• State
  • Locked Locked
  • Replies 2 replies
  • Subscribers 30 subscribers
  • Views 806 views
  • Users 0 members are here
Support feedback
Options
Options
Similar topics

This thread has been locked.

If you have a related question, please click the "Ask a related question" button in the top right corner. The newly created question will be automatically linked to this question.

Original question:

DCA1000EVM: Can't see the Radar API when I start mmWave studio

DCA1000EVM: Radar devices not selected

Akash Deep Singh
Intellectual 555 points
Part Number: DCA1000EVM

Hi,

This is in relation to this post: 

DCA1000EVM: Can't see the Radar API when I start mmWave studio - Sensors forum - Sensors - TI E2E support...

e2e.ti.com
Part Number: DCA1000EVM Other Parts Discussed in Thread: IWR1642BOOST Hi, I have a DCA1000 EVM connected to a IWR1642BOOST module as shown in https://training

I am not able to get anything out of my DCA1000 board. I have followed and installed everything as shown in the tutorial, but to no avail. 

  1. When I click "Set", I get the error: Radar Devices not selected.
  2. When I click "Connect', I get even more errors. I have attached my output log. Please help.

  • 0
    TI__Mastermind 25825 points
    Hello,

    By looking at the log file it appears that RS232 port is not getting connected to mmWave studio.
    Without the right com port selection RX232 ports will not connect. Could you please post Device manager's virtual com ports?
    And device need to be booted in SOP2 mode and NRSET need to be pressed before mmWave studio connection.
    Also could you please post the picture of the EVM setup?

    Thanks and regards,
    CHETHAN KUMAR Y.B.
  • 0 in reply to CHETHAN KUMAR Y.B.
    TI__Mastermind 25825 points
    Hello,

    Closing this thread as there is similar post is raised.

    Thanks and regards,
    CHETHANK UMAR Y.B.