Part Number: INA223 Other Parts Discussed in Thread: TPS62130A , As mentioned in the other thread, I was aiming to use the INA223 to adjust the TPS62130A output voltage so that a constant power is delivered to a load resistance. I believe I have achieved…
Part Number: INA223 Other Parts Discussed in Thread: TPS62130A , , LMP8646 I'm looking into a concept that will provide a load resistor with constant power. My current approach is to use the TPS62130A to provide power to the load and the INA223 in load…
Part Number: INA223 Other Parts Discussed in Thread: INA228 Hi all,
I need 3 information regarding INA223 IC.
1. what is the sampling data rate of this INA223 IC?
Does it give measured current details continuously or with some intervals.
2.What is…
Part Number: INA223 Other Parts Discussed in Thread: INA228 , , INA228-Q1 HI Team,
Can you please help with the below query from our customer:
In I2C for memory devices, if from the master, ack and clock continue after reading one location of memory,…
Part Number: PSPICE-FOR-TI Other Parts Discussed in Thread: INA223 , TINA-TI Is it possible to generate a part in PSpice for TI using a TINA-TI Spice model? I'm using the INA223 model provided and trying to generate a part from it, but run into issues.…
Part Number: INA223 Tool/software: TI-RTOS Hi Sir
I have a question about INA223 Equation2(page16) is correct or not as below.
Because I saw Power Modes description (page17) are conflict with Equation2
Maybe correct equation2 is POWERgain=VOUT/(POWER…
Part Number: INA223 Hi Sirs,
Would you please advise that if we have high voltage option (>=30V) of the INA223 (analog output and I2C control) in pipeline? Thank you and Best regards, Wayne Chen 01/29/2019
Part Number: INA223 Other Parts Discussed in Thread: INA233 Tool/software: TI-RTOS Hi Sir
I have a question about "Vout range at INA223 and total current shunt monitor solutions"
The Vout range meet Supply Voltage is OK, is it right?
Thanks…
Part Number: INA223 Hello,
For a project I want to use the INA223 in combination with an ADC to measure both the voltage and current of my load. For this I want to use the internal mux to switch at about 20khz between the "bus voltage measurement" and…
Hi Sreenivasa,
Thanks for getting back to me. The single supply requirement is not that critical, but it would help simplify the design a bit.
The main goal is to create a constant power (heater) circuit that also has a temperature sensing capability…