Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions

  • [FAQ] PROCESSOR-SDK-DRA8X-TDA4X: Ethernet LLD replacing CPSW LLD

    Part Number: PROCESSOR-SDK-DRA8X-TDA4X Hello, Processor SDK 7.1 onwards, TI is migrating it's Ethernet drivers on CPSW and ICSSG IPs to feature-rich Ethernet LLD (Enet LLD) replacing current CPSW LLD. Please find attached the Enet LLD review slides…

  • [FAQ] TDA4VM: How to debug from Linux command line

    Part Number: TDA4VM How do I do the following when running Linux: Read / Write registers Print/dump processor related information like clocks

  • [FAQ] TDA2x: What are the steps to create our own custom usecase containing custom Algorithm plugin in Vision SDK bios?

    Can I know the steps to create custom use-case, custom Algorithm plugin & how to include custom plugin into the usecase chain?

  • [FAQ] TDA2PXEVM: Temperature calculation at runtime for hlos usecase

    Hello, I am working on hlos use case and want to calculate the temperature at runtime. Please suggest some solution. Thank you in advance!

  • [FAQ] PROCESSOR-SDK-DRA8X-TDA4X: How to use IPC Example Application Echo Test on PSDKQA7.0

    Part Number: PROCESSOR-SDK-DRA8X-TDA4X How is the IPC echo test application built and run on the PSDKQA7.0 release?

  • [FAQ]: How to connect CAL to VIP on TDA2Px?

    Part Number: TDA2PXEVM TDA2Px supports Camera Adapter Layer (CAL) module to capture input over CSI interface. When YUV camera is connected to CAL over CSI interface, the data captured by CAL can be redirected to VIP module and VIP can be used for on…

  • [FAQ]: How to configure DSS for BT656 or BT1120 output format?

    Part Number: PROCESSOR-SDK-DRA8X-TDA4X Many of the LCDs and encoders accept the video over BT656 or BT1120 format. How t0 change PSDKRA to configure DSS for BT656 and BT1120 output format?

  • [FAQ] TDA4VM: Application in the PSDKRA runs standalone from SBL but doesn't run alongside Linux

    Part Number: TDA4VM I took an PSDKRA example ran it using SBL and it ran fine. But now when I copy the same application executable and put it in /lib/firmware of the SD card, it doesn't load. What could be the problem?

  • [FAQ]: How to run multi-cam usecase for YUV sensors?

    Part Number: PROCESSOR-SDK-DRA8X-TDA4X Multi-Cam example on PSDKRA currently supports RAW sensor. How to change it to use for YUV sensors?

  • [FAQ] TDA4VM: Routing interrupts via the interrupt router

    Part Number: TDA4VM How to route an interrupt from a peripheral via the interrupt router to the core?

View FAQ threads
  • Threads 198791 Discussions