Because of the Thanksgiving holiday in the U.S., TI E2E™ design support forum responses may be delayed from November 25 through December 2. Thank you for your patience.
Part Number: MSP430I2040 Tool/software: I am using the EMDC software to generate code for i2041. The configuration has one voltage channel and one current channel with CT.
Unfortunately, we could not get the HID to work with 5529LP. The green LED never…
Part Number: MSP430FR6047 Other Parts Discussed in Thread: TIDM-1019 Do we know what the breakdown is regarding how much flash the metrology code consumes in the standard EVM design?
Part Number: MSP430I2041 Other Parts Discussed in Thread: TIDM-TWOPHASEMETER-I2040 , TIDM-SERVER-PWR-MON Support,
I'm using the TIDM-SERVER-PWRMON kit and SW.
1. Verify that readings are updated every 4 AC cycles? Where in the code is this set? Can…
Part Number: TIDM-TMS570BMS
I made the changes as per your suggestions, but how do I check that my NHET is working properly. Also , Even now when I connect the TMS570 to the host PC, the BQ76PL455a GUI still shows "the COMP port cannot open". Please guide…
Hi Paul,
Paul Reshetikhin said: Would it be possible to also use the TMS320F28P559SJ in conjunction with another TI processor to leverage the Instaspin-Motion motion profiling? If so can you offer a recommended solution for this?
InstaSPIN Motion can only…
Rana,
1. F28377S has 2 Flash banks, so OTA is possible. Strictly speaking, AUTOSAR FOTA on this device will require 3 Flash banks.
2. You have to set it up properly during production, and make it OTA ready.
3. You can start by referring to spracn0 (section…
Hi
So far, I can't find the direct information on metrology formulas
Three-Phase Metrology With Enhanced ESD Protection and Tamper Detection Reference Design (TIDM-3PHMTR-TAMP-ESD) should be the reference.
The previous E2E thread discussion is the reference…
Part Number: TIDM-2PHASE-SUBMTR-FW2 Other Parts Discussed in Thread: MSP-ISO
The Two Phase Embedded Metering Firmware Upgrade reference design shows the communication of multiple devices performed over I2C and finally connected to host using a I2C to RS232…
Hi Dan,
Daniel Nanto said: Are the hardware design files still archived/hosted? I might design a quick dev-board for the chips and have them fabricated for evaluation.
You can find the user's guide at https://www.ti.com/lit/pdf/spmu360 which has the…
Part Number: LAUNCHXL-F28P65X Other Parts Discussed in Thread: SYSCONFIG , TIDM-02011 Tool/software: Hi TI experts,
I am currently working on firmware updates through CAN for 65x board and i have a few doubts about the boot modes and LFU.
I went through…
