Part Number: DAC7513 Tool/software: Hi
When calculating the Total Unadjusted Error (TUE) for a DAC is the same method as used for an ADC i.e. the same as described in 'ADC Performance Parameters - Convert the Units Correctly!' (Application Report…
Part Number: DAC7513 Other Parts Discussed in Thread: DAC80504 , DAC80501 , DAC7573 , DAC121C085 Hi~
I'm looking for DAC solution similar to LTC2629 and I found TI's DAC7513 has similar features which could fit my design.
However, I don't need SYNC…
Part Number: DAC7513 Dear TI team.
Thank you for your support.
This is Takashi from Digi-Key.
I have recently ask question by customer about chemSHERPA certification (SHAI file).
Customer requested for
DAC7513N/3K
I don't think it available…
Other Parts Discussed in Thread: DAC7513 We are considering using two DAC7513 digital-to-analog converters on the same SPI bus. However, I noticed that this part does not have a CS pin. Does this mean that two of these parts can not share the same SPI…
Other Parts Discussed in Thread: DAC7513 Hi,
I am using the DAC7513 and some chips give a lower Vout than expected.
For example:
When I write FFF to the shift register I don't get the expected Vref at output .
For Vref = 293mV:
I get:
Vout…
Hi,
Tiva series does not have on-chip DAC. You must externally add such device, example DAC7513, 12 bits, SPI interface. However, you should specify/search for appropriate device for your project.
Hi,
We are planning on using the CC430F6137 Reference Voltage (pins 59/60) as a reference for a DAC7513 digital to analog converter. Specifically, we're planning on connecting pin 59 (VREF+) on the CC430 to pin 3 (VREF) on the DAC7513 . Could you please…
Other Parts Discussed in Thread: DAC7513 , TLV5614 , TLV5638 Hi,
I have a C6713 DSP Starter kit and I need to implement the use of a DAC for arbitrary waveform generation. My center frequency will be around 1MHz with a BW of 40kHz and I would like to…
Hello Yuyama-san,
The data sheet will post to ti.com within the next 3 months, but I am attaching it to this post for now for reference. The fundamental change is that we do not support any operation below 0 C ambient temperature with OPA561.
Regards…
