support problem 0 Locked

    192 views
    0 replies
    Started over 13 years ago
    by jason lee
  • Answered

    OMAP3 DSP Control GPIO 0 Locked

    2413 views
    12 replies
    Latest over 13 years ago
    by Brad Griffis
  • Not Answered

    How to create an intermediary frame for image processing on EVM DM648 with preview-demo 0 Locked

    468 views
    3 replies
    Latest over 13 years ago
    by Maxime GUYON
  • Not Answered

    VSRC on A8 0 Locked

    295 views
    1 reply
    Latest over 13 years ago
    by Dongfeng.Judah
  • Answered

    Is the latest version of the dependency component compatible with which specified in the release note? 0 Locked

    333 views
    3 replies
    Latest over 13 years ago
    by Hongmei Gou
  • Answered

    how to compile C program for c6x-linux? 0 Locked

    503 views
    2 replies
    Latest over 13 years ago
    by Rex Chang
  • Answered

    two different MSGQ_alloc() have two different parameter orders 0 Locked

    530 views
    3 replies
    Latest over 13 years ago
    by ToddMullanix
<>