TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM625-Q1 / AM625SIP: UHS-I SDR104 Receive mode timing

    Koichiro Tashiro
    Koichiro Tashiro
    Part Number: AM625 Tool/software: Hi, Datasheet section 7.11.5.16.2.7 only provides Transmit Mode timings. My customer is asking for receive mode timings. Thanks and regards, Koichiro Tashiro
    • 10 months ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: TIDL back port guide including SDK 9.x and SDK 10.x

    Adam Hua
    Adam Hua
    Part Number: TDA4VM-Q1 Other Parts Discussed in Thread: TDA4VM Tool/software: New features of TIDL are always added with new SDK release, but it is not possible to upgrade the whole SDK because this will affect all parts of software. This thread will…
    • 10 months ago
    • Processors
    • Processors forum
  • [FAQ] AM62A7 / AM62A7-Q1 / AM62A3 / AM62A3-Q1 / AM62A1-Q1 / AM62D-Q1 / AM62P / AM62P-Q1 Design Recommendations / Custom board hardware design – common queries for PMIC TPS65224-Q1

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM62P Other Parts Discussed in Thread: TPS65224-Q1 , TPS65219 , , TPS65224 , AM62A7 , AM62A3 , AM62A7-Q1 , AM62A3-Q1 , USB2ANY , AM6442 , TPS22918 Tool/software: HI Board designers, I am designing my board using TPS65224-Q1 PMIC Are…
    • Answered
    • 10 months ago
    • Processors
    • Processors forum
  • [FAQ] AM62A7 / AM62A7-Q1 / AM62A3 / AM62A3-Q1 / AM62A1-Q1 / AM62D-Q1 Design Recommendations / Custom board hardware design – common queries for PMIC TPS6593

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM62A74 Other Parts Discussed in Thread: TPS6594-Q1 , TPS65224 , AM62A7-Q1 , TPS6593-Q1 , TPS22918 Tool/software: HI Board designers, I am designing my board using TPS6593 PMIC Are there some common recommendation or observations…
    • Answered
    • 11 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM625-Q1 / AM625SIP Design Recommendations / Custom board hardware design – Common queries for PMIC TPS65219 and PDN

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM625 Other Parts Discussed in Thread: TPS65219 , TPS6521905 , TPS65215 , AM2434 , TPS65220 , AM6421 , TPS22918 Tool/software: HI Board designers, I am designing my board using TPS65219. Are there some common recommendation or observations…
    • Answered
    • 11 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM625-Q1 / AM625SIP: Custom board hardware design – Connection recommendations for RSVD pins

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM625 Tool/software: Hi TI Experts, I see some of the processor pins named RSVD. Are there some recommendations to be followed during custom board design.
    • Answered
    • 11 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM625-Q1 / AM625SIP Custom board hardware design – Queries regarding crystal (MCU_OSC0) Start-up Time

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM625 Other Parts Discussed in Thread: AM6442 , , AM62P , SYSCONFIG Tool/software: Hi TI Experts, I have a question about "Figure 7-16. MCU_OSC0 Start-up Time" from the datasheet. Here it looks like that MCU_OSC0 is only allowed to…
    • Answered
    • 11 months ago
    • Processors
    • Processors forum
  • [FAQ] AM3357: ADC AIN input for AM3357 (also applies to AM3352 , AM3354 , AM3356 ,AM3358 , AM3359)

    takahiro higuchi
    takahiro higuchi
    Part Number: AM3357 Tool/software: Hi team, I am planning to input an analog signal to AM3357's AIN by dividing the voltage. Was the constant of the voltage divider resistor OK with the constant shown in the figure? I am wondering if I should add…
    • 11 months ago
    • Processors
    • Processors forum
  • [FAQ] AM62x, AM62Ax, AM62Px, AM62D-Q1, AM64x, AM243x: OSPI Phy Tuning Algorithm

    Vaibhav Kumar
    Vaibhav Kumar
    Part Number: AM62A7 Other Parts Discussed in Thread: SYSCONFIG Tool/software: Questions addressed in this post: What is OSPI Phy Tuning? When is the Phy Tuning Algorithm used? Where is the Phy enabled and disabled throughout the MCU PLUS SDK…
    • Answered
    • 11 months ago
    • Processors
    • Processors forum
  • [FAQ] AM6442: Clock Specifications for SERDES0_REFCLK0N SERDES0_REFCLK0P and USB3

    TK0312
    TK0312
    Part Number: AM6442 Other Parts Discussed in Thread: SK-AM64B Tool/software: Hello, I am designing a board with Ethernet and USB3 using the AM6442. I have referred to the device sheet and TRM, but I could not find the required specifications for…
    • Answered
    • 11 months ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198461 Discussions
  • Not Answered

    I try to make “awb_calc_data.c” for my raw sensor with Image Turning Tool : Stand alone mode 0 Locked

    263 views
    0 replies
    Started over 14 years ago
    by YongKil JUNG
  • Answered

    Codec Server Compile Error: Unresolved symbols -- about dm6467 HDVICP 0 Locked

    212 views
    1 reply
    Latest over 14 years ago
    by bin mortal
  • Answered

    OMAP L138 uart1 maximum baud rate 0 Locked

    3738 views
    13 replies
    Latest over 14 years ago
    by sinoj issac
  • Not Answered

    Not able to create server from TI's h264 decoder library for DM6467. 0 Locked

    374 views
    3 replies
    Latest over 14 years ago
    by bin mortal
  • Not Answered

    Need to display driver on LCD of AM3517 EVM kit 0 Locked

    411 views
    2 replies
    Latest over 14 years ago
    by embedded linux beginner
  • Not Answered

    5505CEVM batteries power supply - how do we make it work? 0 Locked

    332 views
    2 replies
    Latest over 14 years ago
    by Steve Tsang
  • Answered

    problem with insmod cmemk.ko 0 Locked

    1115 views
    2 replies
    Latest over 14 years ago
    by Ashwani
  • Answered

    How to write eboot in Nand Falsh using EVM flash tool (Flash v1.2) on OMAP EVM 3530 Rev D? 0 Locked

    900 views
    3 replies
    Latest over 14 years ago
    by Jatin Jain
  • Not Answered

    computation capacity in terms of Flops. 0 Locked

    275 views
    0 replies
    Started over 14 years ago
    by chenhui yang
  • Answered

    CCS V4.2, SYSBIOS, OMAP-L138 link error "Data Verification Failure" 0 Locked

    1548 views
    11 replies
    Latest over 14 years ago
    by Robert Wolfe
  • Not Answered

    Linux Ethernet Stack Limiting Performance 0 Locked

    671 views
    5 replies
    Latest over 14 years ago
    by Chuck@Cimarron Systems
  • Not Answered

    the problem of PSC0 0 Locked

    443 views
    2 replies
    Latest over 14 years ago
    by Gaurav Agarwal
  • Not Answered

    edma3 lld performance insufficient 0 Locked

    788 views
    7 replies
    Latest over 14 years ago
    by RandyP
  • Answered

    Building the DSP side of DSPLINK 0 Locked

    214 views
    2 replies
    Latest over 14 years ago
    by Kevin the almighty
  • Not Answered

    C6745 - finished testing my C code on the PC, how do I load it in my target board? 0 Locked

    179 views
    1 reply
    Latest over 14 years ago
    by Gaurav Agarwal
  • Answered

    CCSv4: XDC runtime error .... diags_USER1 is sealed - what does that mean? 0 Locked

    2588 views
    23 replies
    Latest over 14 years ago
    by Chris McCormick
  • Answered

    Proper way of sharing IO resources between ARM and DSP in OMAP-L138 Linux PSP 0 Locked

    3273 views
    15 replies
    Latest over 14 years ago
    by Mike Brudevold
  • Not Answered

    I can't understand the 2nd order IIR resonator algorithm 0 Locked

    234 views
    1 reply
    Latest over 14 years ago
    by Steve Tsang
  • Not Answered

    Can MUSB work as Hub on DM365? 0 Locked

    479 views
    6 replies
    Latest over 14 years ago
    by swami
  • Not Answered

    DSPLink compile 0 Locked

    93 views
    0 replies
    Started over 14 years ago
    by Bill Loraine
<>