TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DRA821: SPL BOOT without A72 SPL on J7200 on 10.1 SDK

    Gokul Praveen
    Gokul Praveen
    Part Number: DRA821 Tool/software: How to enable Falcon Boot Mode on J7200? Boot Flow: R5 SPL -> ATF -> OPTEE -> U-BOOT -> Kernel Regards Gokul
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 197756 Discussions
  • Not Answered

    GPIO context during "suspend" (deepsleep0) 0 Locked

    536 views
    6 replies
    Latest over 10 years ago
    by Dav01
  • Not Answered

    Debug data port switch in AM3359 processor 0 Locked

    153 views
    1 reply
    Latest over 10 years ago
    by Biser Gatchev-XID
  • Answered

    Hwi_disable in multicore 0 Locked

    279 views
    1 reply
    Latest over 10 years ago
    by Ganapathi Dhandapani95
  • Answered

    EMAC DHCP Still Not Working 0 Locked

    786 views
    5 replies
    Latest over 10 years ago
    by Stephen Mansfield
  • Not Answered

    Intelligent Motion Detect does not in DM8168 [DVRRDK04.00.00.03] 0 Locked

    353 views
    3 replies
    Latest over 10 years ago
    by Ritesh Rajore
  • Answered

    Device connected on i2c doesn't get discovered. 0 Locked

    750 views
    4 replies
    Latest over 10 years ago
    by Dip Bhanvadiya
  • Answered

    platform_write for C6678 0 Locked

    1308 views
    2 replies
    Latest over 10 years ago
    by murad qahwash
  • Answered

    captue frame error 0 Locked

    447 views
    6 replies
    Latest over 10 years ago
    by yue gu1
  • Answered

    EDMA test example 0 Locked

    295 views
    3 replies
    Latest over 10 years ago
    by Pubesh
  • Answered

    SGMII Transmit Configuration Register n (SGMII_SERDES_CFGTXn ) 0 Locked

    935 views
    5 replies
    Latest over 10 years ago
    by Pubesh
  • Answered

    choma encoding is not correct running omx encode example provided by DM8148 evm and the process can't quit 0 Locked

    613 views
    4 replies
    Latest over 10 years ago
    by Margarita Gashova
  • Answered

    DM8148 kernel crash: Unable to mount root fs via NFS... . PHY - Marvell Alaska 88E1512 0 Locked

    3150 views
    9 replies
    Latest over 10 years ago
    by kiran patil96658
  • Answered

    mcasp on am335x bclk sends 25MHz instead of 1.536MHz 0 Locked

    1012 views
    9 replies
    Latest over 10 years ago
    by Arend Lapere
  • Not Answered

    C6747 work from begin auto? 0 Locked

    588 views
    5 replies
    Latest over 10 years ago
    by Shankari G
  • Not Answered

    TI has 4K supported Soc within the Davinci Series 0 Locked

    246 views
    0 replies
    Started over 10 years ago
    by Hennessy
  • Not Answered

    how do i get values( about cc2541 button value)? 0 Locked

    298 views
    0 replies
    Started over 10 years ago
    by sunjoo lee
  • Answered

    DM8148 graphics usage 0 Locked

    516 views
    6 replies
    Latest over 10 years ago
    by nandish mj
  • Not Answered

    ISIF - Converting from 16-bit to 12-bit 0 Locked

    271 views
    2 replies
    Latest over 10 years ago
    by German Baranov
  • Not Answered

    RAM is not enough 0 Locked

    393 views
    4 replies
    Latest over 10 years ago
    by Pratap Reddy M V
  • Not Answered

    slice mode encoder issue 0 Locked

    1352 views
    11 replies
    Latest over 10 years ago
    by Jacson
<>