TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] J722SXH01EVM: Attempt to connect to XDS110 failed (on-board USB debugger)

    Neehar Sawant
    Neehar Sawant
    Part Number: J722SXH01EVM Tool/software: I have the following error when trying to connect XDS110 debugger and launch target configuration in CCS: How do I fix this?
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM64x / AM243x / AM62Ax / AM62Px / AM62D-Q1 / AM62L - Bootmode implementation without isolation buffers

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM625 Other Parts Discussed in Thread: SK-AM62A-LP , AM62L , AM62P Tool/software: Hi TI Experts, Do you have suggestions to optimize the BOOTMODE configuration on custom board compared to implementation on the SK or the EVM schematics…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM625SIP / AM625-Q1 / AM62Ax / AM62Px Custom board hardware design – CSI-2 capabilities

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM625 Tool/software: Hi TI Experts, I have the below queries regarding the CSI-2 interface Supported data rate Does the CSI-2 interface provide provision for internal termination Links to useful threads Let me know your…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM6442: Running Raw Serdes

    Tony Spagnolia
    Tony Spagnolia
    Part Number: AM6442 Tool/software: We have a desire to use the SERDES as a raw interface without a protocol on top. The idea would be to just run 8b/10b and limit our packet size to 10 -40 bits. Is this possible or do we need to run PCIE or USB using…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AH-Q1: How to edit/change ONNX graph to remove unsupported layers by TIDL and add supported ones

    Pratik Kedar
    Pratik Kedar
    Part Number: TDA4AH-Q1 Tool/software: I have ONNX graph with below mentioned layer structure. Which tools can i use to change the unsupported layer (HardSwish) to Supported ones ?
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] SK-TDA4VM: No graphics acceleration on SDK 9.x in Wayland (Weston)

    JB LIM
    JB LIM
    Part Number: SK-TDA4VM Other Parts Discussed in Thread: TDA4VM Tool/software: Hi, TI Team I run an opencv example program(drawing and media play) in Wayland(western). But drawing(graphics) is little bit slow and media play occurs a stuttering frames…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM623: 4GB LPDDR4

    Kim Yue
    Kim Yue
    Part Number: AM623 Tool/software: Hi team, A customer wants to have 4GB LPDDR4 (single channel topology). They could not find 4GB 16-bit single-channel LPDDR4, there is only 2GB option. Can they use a 32-bit device and only connect one channel?…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM62P: How to measure wakeup latency for Low Power Modes on AM62x/A/P

    Anshu Madwesh
    Anshu Madwesh
    Part Number: AM62P Tool/software: How can you measure the wakeup latency for Low Power Modes on AM62x/A/P? Low Power Mode's wakeup latency is the amount of time required from triggering a wakeup event to resuming normal operation. This FAQ shows to…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM62x, AM62Ax, AM62D-Q1, AM62L, AM62Px, AM64x, AM243x, Custom board hardware design – How to handle Used / Unused Pins / Peripherals and add pullup or pulldown? (e.g. GPIOs, SERDES, USB, CSI, MMC (eMMC, SD-card), CSI, OLDI, DSI, CAP_VDDSx, .......

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM625 Tool/software: Hi TI Experts, Is there any application note with information about how to connect IOs or Peripherals - Used or Unused Details on the connections to be done when used. When not used, should these IOs or Peripherals…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VH-Q1: How to change the ATF to print on MCU_UART in SBL bootflow

    Nikhil Dasan
    Nikhil Dasan
    Part Number: TDA4VH-Q1 Tool/software: In the SBL bootflow, using BootApp, how to print ATF logs on MCU_UART or WKUP_UART?
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198424 Discussions
  • Not Answered

    AM335X_StarterWare_02_00_00_07\third_party\fatfs\src\integer.h", line 22: error #41: expected an identifier 0 Locked

    724 views
    3 replies
    Latest over 12 years ago
    by John Conover
  • Answered

    EDMA3 LLD questions: are the structures EDMA3_RM_GblConfigParams, EDMA3_RM_InstanceInitConfig same as EDMA3_DRV_GblConfigParams, EDMA3_DRV_InstanceInitConfig 0 Locked

    579 views
    2 replies
    Latest over 12 years ago
    by Victor Cheng
  • Answered

    c6x Linux Real Time OS? 0 Locked

    185 views
    1 reply
    Latest over 12 years ago
    by Rex Chang
  • Not Answered

    Errors during building project 0 Locked

    265 views
    1 reply
    Latest over 12 years ago
    by Radhesh Bhat
  • Not Answered

    TWL6041 audio chip not working on TI Omap4460 custom board 0 Locked

    315 views
    0 replies
    Started over 12 years ago
    by Mooi Mooi Tan
  • Answered

    8168 McAsp 0 Locked

    310 views
    1 reply
    Latest over 12 years ago
    by Pavel Botev
  • Not Answered

    OMAP3530ECBB 0 Locked

    139 views
    1 reply
    Latest over 12 years ago
    by Cvetolin Shulev-XID
  • Not Answered

    Memory allocation. 0 Locked

    382 views
    2 replies
    Latest over 12 years ago
    by Sriram V
  • Answered

    What is softwares to open the camera to get buffer data to user applications on OMAP4460 in Ubuntu? 0 Locked

    427 views
    3 replies
    Latest over 12 years ago
    by Olivier Naudan
  • Not Answered

    mic input instead of line input in beaglebone audio cape 0 Locked

    226 views
    0 replies
    Started over 12 years ago
    by Mehmet Kurnaz15096
  • Not Answered

    mic input instead of line input in beaglebone audio cape 0 Locked

    252 views
    0 replies
    Started over 12 years ago
    by Mehmet Kurnaz15096
  • Not Answered

    AM3517: RBL related speed optimizations? 0 Locked

    417 views
    6 replies
    Latest over 12 years ago
    by Anton Ivanov1
  • Not Answered

    No snd device found on dm8168 evm board when kernel start 0 Locked

    183 views
    0 replies
    Started over 12 years ago
    by Xavier
  • Answered

    Desktop Linux SDK questions 0 Locked

    334 views
    2 replies
    Latest over 12 years ago
    by Sam Nelson
  • Not Answered

    Query regarding PMIC and AM3352 JTAG 0 Locked

    313 views
    1 reply
    Latest over 12 years ago
    by Biser Gatchev-XID
  • Not Answered

    ping failed?? 0 Locked

    198 views
    0 replies
    Started over 12 years ago
    by mostafa safaie
  • Answered

    2K JPEG2000 codec support 0 Locked

    363 views
    2 replies
    Latest over 12 years ago
    by Sahan Devapriya
  • Not Answered

    problem in debugging new project 0 Locked

    172 views
    1 reply
    Latest over 12 years ago
    by Radhesh Bhat
  • Not Answered

    DM368 - Software OSD font color is not working 0 Locked

    352 views
    0 replies
    Started over 12 years ago
    by sweta bhatt
  • Not Answered

    Making a custom signal library functiopn 0 Locked

    205 views
    1 reply
    Latest over 12 years ago
    by Venugopala
<>