Thank you very much !
In my case, I've a single ended audio input, that's why I adhered to what reported in the INA1651 datasheet, i.e.: IN -A connected to OUT B, and IN -B connected to OUT A.
Plus, as you say, I utilized the INA1651 internal 1/2…
Thomas,
The ref clk complies with the electrical parameters specified in PCI Express® Base Specification Revision 4.0. If the ref clk is used as an input, table 6-2 is in addition to the specs.
Hi Akshay,
Akshay Rathod said: Which XO or OCXO is used to get these results?
On EVAL board, it is TCXO 48.0048 MHz. The phase noise that we documented is often taken with XO being the signal generator SMA100B to show LMK05318B phase noise only. With…
1) There is Erratum SPI_ERR_04 [Ref Errata (SLAZ742F) p. 20], though that claims it only applies in peripheral "receive only" mode [whatever that is -- POD=1 maybe?]. One wonders what happens between bytes with an empty TX FIFO. That said: I'm trying…
Hey Gerasimos,
1) OK.
2) My comments above were in general, so I remeasured these just now: REF=1.410V, SENSE=1.572V, diff then is 0.162V, OUT=2.901V. Isn't the output biased up to Vs/2 = +5.0/2 = +2.5V in this case? Section 7.6 of the datasheet implies…
Part Number: ADS124S08 Tool/software: Hi,
I have a few questions that I am not clear about
1. I am trying to implement the universal RTD measurement circuit using the ADS124S08 as shown below
I was wondering if I need to add a common mode filter…
Hi David,
david krzmarcik said: 1. Is the TPS25983 indeed UL recognized, and what the UL file number? Is it the E339631 with the TPS25982 and TPS25980, but perhaps in a separate file. Or if it so new perhaps the database just hasn’t been updated yet…
Dear Anandhu,
Yes sorry I meant to ask for " oe-layertool-setup.sh ". You provided me with the info I needed.
In terms of TFA_INSTALL_TARGET , target selection between layers (and in general any interactions between 2 layers) is organized by a combination…
