TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AM6442: MCU_OSC0 Crystal Circuit Requirements

    Guillaume Henri
    Guillaume Henri
    Part Number: AM6442 Tool/software: Dear Sitara HW champs, In the Table “6-19. MCU_OSC0 Crystal Circuit Requirements” in the AM64x datasheet, it is specified the following : . When not using the RGMII and/or RMII interfaces, then +/-100 ppm Xtal…
    • Answered
    • 10 months ago
    • Processors
    • Processors forum
  • [FAQ] PROCESSOR-SDK-AM64X: Data Verification Error while loading the program on M4F core

    Tushar Thakur
    Tushar Thakur
    Part Number: PROCESSOR-SDK-AM64X Tool/software: I am trying to load the SDK example code to AM62x/AM64x board, but I am facing an issue while loading the program into it as shown in the below screenshot. Can you please help to resolve the above error…
    • Answered
    • 10 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM62A / AM62D-Q1 / AM62P / AM62L / AM64x / AM243x Design Recommendations / Custom board hardware design - Custom Board Schematics Self Review

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM625 Other Parts Discussed in Thread: TMDS64EVM , SK-AM64B , SK-AM62B-P1 , SK-AM62-LP , SK-AM62B , SK-AM62-SIP , , SK-AM62A-LP , AM62P , SK-AM62P-LP Tool/software: HI TI experts, We are currently designing a custom board leveraging…
    • Answered
    • 10 months ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: Patches and scripts for the SRV optimization App note

    Nikhil Dasan
    Nikhil Dasan
    Part Number: TDA4VM-Q1 Other Parts Discussed in Thread: TDA4VM Tool/software: Links for the patches for the SRV optimization App note
    • Answered
    • 10 months ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: MDIO change in SR2.0

    Biao Li
    Biao Li
    Part Number: TDA4VM-Q1 Other Parts Discussed in Thread: TDA4VM Tool/software: Hi Expert, My customer Motovis report an issue about ethernet link down issue, customer have catch the MDIO using the Logic analysis, they find there is some difference…
    • Answered
    • 10 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625: MCSPI MISO MOSI IDENTIFICATION

    Paul Nwoko
    Paul Nwoko
    Part Number: AM625 Tool/software: Hi Ti Experts, I am designing a custom board for the AM6254 SoC and trying to connect an SPI peripheral to the AM6254 SPI interface. I intend to use MCU_SPI1 Channel but I am not sure which one is MISO and MOSI…
    • Answered
    • 10 months ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AP-Q1: How to Set PCIe0 Transmitter De-emphasis

    Kevin Peng
    Kevin Peng
    Part Number: TDA4AP-Q1 Tool/software: Hi TI Experts, Customer is working on TDA4AP SDK10.0. They are using SPL boot. They want to change the De-emphasis to be -3.5dB for PCIe0 for 5.0GT/s to minimize reflection. Please see the below description…
    • Answered
    • 10 months ago
    • Processors
    • Processors forum
  • [FAQ] AM62X/AM62Ax/AM62Px: What to do if Linux fails to initialize remoteproc with DM R5F?

    Nick Saulnier
    Nick Saulnier
    I am using a processor with a DM R5F (AM62x, AM62Ax, AM62Px). I am using SDK 9.2.1 or SDK 10.0. The Device Manager (RM) R5F core is listed in the Linux devicetree, so Linux should use the remoteproc driver to attach to the DM R5F during Linux boot time…
    • Answered
    • 10 months ago
    • Processors
    • Processors forum
  • [FAQ] SK-AM69: How to stream from CSI sensor and USB camera to display using GStreamer?

    Fabiana Jaimes
    Fabiana Jaimes
    Part Number: SK-AM69 Other Parts Discussed in Thread: SK-AM68 , AM67 , SK-TDA4VM Tool/software: Hi, I have a Starter Kit (SK) Edge AI device with a CSI sensor connected and would like to stream to my display. I have enabled the sensor by following…
    • Answered
    • 10 months ago
    • Processors
    • Processors forum
  • [FAQ] : How to test ECC for R5F Cache Memories on AM6x/AM243 devices.

    Nihar Potturu
    Nihar Potturu
    Part Number: SK-AM62B-P1 Tool/software: Is ECC (SEC/DED) testing possible on R5F internal cache memories? If yes, please provide the steps to do so.
    • Answered
    • 10 months ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198009 Discussions
  • Not Answered

    beginner question about the dm6437 0 Locked

    222 views
    1 reply
    Latest over 16 years ago
    by Bernie Thompson TI
  • Discussion

    DSPLink problems with the DM6467 Locked

    207 views
    1 reply
    Latest over 16 years ago
    by Juan Gonzales
  • Not Answered

    need dm355 the source package of busybox employed by TI 0 Locked

    301 views
    1 reply
    Latest over 16 years ago
    by Bernie Thompson TI
  • Discussion

    HELP----"Invalid Module Format" error @ insmod V4L module for OMAP3530 Locked

    381 views
    1 reply
    Latest over 16 years ago
    by Bernie Thompson TI
  • Discussion

    Problem running CCS Locked

    245 views
    1 reply
    Latest over 16 years ago
    by Bernie Thompson TI
  • Not Answered

    Questions about libraries and test codes 0 Locked

    372 views
    2 replies
    Latest over 16 years ago
    by RobbySun
  • Not Answered

    Testing External Memory 0 Locked

    1967 views
    16 replies
    Latest over 16 years ago
    by BrandonAzbell
  • Discussion

    dm355 busybox Locked

    354 views
    2 replies
    Latest over 16 years ago
    by Bernie Thompson TI
  • Discussion

    do a menu including 1.encode 2. decode 3. stock up 4.encode and stock up 5 pause 6 quit the 7stop ? Locked

    227 views
    1 reply
    Latest over 16 years ago
    by Juan Gonzales
  • Discussion

    may I encode and decode mpeg4 in dm355 IR remote ? Locked

    323 views
    1 reply
    Latest over 16 years ago
    by Juan Gonzales
  • Not Answered

    How to use a pipe to transfer data between two tasks?? 0 Locked

    240 views
    2 replies
    Latest over 16 years ago
    by wenying xu
  • Discussion

    Linux/Kernel -dispc_reg_merge() and dispc_reg_out() Locked

    287 views
    3 replies
    Latest over 16 years ago
    by Elric
  • Discussion

    DM355 running on battery. Locked

    340 views
    4 replies
    Latest over 16 years ago
    by viethoang
  • Not Answered

    NOR flash on DM355 0 Locked

    314 views
    5 replies
    Latest over 16 years ago
    by Bernie Thompson TI
  • Discussion

    Introducing Delay in Program[CCS 3.3] Locked

    902 views
    5 replies
    Latest over 16 years ago
    by Bernie Thompson TI
  • Not Answered

    How to boot the EVM6437 board with CCS? 0 Locked

    369 views
    3 replies
    Latest over 16 years ago
    by TimHarron
  • Not Answered

    Input video format question while using IMGLIB 0 Locked

    422 views
    3 replies
    Latest over 16 years ago
    by akira
  • Discussion

    data verification failed at 0x80000000.unable to access sdram Locked

    479 views
    1 reply
    Latest over 16 years ago
    by Juan Gonzales
  • Not Answered

    Does lib file can be converted to ais file 0 Locked

    459 views
    5 replies
    Latest over 16 years ago
    by Geetha
  • Discussion

    TMS320C6000 DSP (CPU) and DMA Locked

    384 views
    4 replies
    Latest over 16 years ago
    by Camila Nunes
<>