TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] AM625 / AM623 / AM620-Q1 / AM62L / AM64x/ AM243x (ALV) / AM62Ax / AM62D-Q1 / AM62Px Design Recommendations / Commonly Observed Errors during Custom board hardware design – SDIO (embedded) interface

    Kallikuppa Sreenivasa
    Kallikuppa Sreenivasa
    Part Number: AM625 Other Parts Discussed in Thread: SK-AM62B-P1 , SYSCONFIG , CC3300 Tool/software: Hi TI Experts, Can you provide any available design guidelines for interfacing embedded SDIO device(s) using MMC1/MMC2 interface signals
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198182 Discussions
  • Not Answered

    need information 0 Locked

    122 views
    1 reply
    Latest over 13 years ago
    by smitha pappu
  • Answered

    request for BSP_WINCE_OMAP35x 06_14_00 0 Locked

    161 views
    1 reply
    Latest over 13 years ago
    by Jatin Jain
  • Answered

    DM368 UART output 0 Locked

    678 views
    7 replies
    Latest over 13 years ago
    by bioz
  • Not Answered

    Graphic driver support on BeagleTouch with QT 0 Locked

    1256 views
    2 replies
    Latest over 13 years ago
    by Prabindh Sundareson
  • Not Answered

    OMAP3530 GPMC 0 Locked

    196 views
    0 replies
    Started over 13 years ago
    by Shihao Liu
  • Not Answered

    Enable SPI on a Beaglebone 0 Locked

    119 views
    0 replies
    Started over 13 years ago
    by 1978475
  • Answered

    IPC MessageQ_open Threading problems 0 Locked

    884 views
    1 reply
    Latest over 13 years ago
    by ToddMullanix
  • Not Answered

    6713DSK not connecting with CCS or diagnostics utility, USB driver problem 0 Locked

    209 views
    0 replies
    Started over 13 years ago
    by Jeeva
  • Not Answered

    c6678 how to fix 16 bit shift in memory 0 Locked

    190 views
    2 replies
    Latest over 13 years ago
    by Aviv
  • Answered

    About linker.cmd 0 Locked

    366 views
    3 replies
    Latest over 13 years ago
    by Chunjian Li
  • Answered

    some question on the UART of th DM648 0 Locked

    207 views
    2 replies
    Latest over 13 years ago
    by maoyang wu
  • Not Answered

    Image dumping in LCD 0 Locked

    217 views
    0 replies
    Started over 13 years ago
    by Muhammad Salih
  • Answered

    Replace 16-bit NAND to 8-bit NAND on DM816x EVM 0 Locked

    2312 views
    8 replies
    Latest over 13 years ago
    by Parth Saxena
  • Not Answered

    Kernel Panic not syn. unable to open an intial console.....trying passing option 0 Locked

    372 views
    1 reply
    Latest over 13 years ago
    by Mayank Saini
  • Not Answered

    how to change the h264 decoder levels when create the decoder? 0 Locked

    397 views
    1 reply
    Latest over 13 years ago
    by Brandy Jabkiewicz
  • Discussion

    DM8168 dvrmain applicatin build Error (QT Issue) Locked

    384 views
    0 replies
    Started over 13 years ago
    by mahesh kalmeshwar
  • Answered

    How can I understand every package/tools necesary to compile and load progrms in davinci evmDM6437? 0 Locked

    242 views
    2 replies
    Latest over 13 years ago
    by Pablo Varela
  • Answered

    RTSC destruct() and delete() 0 Locked

    572 views
    6 replies
    Latest over 13 years ago
    by npb17
  • Not Answered

    linux-devkit rebuild 0 Locked

    131 views
    0 replies
    Started over 13 years ago
    by Jan Pohanka
  • Not Answered

    Regarding V4l2 sample(saLoopback) modification 0 Locked

    446 views
    2 replies
    Latest over 13 years ago
    by Jongpil Won
<>