TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AM625: MMC0 PCB Connectivity Requirements

    reto hermann
    reto hermann
    Part Number: AM625 Tool/software: Hi we have issues with an eMMC connected to MMC0 of a AM6254 processor on a custom board. In the datasheet of the AM625 processors we found layout requirements for the MMC0 interface. Does this "min" specification…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] PROCESSOR-SDK-AM64X: How to enable RTOS based PCIE-PTM

    Ashwani Goel
    Ashwani Goel
    Part Number: PROCESSOR-SDK-AM64X Other Parts Discussed in Thread: TMDS243EVM Tool/software: Hi TI Expert, How can we use AM64x/ AM243x - MCU+SDK to enable PCIE based Precision Time Measurement (PTM) ? Regards
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] How do I build the native IgH EtherCAT stack for TI microprocessors?

    Jared McArthur
    Jared McArthur
    Part Number: AM62 Tool/software: The IgH EtherCAT stack is an open source EtherCAT stack. It comes with a generic driver that uses generic Linux ethernet API calls, but is not optimized for specific platforms, and therefore comes with latency. …
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM: How to run ETHFW without connecting GESI card to J721EXCPXEVM for TDA4VM/J721E?

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM Other Parts Discussed in Thread: J721EXCPXEVM , Tool/software: How to run ETHFW without connecting GESI card to J721EXCPXEVM for TDA4VM/J721E? When using TI SDK ETHFW was failed to load.
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM620-Q1: Connect SRAM to GPMC

    FM
    FM
    Part Number: AM620-Q1 Tool/software: Hi TI Team, I would like to avoid LPDDR4 memory because of cost. Is it possible to connect a standard 16-bit SRAM to the GPMC? Can you recommend any p/n? What is the maximum addressing size? Voltage…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM6421: How many reflow is acceptable at new package ANI?

    Tsurumoto
    Tsurumoto
    Part Number: AM6421 Tool/software: Hi To decide if customer use AM6421 for their new product or not, they need the information about how many reflow is acceptable at new package ANI. What's the limit number of reflow of AM6421BSEFHIANIR?
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TLV62585: Input voltage vs Output voltage - AM64x AM62x Discrete power architecture

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: TLV62585 Tool/software: Hi Experts, I am reviewing a customer schematic. Customer is using TLV62585DRLR the input is 4.2V and could be switched to 3V. The output is 3.3V. Do you have any concern with the TLV62585DRLR providing…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] How to flash and boot Linux from NAND with AM335x Linux SDK 9.1

    Hong Guan64
    Hong Guan64
    Part Number: AM3358 Tool/software: AM335x GPMC-NAND boot issue was observed with AM335x Linux SDK 9.1 [1]. The FAQ lists the u-boot and kernel patches to support flashing and booting u-boot/kernel/root_fs with AM335x Linux SDK 9.1 from GPMC-NAND on…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] : Reset Module on AM64X / AM243/AM62X SOC's

    Swargam Anil
    Swargam Anil
    Part Number: AM6442 Tool/software: In AM64X/AM243/AM62X there are many Resets. So, what is the difference between each type of Reset? What is the boot flow for each Reset ? What are the Registers/Peripherals affected for each Reset ? How different…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] J784S4XEVM: How to create EXT4 rootfs on UFS and boot to Linux using UFS

    Keerthy J
    Keerthy J
    Part Number: J784S4XEVM Tool/software: UFS is present on the J784S4EVM. How can one use it instead of eMMC to host rootfs and use that to boot to Linux command prompt.
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198113 Discussions
  • Answered

    Problems with calloc in DSP/BIOS 0 Locked

    683 views
    5 replies
    Latest over 14 years ago
    by ToddMullanix
  • Not Answered

    PRTCSS slow interrupts and read outs 0 Locked

    319 views
    1 reply
    Latest over 14 years ago
    by zanget
  • Answered

    DM365 GIO interrupt pins multiplex problem 0 Locked

    543 views
    4 replies
    Latest over 14 years ago
    by zanget
  • Not Answered

    LCD display resolution support for DM3730 0 Locked

    161 views
    0 replies
    Started over 14 years ago
    by sweta bhatt
  • Not Answered

    RTDX_interrupt - symbol referencing error C6713 0 Locked

    1409 views
    5 replies
    Latest over 14 years ago
    by Tronix Tronix
  • Not Answered

    Status of SDOCM00067652: Suspend/resume doesn't succeed for 37x when off mode is enabled. 0 Locked

    518 views
    9 replies
    Latest over 14 years ago
    by jeffc
  • Not Answered

    Running a single static image in DaVinci 6446 EVM kit LCD 0 Locked

    220 views
    1 reply
    Latest over 14 years ago
    by Nagabhushana
  • Answered

    PSP block media driver 0 Locked

    646 views
    5 replies
    Latest over 14 years ago
    by Sandeep Krishnaswamy
  • Not Answered

    DM365 RDK - Undefined References 0 Locked

    350 views
    1 reply
    Latest over 14 years ago
    by CC Lin
  • Answered

    McBSP as slave (6437 controller) with "Spectrum digital" EVM board not working.. 0 Locked

    890 views
    7 replies
    Latest over 14 years ago
    by Raghavendra Maddikery
  • Answered

    App Note for McBSP as SPI slave with CPU interrupts... 0 Locked

    470 views
    3 replies
    Latest over 14 years ago
    by Raghavendra Maddikery
  • Not Answered

    Error In Build for RowBoat Eclair Version 0 Locked

    591 views
    6 replies
    Latest over 14 years ago
    by Bin Liu
  • Answered

    C6A816x-evm kernel boot fails on NAND but works on SD 0 Locked

    712 views
    6 replies
    Latest over 14 years ago
    by Vaibhav Bedia
  • Not Answered

    Regarding EDMA3 programming in DSP of DM814x 0 Locked

    217 views
    0 replies
    Started over 14 years ago
    by Radhesh Bhat
  • Answered

    c67xfastMath.lib: expsp.obj is partly in unspecified "text" section 0 Locked

    384 views
    1 reply
    Latest over 14 years ago
    by RandyP
  • Not Answered

    Issue with V4L2 Layer Multiple Buffers while camera is streaming 0 Locked

    807 views
    1 reply
    Latest over 14 years ago
    by Aparna Anand
  • Not Answered

    the method to overcome the noise of VA5505 's audio signal processing demo's discontinuty( noise) 0 Locked

    622 views
    5 replies
    Latest over 14 years ago
    by Kieran Yu
  • Discussion

    TI announces new low-cost eZdsp development tools Locked

    460 views
    3 replies
    Latest over 14 years ago
    by Sunil Kamath
  • Answered

    Problem in change target UART number OMAP-L138_FlashAndBootUtils_2_29? 0 Locked

    1202 views
    12 replies
    Latest over 14 years ago
    by Colman Lai
  • Not Answered

    PC jump to 0x00000000 in IPC Multicore MessageQ Sample Project for OMAP L128 0 Locked

    805 views
    6 replies
    Latest over 14 years ago
    by Stefan Koehler
<>