TI E2E support forums
TI E2E support forums
  • User
  • Site
  • Search
  • User
  • E2E™ design support >
  • Forums
    • Amplifiers
    • API solutions
    • Audio
    • Clock & timing
    • Data converters
    • DLP® products
    • Interface
    • Isolation
    • Logic
    • Microcontrollers
    • Motor drivers
    • Power management
    • Processors
    • RF & microwave
    • Sensors
    • Site support
    • Switches & multiplexers
    • Tools
    • Wireless connectivity
    • Archived forums
    • Archived groups
  • Technical articles
  • TI training
    • Tech days
    • Online training
    • Live events
    • Power Supply Design Seminar
  • Getting started
  • 简体中文
  • More
  • Cancel
Processors

Processors

Processors forum

  • Mentions
  • Tags
  • More
  • Cancel
  • Ask a new question
  • Ask a new question
  • Cancel
Texas Instruments (TI) Processors support forum is an extensive online knowledge base where millions of technical questions and solutions are available 24/7. You can search processors content or ask technical support questions on Sitara™ processors, digital signal processors (DSP) and automotive processors. Find the right solution for your circuit design challenges by using our TI E2E™ support forums that are supported by thousands of contributing TI experts.
Frequent questions
  • [FAQ] DRA821: SPL BOOT without A72 SPL on J7200 on 10.1 SDK

    Gokul Praveen
    Gokul Praveen
    Part Number: DRA821 Tool/software: How to enable Falcon Boot Mode on J7200? Boot Flow: R5 SPL -> ATF -> OPTEE -> U-BOOT -> Kernel Regards Gokul
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] How to avoid crashing the DM R5F when writing custom DM R5F firmware

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, on some devices (not all devices!), TI supports writing custom code to run on the DM R5F, alongside the…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] SBL boot: How to find the DM R5F firmware that is loaded by SBL

    Nick Saulnier
    Nick Saulnier
    Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the DM R5F, alongside the DM task. The firmware running on the…
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] TDA4AL-Q1: Large byte transfer

    Tarun Mukesh Puvvada
    Tarun Mukesh Puvvada
    Part Number: TDA4AL-Q1 Tool/software: Example application on SDK 10.0 to show large byte transfer between CDD IPC(MCU1_0) and Linux (A72) using cdd_ipc_rc_linux ,rpsmg_char_simple applications on J721S2 ?
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] How to check if Linux can communicate with a non-Linux core through RPMsg

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Before Linux can communicate with a non-Linux core over the RPMsg inter-processor communication (IPC) protocol, several things needs to be true: 1) RPMsg between Linux and the non-Linux core must be supported…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] Linux: How to check what binary is running on the DM R5F

    Nick Saulnier
    Nick Saulnier
    Other Parts Discussed in Thread: AM67 , AM67A Parts Discussed in Thread: AM62x, AM62Ax, AM62Dx, AM62Px, AM67, AM67A The primary role of the Device Management (DM) R5F core is to run the DM task. However, there may be other non-DM code running on the…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] TDA4VM-Q1: How to enable cross domain UART access from PDK applications.

    Doredla Sudheer Kumar
    Doredla Sudheer Kumar
    Part Number: TDA4VM-Q1 Tool/software: On custom boards where UART instances are limited, how can I route debug output from my application running in one domain to a UART instance available in different domain? Specially, I want to enable cross-domain…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] EDGE-AI-STUDIO: TIDL RTOS tool vs edgeai-tidl-tools

    Adam Hua
    Adam Hua
    Part Number: EDGE-AI-STUDIO Tool/software: Model importing in TI has two sets of tools due to historical reasons. These two sets has developed in parallel for a long time. Here is an explanation of the similarity and difference of the two tools. …
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] What is Active Slot bitmask, Data Bitmask, and Transaction Count in MCASP?

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM62D-EVM AUDIO-AM275-EVM Other Parts Discussed in Thread: SYSCONFIG Tool/software: 1. While configuring McASP through sysConfig, I found that when the num of slots set as 2, the active slot bitmask can only below 3. What is this…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
  • [FAQ] Not able to return from infinity loop in C7 core by changing the loop variable using CCS

    Ritapravo Sarker
    Ritapravo Sarker
    Part Number: AUDIO-AM275-EVM Tool/software: I am not able to return from infinity loop in C7x core by changing the loop variable from the Variables tab in CCS. In the following code - void loop_forever() { volatile uint32_t loop = 1U; while(loop…
    • Answered
    • 2 months ago
    • Processors
    • Processors forum
<>

View FAQ threads
  • Tags
  • RSS
  • More
  • Cancel
  • Threads 198356 Discussions
  • Not Answered

    Problems outputting NTSC digital video on DM355 0 Locked

    903 views
    14 replies
    Latest over 15 years ago
    by R&D10371
  • Answered

    C6747 GPIO interrupts - GPIO doesnt raise an event 0 Locked

    580 views
    3 replies
    Latest over 15 years ago
    by Brad Griffis
  • Not Answered

    Problem with converting .out to .bin (hex470.exe) 0 Locked

    1096 views
    7 replies
    Latest over 15 years ago
    by Jack16236
  • Not Answered

    Building Codec sample code of Linux on Windows CCS ver3.3 0 Locked

    392 views
    3 replies
    Latest over 15 years ago
    by Cholnam Kim
  • Not Answered

    When does *fft_noscale() work? 0 Locked

    200 views
    1 reply
    Latest over 15 years ago
    by Brian Willoughby
  • Not Answered

    QSPI 0 Locked

    775 views
    6 replies
    Latest over 15 years ago
    by Brian Willoughby
  • Discussion

    DSPLink hangs: solutions Locked

    233 views
    0 replies
    Started over 15 years ago
    by Flamingo
  • Not Answered

    OMAP-L137 Production time line 0 Locked

    241 views
    2 replies
    Latest over 15 years ago
    by tony15380
  • Not Answered

    USB Controller FIFO on DM365 0 Locked

    236 views
    2 replies
    Latest over 15 years ago
    by Alexander Khvilivitzky
  • Suggested Answer

    DM6467 boot + kernel start time 0 Locked

    180 views
    1 reply
    Latest over 15 years ago
    by Bernie Thompson TI
  • Suggested Answer

    Module number of VPSS DAC in PSC of DM355 0 Locked

    324 views
    3 replies
    Latest over 15 years ago
    by Juan Gonzales
  • Answered

    Migration from OMAP3430 to OMAP3530 0 Locked

    1117 views
    10 replies
    Latest over 15 years ago
    by Soren Steen Christensen
  • Not Answered

    Programming Frame buffer address in DM355 0 Locked

    212 views
    1 reply
    Latest over 15 years ago
    by Juan Gonzales
  • Not Answered

    Getting css file for using EVMDM365 and XDS560 0 Locked

    225 views
    2 replies
    Latest over 15 years ago
    by Cholnam Kim
  • Answered

    OMAP3530 CUS Package Boot Issue 0 Locked

    349 views
    7 replies
    Latest over 15 years ago
    by Brad Griffis
  • Suggested Answer

    OMAP-L138 uPP DMA 0 Locked

    622 views
    1 reply
    Latest over 15 years ago
    by Brad Griffis
  • Not Answered

    c5502 timer to measure period 0 Locked

    456 views
    1 reply
    Latest over 15 years ago
    by Mark M
  • Answered

    DM355-270Mhz changing PLL in ublDM355 0 Locked

    1076 views
    12 replies
    Latest over 15 years ago
    by Juan Gonzales
  • Not Answered

    5MP camera output on leopardboard 0 Locked

    412 views
    0 replies
    Started over 15 years ago
    by Tim Liebau
  • Suggested Answer

    Using XDS100 JTAG Emulator for C5505 processor 0 Locked

    245 views
    1 reply
    Latest over 15 years ago
    by Mariana
<>