TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM62L / AM64x/ AM243x (ALV) / AM62Ax / AM62D-Q1 / AM62Px Design Recommendations / Commonly Observed Errors during Custom board hardware design – SDIO (embedded) interface

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM625 Other Parts Discussed in Thread: SK-AM62B-P1 , SYSCONFIG , CC3300 Tool/software: Hi TI Experts, Can you provide any available design guidelines for interfacing embedded SDIO device(s) using MMC1/MMC2 interface signals
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198152 Discussions
  • Answered

    Building example video_integration for dm6437 (CCS v5.1) 0 Locked

    570 views
    3 replies
    Latest over 12 years ago
    by Albert Zeman
  • Not Answered

    Why my custom DM8148 board booting stops? 0 Locked

    696 views
    3 replies
    Latest over 12 years ago
    by xu steven
  • Not Answered

    C55x - FAXLIB_2_0_1_2 convert project 0 Locked

    75 views
    0 replies
    Started over 12 years ago
    by HRi
  • Not Answered

    need help : installing SYSLINK-2_10_03_20 0 Locked

    168 views
    0 replies
    Started over 12 years ago
    by STALIN
  • Answered

    Adding new decoder to Codec server in dvsdk_3_10_00_16 0 Locked

    723 views
    7 replies
    Latest over 12 years ago
    by hua zhang2
  • Discussion

    Working with DSK6713 Locked

    203 views
    0 replies
    Started over 12 years ago
    by Mukhtar Hussain
  • Answered

    DSK C6713 Audio Codec 0 Locked

    3655 views
    12 replies
    Latest over 12 years ago
    by Mukhtar Hussain
  • Not Answered

    Non initialization for MSMCSRAM variables using 7.2 compiler version 0 Locked

    214 views
    2 replies
    Latest over 12 years ago
    by HRi
  • Not Answered

    smsc9118 driver transplanting problems. 0 Locked

    670 views
    5 replies
    Latest over 12 years ago
    by Renjith Thomas
  • Answered

    BeagleBone Capes 0 Locked

    449 views
    6 replies
    Latest over 12 years ago
    by Ameesh vv
  • Answered

    DM8127 IPNC_RDK 3.2 OSA_DMA copy performance 0 Locked

    1118 views
    9 replies
    Latest over 12 years ago
    by vincent kuo
  • Answered

    Problem on UART interrupt mode programming 0 Locked

    216 views
    2 replies
    Latest over 12 years ago
    by David Allen
  • Answered

    NTSC Camera Interface 0 Locked

    283 views
    2 replies
    Latest over 12 years ago
    by Egor Rumjantsev
  • Answered

    interface of RGB 24bit on OMAP4460 0 Locked

    412 views
    2 replies
    Latest over 12 years ago
    by Egor Rumjantsev
  • Not Answered

    Video is not smooth when DM365 run at 216M Hz 0 Locked

    268 views
    1 reply
    Latest over 12 years ago
    by Minglei Li
  • Not Answered

    PCIe link up problems in FPGA connecting to DSP 0 Locked

    3794 views
    9 replies
    Latest over 12 years ago
    by xing wang
  • Answered

    How to test U-boot for pandaboard ES 0 Locked

    659 views
    4 replies
    Latest over 12 years ago
    by madhav aarotale
  • Not Answered

    Setting up CMEM and DSPLINK modules 0 Locked

    903 views
    3 replies
    Latest over 12 years ago
    by chen liang
  • Answered

    RE: Migration issues from CCS v3.3(DSP/BIOS) to CCS v5.2(SYS/BIOS) 0 Locked

    189 views
    1 reply
    Latest over 12 years ago
    by Sasha Slijepcevic
  • Not Answered

    DDR3 Layout Rules and Required Layout Tools 0 Locked

    365 views
    0 replies
    Started over 12 years ago
    by Randy Maruschock
<>