TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] AM620-Q1: Connect SRAM to GPMC

    FM
    FM
    Part Number: AM620-Q1 Tool/software: Hi TI Team, I would like to avoid LPDDR4 memory because of cost. Is it possible to connect a standard 16-bit SRAM to the GPMC? Can you recommend any p/n? What is the maximum addressing size? Voltage…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] AM6421: How many reflow is acceptable at new package ANI?

    Tsurumoto
    Tsurumoto
    Part Number: AM6421 Tool/software: Hi To decide if customer use AM6421 for their new product or not, they need the information about how many reflow is acceptable at new package ANI. What's the limit number of reflow of AM6421BSEFHIANIR?
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] TLV62585: Input voltage vs Output voltage - AM64x AM62x Discrete power architecture

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: TLV62585 Tool/software: Hi Experts, I am reviewing a customer schematic. Customer is using TLV62585DRLR the input is 4.2V and could be switched to 3V. The output is 3.3V. Do you have any concern with the TLV62585DRLR providing…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] How to flash and boot Linux from NAND with AM335x Linux SDK 9.1

    Hong Guan64
    Hong Guan64
    Part Number: AM3358 Tool/software: AM335x GPMC-NAND boot issue was observed with AM335x Linux SDK 9.1 [1]. The FAQ lists the u-boot and kernel patches to support flashing and booting u-boot/kernel/root_fs with AM335x Linux SDK 9.1 from GPMC-NAND on…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] : Reset Module on AM64X / AM243/AM62X SOC's

    Swargam Anil
    Swargam Anil
    Part Number: AM6442 Tool/software: In AM64X/AM243/AM62X there are many Resets. So, what is the difference between each type of Reset? What is the boot flow for each Reset ? What are the Registers/Peripherals affected for each Reset ? How different…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] J784S4XEVM: How to create EXT4 rootfs on UFS and boot to Linux using UFS

    Keerthy J
    Keerthy J
    Part Number: J784S4XEVM Tool/software: UFS is present on the J784S4EVM. How can one use it instead of eMMC to host rootfs and use that to boot to Linux command prompt.
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] How to flash and boot u-boot from parallel GPMC NAND on AM64x

    Hong Guan64
    Hong Guan64
    Part Number: AM6442 Other Parts Discussed in Thread: TMDS64EVM Tool/software: AM64x boot ROM supports booting from parallel GPMC NAND. From "4.4.10 GPMC NAND Boot" in AM64x TRM "AM64x ROM only supports boot from ONFI 1.0 compatible 8 bit parallel…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] Using DDR IBIS Models for AM64x, AM243x (ALV), AM62x, AM62L, AM62Ax, AM62D-Q1, AM62Px

    JJD
    JJD
    Other Parts Discussed in Thread: SYSCONFIG The DDR Controller and PHY in Sitara processors is a flexible interface which can be used with LPDDR4 or DDR4. There are many settings available to fine-tune the signal timing on this interface. These settings…
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] PROCESSOR-SDK-AM62X: Question about AM625 / AM623 / AM620-Q1 / AM625-Q1 / AM625SIP DDR MARGIN TEST Tool

    Chunyen Wang
    Chunyen Wang
    Part Number: PROCESSOR-SDK-AM62X Other Parts Discussed in Thread: SK-AM62-LP , SK-AM62A-LP Tool/software: Hi I want to use the DDR Margin Test Tool on the AM62x-SK-EVM for testing, but I encountered an issue in the red step while following the readme…
    • over 1 year ago
    • Processors
    • Processors forum
  • [FAQ] PROCESSOR-SDK-AM64X: PCIE communication using AM64x/AM243x

    Mahantesh Mahantesh
    Mahantesh Mahantesh
    Part Number: PROCESSOR-SDK-AM64X Tool/software: Hi Team, I want to use two AM64x board for PCie communication. One EVM acts as root complex and other EVM acts as a Endpoint. I am using PE-FLEXI-G2-MMCX-12-TII. I want to verify memory read…
    • Answered
    • over 1 year ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 197927 Discussions
  • Not Answered

    Using GPIO for interrupt without using CSL 0 Locked

    500 views
    1 reply
    Latest over 13 years ago
    by Theodore Wolff
  • Not Answered

    Error in PCIE EDMA-Interrupt Example with MCSDK 2_0_7 0 Locked

    362 views
    1 reply
    Latest over 13 years ago
    by KTM
  • Not Answered

    Unable to boot U-boot over Ethernet(GMII) 0 Locked

    289 views
    2 replies
    Latest over 13 years ago
    by Julie Lambert
  • Not Answered

    sgmii 6457 0 Locked

    367 views
    1 reply
    Latest over 13 years ago
    by Bill Taboada
  • Answered

    core0 local reset behavior 0 Locked

    1268 views
    7 replies
    Latest over 13 years ago
    by Joel Keller
  • Not Answered

    mt9p031.c driver not detecting LI-5M02 camera sensor on DM365DVEVM. 0 Locked

    734 views
    2 replies
    Latest over 13 years ago
    by Vinod Sankar
  • Not Answered

    No interrupt on USB0 (OTG) when TXPKTRDY clears 0 Locked

    245 views
    0 replies
    Started over 13 years ago
    by Mark K
  • Answered

    Enabling Cache in ARM of OMAPL138 0 Locked

    479 views
    4 replies
    Latest over 13 years ago
    by Shino Samuel
  • Answered

    SYS/BIOS 6 TMS32028346 uart driver 0 Locked

    224 views
    2 replies
    Latest over 13 years ago
    by Andrew Barnes
  • Not Answered

    EDMA problem 0 Locked

    570 views
    8 replies
    Latest over 13 years ago
    by RandyP
  • Not Answered

    Mixing CSL IRQ module and vector.asm? 0 Locked

    337 views
    1 reply
    Latest over 13 years ago
    by MikeH
  • Not Answered

    abort() 0x8B84EFC0 (abort has only skeletal debug info) 0 Locked

    322 views
    0 replies
    Started over 13 years ago
    by Markus Grunwald
  • Answered

    The information of the Ethernet Throughput Performance for AM335x 0 Locked

    1676 views
    6 replies
    Latest over 13 years ago
    by Daisuke Maeda
  • Answered

    [Concerto F28M35H52C1] SYSBIOS IPC message buffer lost 0 Locked

    463 views
    1 reply
    Latest over 13 years ago
    by judahvang
  • Answered

    should HeapBufMP_create be in Thread ? why not in main() ? 0 Locked

    783 views
    10 replies
    Latest over 13 years ago
    by judahvang
  • Answered

    DSP idle loop overloading 0 Locked

    365 views
    1 reply
    Latest over 13 years ago
    by judahvang
  • Answered

    Where to find build files for "OpenCV on TI's DSP+ARM platform" white paper. (spry175.pdf) 0 Locked

    2463 views
    10 replies
    Latest over 13 years ago
    by Rahul Prabhu
  • Not Answered

    images jitter when cloning outputs 0 Locked

    367 views
    3 replies
    Latest over 13 years ago
    by Alexander Vasiljev
  • Answered

    I am getting this warning warning: creating output section ".bitVectors" without a SECTIONS 0 Locked

    1324 views
    1 reply
    Latest over 13 years ago
    by Sasha Slijepcevic
  • Answered

    UART Debugging [Concerto] 0 Locked

    1332 views
    5 replies
    Latest over 13 years ago
    by Philipp L.
<>