Frequent Questions

  • [FAQ] SK-AM64B: MCSPI Integration Guide

    Part Number: SK-AM64B Other Parts Discussed in Thread: SYSCONFIG Tool/software: On Sitara Family of Processors, there are multiple instances of MCSPI present. Some of the MCSPI instances are available in the MAIN Domain[example: SoC_SPI0] while…

  • [FAQ] MCU-PLUS-SDK-AM243X: How to use ICSSG0 Ethernet on AM64x/AM243x

    Part Number: MCU-PLUS-SDK-AM243X Other Parts Discussed in Thread: DP83869 Tool/software: Hi, Can you help me with how to enable PRU Ethernet on the ICSSG0 instance on AM64x/AM243x? Regards Ashwani

  • [FAQ] MCU-PLUS-SDK-AM243X: PCIe boot on AM64x/AM24x

    Part Number: MCU-PLUS-SDK-AM243X Tool/software: Hi, How to enable PCIe boot on AM64x/AM24x? Regards Ashwani

  • [FAQ] DS250DF230: CTLE Boost Table

    Part Number: DS250DF230 Other Parts Discussed in Thread: DS250DF210 , DS250DF410 , DS250DF810 , , DS280DF810 Tool/software: Across all 25-28G retimers (DS250DF210, DS250DF230, DS250DF410, DS250DF810, DS280DF810) there are 255 total CTLE boost settings…

  • [FAQ] DS320PR1601: Do TI PCIe redrivers support bifurcation?

    Part Number: DS320PR1601 Tool/software: Do TI PCIe redrivers support bifurcation?

  • [FAQ] C2000WARE: How to configure CMPSS and EPWM for EDGE trigger instead of LEVEL trigger

    Part Number: C2000WARE Tool/software: Situation example: The CMPSS's compared voltage is set as 1.5V from internal DAC / external signal, once the sensed voltage on positive pin is higher than negative pin 1.5V, then trigger ONCE interrupt. Then…

  • [FAQ] ADS1298R: How are the lead-off comparator thresholds set?

    Tool/software: In the ADS129x family, a 4-bit DAC is used to set the lead-off detection threshold for the positive and negative channels inputs. The DAC settings are configured writing to COMP_TH[2:0] in the LOFF control register. The threshold voltages…

  • [FAQ] TPS628502: AM625 / AM623 Power Architecture using TPS6285020MQDRLRQ1 - Fixed 1.8V output

    Part Number: TPS628502 Tool/software: Hi Experts, My customer is using TPS6285020MQDRLRQ1 to generate 1.8V fixed output from 3.3V input. Help me understand how to connect the feedback - should this be left open. Customer has connected the output…

  • [FAQ] J721S2XSOMXEVM: How to flash Keywriter image over JTAG ?

    Part Number: J721S2XSOMXEVM Tool/software: How to flash Keywriter image over JTAG ?

  • [FAQ] TUSB1002A: [FAQ] Purpose of the 330nF capacitors for the USB connector to the SuperSpeed RX and is it required?

    Part Number: TUSB1002A Tool/software: What is the purpose of the 330nF capacitors on the SuperSpeed RX and is it required?

View FAQ threads
Recommended For You