TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DRA821: SPL BOOT without A72 SPL on J7200 on 10.1 SDK

    Gokul Praveen
    Gokul Praveen
    Part Number: DRA821 Tool/software: How to enable Falcon Boot Mode on J7200? Boot Flow: R5 SPL -> ATF -> OPTEE -> U-BOOT -> Kernel Regards Gokul
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198273 Discussions
  • Not Answered

    How to Run menuconfig While Preserving Existing .config Options 0 Locked

    677 views
    1 reply
    Latest over 14 years ago
    by keerti patil
  • Not Answered

    osd character display blur in yuv format 0 Locked

    836 views
    4 replies
    Latest over 14 years ago
    by Wonder Won
  • Not Answered

    questions about boot AM1707 from NOR 0 Locked

    255 views
    1 reply
    Latest over 14 years ago
    by jc-ti
  • Not Answered

    How to compile the 672x CSL correctly 0 Locked

    214 views
    1 reply
    Latest over 14 years ago
    by Loc Truong
  • Not Answered

    My program works only for 10 iterations of a particular loop 0 Locked

    177 views
    1 reply
    Latest over 14 years ago
    by Loc Truong
  • Answered

    OMAP137 HPI boot problem 0 Locked

    3944 views
    31 replies
    Latest over 14 years ago
    by Gaston Schelotto
  • Not Answered

    Video streaming and time information 0 Locked

    118 views
    0 replies
    Started over 14 years ago
    by Josep Bernardo Clari
  • Answered

    QUESTION 0 Locked

    136 views
    1 reply
    Latest over 14 years ago
    by Hyun Kim
  • Answered

    Can't use fastrts64x.lib with CCSV4 and DSP/BIOS 5.40.02.22 0 Locked

    2489 views
    17 replies
    Latest over 14 years ago
    by Brad Griffis
  • Not Answered

    why encode /decode demos cannot run in background (DM355)? 0 Locked

    195 views
    0 replies
    Started over 14 years ago
    by YJ Liu
  • Not Answered

    Compiled Program from Linux DVSDK on Beagle Board xM with Angstrom Distribution 0 Locked

    226 views
    0 replies
    Started over 14 years ago
    by Mohit Hada
  • Not Answered

    Status of 1080p30 h 264 ENCODE on DM6467T-EVB 0 Locked

    393 views
    4 replies
    Latest over 14 years ago
    by Kapil Ahuja
  • Not Answered

    How to create ram file system (ramfs) for omap 0 Locked

    347 views
    1 reply
    Latest over 14 years ago
    by SriHarsha N.S
  • Not Answered

    Net-Snmp 0 Locked

    1266 views
    1 reply
    Latest over 14 years ago
    by Kirill Brilliantov
  • Not Answered

    Is there a way to offloading de-interlacing function in continuous mode? 0 Locked

    173 views
    0 replies
    Started over 14 years ago
    by Scotty Louis
  • Not Answered

    DM355_gadgetfs 0 Locked

    599 views
    6 replies
    Latest over 14 years ago
    by Mohammad Kapadia
  • Answered

    How can I branch to 0x00 in C language? 0 Locked

    237 views
    2 replies
    Latest over 14 years ago
    by SuYoung Choi
  • Not Answered

    EDMA3 error on dm6467 linux kernel (arago r37 vesion) 0 Locked

    340 views
    2 replies
    Latest over 14 years ago
    by ZhangZengbo
  • Answered

    ı want to see same results beetween "output of rifft " with "input of rfft "..??? 0 Locked

    365 views
    1 reply
    Latest over 14 years ago
    by selami tastan
  • Not Answered

    test of SRIO in TMS320C6474 DSP 0 Locked

    251 views
    4 replies
    Latest over 14 years ago
    by Alphan Karacaer56
<>