TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DRA821: SPL BOOT without A72 SPL on J7200 on 10.1 SDK

    Gokul Praveen
    Gokul Praveen
    Part Number: DRA821 Tool/software: How to enable Falcon Boot Mode on J7200? Boot Flow: R5 SPL -> ATF -> OPTEE -> U-BOOT -> Kernel Regards Gokul
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 1 month ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 197770 Discussions
  • Answered

    Control of XDCtools in multiple dvsdk environment 0 Locked

    479 views
    3 replies
    Latest over 15 years ago
    by jacek maitan
  • Answered

    Problem to get CCS 3.3 dsp-app running via dsplink on OMAP-L138 0 Locked

    583 views
    1 reply
    Latest over 15 years ago
    by Arnie Reynoso
  • Answered

    C6747EVM psp 01_30_00_06 audio example question about L2 cache 0 Locked

    686 views
    4 replies
    Latest over 15 years ago
    by Atmapuri
  • Suggested Answer

    MAR bits on EVM OMAP L137! 0 Locked

    674 views
    3 replies
    Latest over 15 years ago
    by TimHarron
  • Answered

    dm6467 network question 0 Locked

    821 views
    3 replies
    Latest over 15 years ago
    by Sid
  • Answered

    PowerVR SDK and DDK on OMAP35x and VBO using 0 Locked

    599 views
    1 reply
    Latest over 15 years ago
    by Atul Verma
  • Not Answered

    How many hubs (in depth) will USB0 on the L137 support? 0 Locked

    388 views
    5 replies
    Latest over 15 years ago
    by james whitsett
  • Not Answered

    Qt on OMAP3530 Zoom 0 Locked

    1081 views
    13 replies
    Latest over 15 years ago
    by Pranam Shetty
  • Answered

    Is there CSL for OMAPL137? 0 Locked

    612 views
    2 replies
    Latest over 15 years ago
    by hua chen47326
  • Answered

    6748 Configuration and Power Consumption 0 Locked

    1081 views
    4 replies
    Latest over 15 years ago
    by clam
  • Answered

    Porting "ST #immediate, Smem" from C54x to C55x 0 Locked

    438 views
    1 reply
    Latest over 15 years ago
    by Archaeologist
  • Not Answered

    Flashing Custom Design DM6446 0 Locked

    689 views
    5 replies
    Latest over 15 years ago
    by Ferhat OLGUN
  • Not Answered

    OMAP-L137:problems with booting spiflash 0 Locked

    480 views
    4 replies
    Latest over 15 years ago
    by tlee
  • Not Answered

    5509A USB interrupt endpoint NAK notification 0 Locked

    389 views
    0 replies
    Started over 15 years ago
    by Kavanagh
  • Not Answered

    DM365: i2c setup 0 Locked

    683 views
    6 replies
    Latest over 15 years ago
    by Brad Griffis
  • Not Answered

    RTC interrupt 0 Locked

    285 views
    3 replies
    Latest over 15 years ago
    by Michael Rietz
  • Not Answered

    [6454] Irregular Power Sequence Question 0 Locked

    224 views
    0 replies
    Started over 15 years ago
    by TimHarron
  • Answered

    reusing PSP audio example - does not link 0 Locked

    703 views
    9 replies
    Latest over 15 years ago
    by Mariana
  • Not Answered

    Which gpio could be set as interrupt source on dm365? 0 Locked

    1526 views
    10 replies
    Latest over 15 years ago
    by raghunath rangaswamy
  • Answered

    RTSC configuration problem 0 Locked

    1108 views
    5 replies
    Latest over 15 years ago
    by AmitMookerjee
<>