Frequent Questions

  • [FAQ] UCC5881-Q1: Upgrading UCC5880-Q1 to UCC5881-Q1 - Key Considerations?

    Part Number: UCC5881-Q1 Other Parts Discussed in Thread: UCC5880-Q1 , If you're planning to upgrade your design from UCC5880-Q1 to UCC5881-Q1, there are several key factors to consider. It’s easy to upgrade since both devices have pin-to-pin compatibility…

  • [FAQ] UCC5881-Q1: What are the new features in UCC5881-Q1?

    Part Number: UCC5881-Q1 Other Parts Discussed in Thread: UCC5880-Q1 , UCC5881-Q1 is TI’s latest programmable isolated gate driver, offering pin-to-pin compatibility with the exact same package and pinout as UCC5880-Q1. This enables designers to keep…

  • [FAQ] AM2612: "No Module Named Construct" on clean install / build of SDK example

    Part Number: AM2612 Hi ASM team, I get the following error after trying to build a simple GPIO toggle program on a clean install of the 10_02_00_15 SDK. Have we seen this before? All the best, Ethan Cope

  • [FAQ] AM2754-Q1: [FAQ] Mcasp signal placement order in buffer for multiple serializers and multiple channels/slots

    Part Number: AM2754-Q1 Other Parts Discussed in Thread: SYSCONFIG , TAD5212 Mcasp buffer order To be short, in case of multiple serializers used in one Mcasp, the samples are placed interleaved by slot not frame by default. (Please check the "12.1…

  • [FAQ] J722SXH01EVM: How do I use the Fusion2 board with the J722SXH01EVM

    Part Number: J722SXH01EVM Tool/software: How do I use the Fusion2 board with the J722SXH01EVM ? When I try to run the single camera demo, I see the following error: [MCU2_0] 76.844004 s: Error writing 0x01 to de-serializer(0x3d) register 0x4c…

  • [FAQ] TDA4VH: TIMER in Capture Mode.

    Part Number: TDA4VH Tool/software: How to enable TIMER in Capture mode in Linux ?

  • [FAQ] MSPM33C321A: Recover device by Factory Reset

    Part Number: MSPM33C321A Tool/software: When MSPM33 enter a state where CCS is unable to connect to M33 core, follow the below procedure to implement Factory Reset. CCS version >= CCS v 20.4.0.5 Step 1 - Launch project less debug Step 2 -…

  • [FAQ] TDA4VH-Q1: How to create openvx graph with a node that needs data from the next node

    Part Number: TDA4VH-Q1 Tool/software:

  • [FAQ] TXE8124-Q1: VOH/IOH/VOL/IOL and Total ICC Current Definitions

    Part Number: TXE8124-Q1 Other Parts Discussed in Thread: TXE8148 , TXE8116 , TXE8124 Tool/software: FAQ: Logic and Voltage Translation > SPI I/O Expanders >> Current FAQ This FAQ describes 6 key spec's for I/O expanders. These specs include: …

  • [FAQ] TDA4VM: What parameters in the VPU driver are used for setting I-frame and IDR key-frame period?

    Part Number: TDA4VM Tool/software: I'm using the TDA4VM Linux or Linux+RTOS 8.6 SDK. What parameters or patches are available to be enable I-frame period and IDR frame period?

View FAQ threads
Recommended For You