TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DRA821: SPL BOOT without A72 SPL on J7200 on 10.1 SDK

    Gokul Praveen
    Gokul Praveen
    Part Number: DRA821 Tool/software: How to enable Falcon Boot Mode on J7200? Boot Flow: R5 SPL -> ATF -> OPTEE -> U-BOOT -> Kernel Regards Gokul
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 197743 Discussions
  • Answered

    AM1808 SDIO IRQ Errata 0 Locked

    390 views
    1 reply
    Latest over 14 years ago
    by Miguel A. Alanis
  • Not Answered

    5515 DMA for 16bit A/D converter 0 Locked

    154 views
    1 reply
    Latest over 14 years ago
    by Wen Li
  • Not Answered

    Noise from surroundings in DSP 0 Locked

    239 views
    1 reply
    Latest over 14 years ago
    by Wen Li
  • Not Answered

    SRIO, and response Msg Ftype13 0 Locked

    1574 views
    3 replies
    Latest over 14 years ago
    by tscheck
  • Not Answered

    Noise problem in C5505 ECG 0 Locked

    322 views
    4 replies
    Latest over 14 years ago
    by Wen Li
  • Answered

    AIF SerDes Clocking 0 Locked

    250 views
    1 reply
    Latest over 14 years ago
    by Yogesh CS
  • Answered

    PLL Config on C5505 (.gel File) 0 Locked

    1048 views
    7 replies
    Latest over 14 years ago
    by Wen Li
  • Not Answered

    OMAP L138 Soft Reset 0 Locked

    1515 views
    5 replies
    Latest over 14 years ago
    by Brad Griffis
  • Not Answered

    SystemMMU 0 Locked

    1295 views
    13 replies
    Latest over 14 years ago
    by Brad Griffis
  • Answered

    Bootloader issues in C6713 0 Locked

    266 views
    1 reply
    Latest over 14 years ago
    by Brad Griffis
  • Answered

    Applying signal voltages to C6746 I/O pins before CVDD has been fully powered-up 0 Locked

    303 views
    1 reply
    Latest over 14 years ago
    by Brad Griffis
  • Answered

    Ethernet configuration for TM320C6748 DSP 0 Locked

    393 views
    1 reply
    Latest over 14 years ago
    by Muhammad Haque
  • Answered

    Looking for an EVM with ADC 0 Locked

    244 views
    7 replies
    Latest over 14 years ago
    by Joseph CJ
  • Answered

    Endianness: emulator won't load 'Invalid endianness' 0 Locked

    452 views
    4 replies
    Latest over 14 years ago
    by Aditya
  • Answered

    Emulation Debug Boot 0 Locked

    236 views
    2 replies
    Latest over 14 years ago
    by Igor Reyzin
  • Not Answered

    am3517 ddr2 timing 0 Locked

    242 views
    1 reply
    Latest over 14 years ago
    by Jeff Culverhouse
  • Not Answered

    am3517 Lpddr timing for clk and DQS 0 Locked

    311 views
    1 reply
    Latest over 14 years ago
    by Jeff Culverhouse
  • Answered

    getsockopt and setsockopt not working properly 0 Locked

    2028 views
    3 replies
    Latest over 14 years ago
    by Steven Connell
  • Discussion

    SPI EDMA Timings Locked

    2151 views
    18 replies
    Latest over 14 years ago
    by David Friedland
  • Not Answered

    setting DSP clock speed for DM3730 EVM 0 Locked

    328 views
    0 replies
    Started over 14 years ago
    by Jonathan Hunter
<>