TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AM64X/ AM62X : How to Reset the SOC when WDT timer expires in AM64X and AM62X?

    Swargam Anil
    Swargam Anil
    Part Number: AM6442 Introduction: The primary application of a watchdog timer is as a system monitor to detect and reset an "out of control" SOC. When program execution goes wrong or software or devices are not functioning properly, the watchdog…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VH/AM62A: How to create the CAC mesh LUT for DCC tuning tool input?

    Gang Hua
    Gang Hua
    CAC in VPAC3-VISS or VPAC3L-VISS is very similar to LDC in VPAC. To prepare the CAC LUT for DCC tuning tool input, we may use similar matlab/octave script as LDC. You may refer to the LDC FAQ in the link below for more details. e2e.ti.com/.../faq-tda4vm…
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] DRA821: canTxstatus is busy even after Cancellation of Finished messages is set for respective Tx Buffer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4VM Hello, Customer has enabled AUTO retransmission of messages, and Using the CAN channel on TDA4x device to continuously send messages, and then remove other nodes on the CAN bus. Later it entered into Error passive state , and the…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] PROCESSOR-SDK-J784S4: How Do I Build Yocto Images and Packages for J7 Devices?

    Jared McArthur
    Jared McArthur
    Part Number: PROCESSOR-SDK-J784S4 Other Parts Discussed in Thread: DRA821 , DRA829 , TDA4VM , AM68 , AM69 , SK-AM68 , SK-AM69 How do I build the default yocto images and install new packages for J7 devices?
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM625-Q1 / AM625SIP : LFOSC usage in the processor

    Koichiro Tashiro
    Koichiro Tashiro
    Part Number: AM625 Other Parts Discussed in Thread: AM62D-Q1 , AM62P-Q1 , , AM62A7-Q1 , AM623 Hi, I have a question from my customer for LFOSC (external 32.668kHz). According to datasheet section 7.11.4.1 Input Clocks / Oscillators, it seems the clock…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM625-Q1 / AM625SIP / AM62L / AM62A7 / AM62A3 / AM62A1-Q1 / AM62D-Q1 / AM62P / AM62P-Q1 Custom board hardware design – EXTINTn pin pullup connection

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Hi TI Experts, I have the below queries regarding the use of EXTINTn pin. Termination recommendations when used. Termination recommendations when not used. Let me know your thoughts.
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM62A7 / AM62A7-Q1 / AM62A3 / AM62A3-Q1 / AM62A1-Q1 / AM62D-Q1 Custom board hardware design - FAQs related to Processor collaterals, functioning, peripherals, interface and Starter kit

    Lavanya M R
    Lavanya M R
    Other Parts Discussed in Thread: AM62D-Q1 , SK-AM62A-LP , AM62P , TMUX1308-Q1 , TPS65224-Q1 Hi Board designers, Refer FAQs listed below related to custom board design for AM62Ax and AM62D-Q1 processor families that could be used along with other available…
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM625, AM623, AM620-Q1, AM625-Q1, AM625SIP Custom board hardware design - FAQs related to Processor collaterals, functioning, peripherals, interface and Starter kit

    Lavanya M R
    Lavanya M R
    Other Parts Discussed in Thread: AM62D-Q1 , SK-AM62 , SK-AM62B-P1 , SK-AM62-LP , SK-AM62-SIP , SK-AM62B , AM62P , TMUX1308-Q1 , TPS65219 Hi Board designers, Refer FAQs listed below related to custom board design for AM62x processor family that could…
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM620-Q1 / AM625-Q1 Custom board hardware design – Collaterals to Get started

    Lavanya M R
    Lavanya M R
    Part Number: AM625-Q1 Other Parts Discussed in Thread: AM620-Q1 , AM625 , AM623 , , AM625SIP , AM62D-Q1 , TPS65219 , SK-AM62-LP , SK-AM62B-P1 , SYSCONFIG Hi TI Experts, Can you provide a List of collaterals that can be referred when starting a custom…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VL: How to resolve NETDEV WATCHDOG: transmit queue timed out issue in Linux (A72) in case of SBL optimized boot flow?

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VL How to resolve NETDEV WATCHDOG: transmit queue timed out issue in Linux (A72) in case of SBL optimized boot flow?
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198177 Discussions
  • Suggested Answer

    Notify callback called multiple times 0 Locked

    1882 views
    11 replies
    Latest over 9 years ago
    by murad qahwash
  • Answered

    Problem in getting CPTS Hardware Timestamp. 0 Locked

    2700 views
    5 replies
    Latest over 9 years ago
    by Shylesh S
  • Discussion

    TI RTOS vs FreeRTOS Locked

    2964 views
    1 reply
    Latest over 9 years ago
    by MarkGrosen
  • Suggested Answer

    AM335X VDD_MPU_MON pin functionality 0 Locked

    2478 views
    6 replies
    Latest over 9 years ago
    by peaves
  • Not Answered

    OMX aac decoder port corruption on dm816x DSP when starting component 0 Locked

    713 views
    2 replies
    Latest over 9 years ago
    by Jose Jimenez
  • Suggested Answer

    ARM PLL clock in K2HEVM 0 Locked

    815 views
    3 replies
    Latest over 9 years ago
    by Senthilkumar Srinivasan
  • Answered

    Memory mapping for A15 0 Locked

    844 views
    4 replies
    Latest over 9 years ago
    by netrover
  • Answered

    CC3200 AWS IOT build throwing error -9 0 Locked

    1130 views
    8 replies
    Latest over 9 years ago
    by Vincent W.
  • Answered

    To update the PWM frequencies using pwm_open() by doing PWM_INIT only once & without using pwm_close for each update 0 Locked

    1611 views
    5 replies
    Latest over 9 years ago
    by Vincent W.
  • Suggested Answer

    beagleboneblack tcp retransmit 0 Locked

    1932 views
    3 replies
    Latest over 9 years ago
    by Schuyler Patton
  • Answered

    How to configure the alignment parameter for heap multi-buf 0 Locked

    495 views
    2 replies
    Latest over 9 years ago
    by Kaichien (Thomas) Tsai
  • Suggested Answer

    C6748 USB throug put 0 Locked

    8817 views
    45 replies
    Latest over 9 years ago
    by Dhar Kurban
  • Answered

    Video Latency occurs when the screen frequency is set to 24Hz on TMS320DM8168 0 Locked

    1076 views
    5 replies
    Latest over 9 years ago
    by Pavel Botev
  • Suggested Answer

    Cycle count increased after adding intrinsic assembly functions for TCI6638 target platform 0 Locked

    636 views
    1 reply
    Latest over 9 years ago
    by ran35366
  • Answered

    DM8168 Max CVDD spec confusion 0 Locked

    770 views
    2 replies
    Latest over 9 years ago
    by Pavel Botev
  • Answered

    Question about mapping system interrupt to Host Interrupt, eventId is -1 0 Locked

    1091 views
    3 replies
    Latest over 9 years ago
    by Raja
  • Not Answered

    DM8148 with RDK4.0.1 0 Locked

    551 views
    1 reply
    Latest over 9 years ago
    by Margarita Gashova
  • Answered

    C6748: using the resource partitions outside loops 0 Locked

    305 views
    1 reply
    Latest over 9 years ago
    by Sivaraj Kuppuraj
  • Answered

    Program.heap and BIOS.heap 0 Locked

    1763 views
    3 replies
    Latest over 9 years ago
    by Vincent W.
  • Suggested Answer

    GIO27 configuration on DM6435 0 Locked

    857 views
    2 replies
    Latest over 9 years ago
    by Titusrathinaraj Stalin
<>