TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AM654x, AM652x : Data sheet Documentation (about timing) of the power sequencing

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM6548 Tool/software: Hi TI experts, On page 142 of the datasheet "AM654x, AM652x Sitara Processors Silicon Revision 2.1 datasheet (Rev. C)", Figure 6-4. Power-Up Sequencing using On Chip Power-on-reset (POR) has labels such as "Note…
    • Answered
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] AM6422: How to configure the PCIe align with the simulation results.?

    wang shu
    wang shu
    Part Number: AM6422 Tool/software: Hi, I am setting the PCIe configuration. We simulated the PCIe using the IBIS model of AM6422. Below picture is the configuration we could get best simulation results. We don't know how to set it in AM6422 software…
    • Answered
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM625-Q1 / AM625SIP: eMMC0_DAT0 not enabled pull up by ROM

    Tony Tang
    Tony Tang
    Part Number: AM625 Tool/software: #1. On my customer board using eMMC0 boot, did not pull up eMMC0_DAT0, occasionally can't boot up by Power On, but can boot up by warm reset or power cycle. #2. Add pull up on eMMC_DAT0, can boot up always so far…
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM62L / AM62A / AM62P / AM62D-Q1 / AM64x / AM243x Design Recommendations / Custom board hardware design - Data sheet Pin Attributes and Pin connectivity related queries

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM625 Tool/software: Hi TI Experts, I have the below query regarding the data sheet Pin attributes Pin attributes I have a number of IOs that are not used, is there a connection recommendation Is there a recommendation for the…
    • Answered
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM62L / AM62A / AM62P / AM62D-Q1 / AM64x / AM243x Design Recommendations / Custom board hardware design - Current Data sheet revision, updates, revision backup and usage notes

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM625 Other Parts Discussed in Thread: AM62D-Q1 , AM62P , AM62L Tool/software: Hi TI Experts, I have the below query Currently available data sheet revision How do i verify i am using the latest revision Is there a way i can receive…
    • Answered
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] SK-AM69: How to run GStreamer pipeline with RTSP source

    Fabiana Jaimes
    Fabiana Jaimes
    Part Number: SK-AM69 Tool/software: How to stream H.264 encoded streams from a RTSP compliant IP camera or via RTSP server running on remote PC using GStreamer?
    • Answered
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] AM5728: Build and Test Guide for AM57xx Driver Examples using CCS

    Karthikeyan S
    Karthikeyan S
    Part Number: AM5728 Tool/software: Hi, How can I build and test an AM57xx driver example Using CCS?
    • Answered
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] AM623: Can eMMC0 support DDR50 mode

    Tony Tang
    Tony Tang
    Part Number: AM623 Tool/software: Can MMC0 port support eMMC DDR50? In the datasheet, list only 3 modes for eMMC application. DDR50 in SD Card application but not for eMMC. Although list all features in TRM, but we was told follow datasheet…
    • Answered
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] How to flash u-boot to GPMC-NAND with USB-DFU on AM62x

    Hong Guan64
    Hong Guan64
    Part Number: AM625 Other Parts Discussed in Thread: SK-AM62-LP Tool/software: AM62x boot ROM supports booting from parallel GPMC NAND. From "5.4.9.1 GPMC NAND Bootloader Operation" in AM62x TRM "GPMC NAND boot only supports boot from ONFI 1.0 compatible…
    • Answered
    • 8 months ago
    • Processors
    • Processors forum
  • [FAQ] SK-AM64B: What is the purpose of --operation=flash-phy-tuning-data ?

    Vaibhav Kumar
    Vaibhav Kumar
    Part Number: SK-AM64B Tool/software: Greetings All, In MCU PLUS SDK offering, across Sitara SoCs, one must have come across different configuration files. These configuration files are located inside the directory: MCU_PLUS_SDK_INSTALL_PATH\tools…
    • Answered
    • 8 months ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198379 Discussions
  • Discussion

    Error with FVID VPFE driver config for 480x640 bt.656 input on DM6437 Locked

    509 views
    5 replies
    Latest over 16 years ago
    by Thupakula
  • Not Answered

    DM355 IPIPE driver support for hardware histograms 0 Locked

    254 views
    1 reply
    Latest over 16 years ago
    by Juan Gonzales
  • Not Answered

    Enabling and disabling Preview Engine at run time on DM6437 0 Locked

    267 views
    0 replies
    Started over 16 years ago
    by Fabrizio
  • Not Answered

    NAND or NOR, what is better for boot with DM6437? 0 Locked

    387 views
    3 replies
    Latest over 16 years ago
    by Fabrizio
  • Not Answered

    NAND bad block with uboot, url, file system 0 Locked

    431 views
    2 replies
    Latest over 16 years ago
    by Tao_SV
  • Not Answered

    DM6467 external interrupts 0 Locked

    460 views
    2 replies
    Latest over 16 years ago
    by Brad Griffis
  • Suggested Answer

    DM644x SPI Voltage 0 Locked

    190 views
    1 reply
    Latest over 16 years ago
    by Juan Gonzales
  • Not Answered

    Error: incompatible use of package 'ti.rtdx' 0 Locked

    317 views
    0 replies
    Started over 16 years ago
    by Gabriel Quintana
  • Not Answered

    Files missing from fc/utils 0 Locked

    242 views
    0 replies
    Started over 16 years ago
    by Dirk Helgemo
  • Not Answered

    DM6446-function call and return latency 0 Locked

    456 views
    3 replies
    Latest over 16 years ago
    by Bernie Thompson TI
  • Not Answered

    Unable to set the environment variables correctly in OMAP L137/ZTMS320C6747 EVM 0 Locked

    3090 views
    4 replies
    Latest over 16 years ago
    by Juan Gonzales
  • Answered

    Is there a document for davincifb in mv5.0? 0 Locked

    265 views
    3 replies
    Latest over 16 years ago
    by Juan Gonzales
  • Not Answered

    Camera Driver in TI_EVM_3530 BSP 0 Locked

    243 views
    1 reply
    Latest over 16 years ago
    by Jason M12556
  • Not Answered

    [OMAP3530] Build problems with packages/ti/sdo/fc/utils 0 Locked

    246 views
    1 reply
    Latest over 16 years ago
    by Dirk Helgemo
  • Answered

    3530 BSP Wince 6.10 build issues with asm files 0 Locked

    413 views
    4 replies
    Latest over 16 years ago
    by Matt Pope
  • Answered

    Running Linux & DSP/BIOS at same time on OMAP-L137 0 Locked

    320 views
    1 reply
    Latest over 16 years ago
    by Brad Griffis
  • Not Answered

    davincifb bug in lsp2.10(mv5.0) ? 0 Locked

    246 views
    1 reply
    Latest over 16 years ago
    by miscellanea
  • Not Answered

    Is safe to write directly in an EDMA register from an EDMA transfer? 0 Locked

    328 views
    5 replies
    Latest over 16 years ago
    by Brad Griffis
  • Answered

    [C6713] library file types 0 Locked

    246 views
    1 reply
    Latest over 16 years ago
    by Brad Griffis
  • Answered

    [C6713] Codec channel swaps 0 Locked

    317 views
    1 reply
    Latest over 16 years ago
    by Brad Griffis
<>