Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Part Number: AM6442 Other Parts Discussed in Thread: SK-AM62B , SK-AM64B , SK-AM62 , AM625 ,
(also applicable to other AM62x, AM62Ax, AM62Px, AM64x parts with changes)
Introduction
Buildroot ( https://buildroot.org/ ) is a simple, efficient, and…
Part Number: SK-TDA4VM Other Parts Discussed in Thread: TDA4VM
Edge Impulse is a tool for creating, analyzing, and deploying machine learning to embedded targets. TI Processors, like the TDA4VM and AM62x, running the default Processor SDK for Linux…
Part Number: SK-TDA4VM Other Parts Discussed in Thread: TDA4VM
Edge Impulse is a tool for creating, analyzing, and deploying machine learning to embedded targets. TI Processors, like the TDA4VM and AM62x, running the default Processor SDK for Linux…
Part Number: AM625 Other Parts Discussed in Thread: SK-AM62
Hello,
I'm using tisdk-base-image and k3-am625-skeleton.dts on SK-AM62 as a starting point.
I modified k3-am625-skeleton.dts to enable mmc0 & mmc1, but mmc1 does not seem to be recognized…
Part Number:
PROCESSOR-SDK-AM64X
PROCESSOR-SDK-AM62X
Hi TI Expert,
Question1: Is there any open source code to recommend for EtherCAT MainDevice in Linux ?
Answer:
There is an constrained open source EtherCAT MainDevice at https://etherlab…
Other Parts Discussed in Thread: SK-AM62 Hi TI Experts,
Could you guide me on configuring the SK-AM62 EVM Bootmode for the below board revisions and testing?
1. Dip Switch Setting for E1
2. Dip switch setting for E2/E3
3. DFU Bootmode does not…
